日本語 dropdown-ico

Kenwood KDC-132の取扱説明書

22ページ 0.84 mb
ダウンロード

ページに移動 of 22

Summary
  • Kenwood KDC-132 - page 1

    KDC-132 KDC-1032 KDC-132CR CD-RECEIVER INSTR UCTION MANU AL © B64-3239-00/00 (KW/KN) T ake the time to r ead through this instruction manual. F amiliarity with installation and operation procedur es will help you obtain the best performance from your new CD-receiv er . For y our records Record the serial number , found on the back of the unit, in ...

  • Kenwood KDC-132 - page 2

    2 | English Con tents W arning 3 Safety precautions 4 Notes 5 About CDs 6 General featur es 7 Pow er Selecting the Source Volume Attenuator System Q Audio Control Audio Setup Speaker Setting Clock Display Adjusting Clock Theft Deterrent F aceplate T uner fea tures 11 T uning T uning Mode Station Pr eset Memor y Auto Memory Entr y Pr eset Tuning CRS ...

  • Kenwood KDC-132 - page 3

    English | 3 2 W arning 2 CAUTION Use of controls or adjustments or performance of procedures other than those specified her ein may result in hazardous radiation exposur e. In compliance with Federal Regulations, f ollowing are repr oductions of labels on, or inside the product relating to laser product saf ety. KENWOOD CORPORA TION 2967-3, ISHIKA ...

  • Kenwood KDC-132 - page 4

    4 | English Safety precautions Lens F ogging When you turn on the car heater in cold weather , dew or condensation may form on the lens in the CD player of the unit. Called lens fogg ing, this condesnation on the lens may not allow CDs to play . In such a situation, remove the disc and wait for the condensation to evaporate . If the unit still does ...

  • Kenwood KDC-132 - page 5

    English | 5 • If you experience problems during installation, consult your Kenwood dealer . • If the unit fails to operate properly , press the Reset button. The unit returns to factory settings when the Reset button is pressed. • Characters in the L CD may become difficult to read in temperatures below 5 ˚C (41 ˚F). • The illustrations o ...

  • Kenwood KDC-132 - page 6

    6 | English Handling CDs • Do not touch the recor ding sur face of the CD. • CD-R and CD-R W are easier to damage than a normal music CD. Use a CD-R or a CD-R W after reading the caution items on the package etc. • Do not stick tape etc. on the CD , or use a CD with tape stuck on it. When using a new CD If the CD center hole or outside rim ha ...

  • Kenwood KDC-132 - page 7

    English | 7 General fea tures Powe r T urning ON the Power Press the [SRC] button. T urning OFF the Power Press the [SRC] button for at least 1 sec ond. Selecting the S ource Press the [SRC] button. Source required Display T uner "TUnE" CD "CD" Standby (Illumination only mode) "STBY" V olume Increasing V olume T urn th ...

  • Kenwood KDC-132 - page 8

    8 | English General fea tures Sy stem Q Selecting the best sound setting preset for different types of music. 1 Select the source to set Press the [SRC] button. 2 Select the Sound type Press the [ Q] button. When you press the button once , the current sound setting is displayed. Each time you press the button, the sound setting alternates. Sound s ...

  • Kenwood KDC-132 - page 9

    English | 9 Speaker Setting Fine-tuning so that the System Q value is optimal when setting the speaker type. 1 Enter Standby Press the [SRC] button. Select the "STBY" display. 2 Enter Speaker Setting mode Press the [VOL] knob. 3 Select the Speaker type T urn the [ VOL] knob. Each time you turn the knob, the setting alternates between the ...

  • Kenwood KDC-132 - page 10

    10 | English General fea tures Theft Deterrent F aceplate The faceplate of the unit can be detached and taken with you, helping to deter theft. Removing the F aceplate Press the Release button. The faceplate unlocks, allowing you to detach it. • The faceplate is a precision piece of equipment and can be damaged by shocks or jolts. • Keep the fa ...

  • Kenwood KDC-132 - page 11

    English | 11 T uner featur es T uning Selecting the station. 1 Select tuner source Press the [SRC] button. Select the " TUnE" display . 2 Select the band Push the Contr ol knob towards [FM] or [ AM]. Each time you push the knob toward [FM], it switches between the FM1, F M2, and FM3 bands. 3 T une up or down band Push the Contr ol knob to ...

  • Kenwood KDC-132 - page 12

    12 | English T uner featur es Station Pr eset Memor y Putting a station in the memory. 1 Select the band Push the Contr ol knob towards [FM] or [ AM]. 2 Select the frequency to put in the memor y Push the Contr ol knob towards [ 4 ] or [ ¢ ]. 3 Put the frequency in the memory Press the desired [1] — [6] butt on for at least 2 seconds. The preset ...

  • Kenwood KDC-132 - page 13

    English | 13 CD play er featur es Playing CD When a disc is inserted Press the [SRC] button. Select the "CD" display. • When a CD is inserted, the "IN" indicator is ON. Pause and play Press the C ontrol knob. Each time you press the knob, the audio pauses or plays. Eject the CD Press the [ 0 ] button. F ast Forwarding and Re v ...

  • Kenwood KDC-132 - page 14

    14 | English CD play er featur es T rack Search Selecting the song you want to hear . Push the Contr ol knob towards [ 4 ] or [ ¢ ]. T rack Repeat Replaying the song you are list ening to. Press the [REP] button. Each time you press the button, the Track Repeat turns ON or OFF . When the T rack Repeat is ON, the "REP" indicator is ON. Sc ...

  • Kenwood KDC-132 - page 15

    English | 15 Ac cessories/ Installation P rocedure Ac cessories 1 ..........1 2 ..........2 3 ..........4 4 ..........4 5 ..........1 Installation Proc edure 1. T o prevent a short circuit, remove the key from the ignition and disconnect the - battery. 2. Mak e the proper input and output wire connections for each unit. 3. Connect the speaker wires ...

  • Kenwood KDC-132 - page 16

    16 | English ANT . CONT MUTE P .CONT FRONT • L FRONT • R REAR • L REAR • R – + FRONT Connecting W ires to T erminals FM/AM antenna input Fr ont left output ( White) (KDC-1032 only) Fr ont right output (Red) (KDC-1032 only) F use (10A) Wiring harness (Accessory 1 ) White/Black Gray/Black Green/Black Purple/Black White Gray Green Purple T o ...

  • Kenwood KDC-132 - page 17

    English | 17 Installation • Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (for example, the sound may skip). non-Japanese cars Japanese cars 1 Ref er to the section <Removing the hard rubber frame> (page 19) and then remove the hard rubber frame. 2 Align the holes in the unit (two locati ...

  • Kenwood KDC-132 - page 18

    18 | English Installation Screwing the F aceplate on the Unit If you want to fasten the faceplate to the main unit so that it does not fall off , screw in the provided screw s in the holes shown below . Accessory 5 • Never insert the screw in any other screw hole than the one specified. If you screw them in another hole, it will contact and may c ...

  • Kenwood KDC-132 - page 19

    English | 19 Removing the Unit Removing the hard rubber fr ame 1 Engage the catch pins on the r emoval tool and remove the two locks on the upper level . Upper the frame and pull it forward as shown in the figure. 2 When the upper level is r emoved, remove the lower two locations. • The frame can be removed from the bottom side in the same manner ...

  • Kenwood KDC-132 - page 20

    20 | English T roubleshooting Guide What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Befor e calling ser vice, first check the following table f or possible problems. General ? The pow er does not turn ON. ✔ The fuse has blo wn. ☞ After checking for shor t circuits in the wires, replac ...

  • Kenwood KDC-132 - page 21

    English | 21 Disc source ? The specified disc does not play , but another one plays instead . ✔ The specified CD is quit e dir ty. ☞ Clean the CD. ✔ The disc is loaded in a diff erent slot from that specified. ☞ Eject the disc magazine and check the number for the specified disc. ✔ The disc is sev erely scratched. ☞ T r y another disc i ...

  • Kenwood KDC-132 - page 22

    22 | English Specifications FM tuner section Fr equency range (200 kH z space) : 87.9 MHz – 107.9 MH z Usable sensitivity (S/N = 30dB) : 9.3dBf (0.8 V/75 Ω) Quieting sensitivity (S/N = 50dB) : 15.2dBf (1.6 V/75 Ω) Fr equency response (±3.0 dB) : 30 Hz – 15 kH z Signal to Noise ratio (MONO) : 70 dB Selectivity (±400 kH z) : ≥ 80 dB ...

メーカー Kenwood カテゴリー Car Stereo System

Kenwood KDC-132のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- KDC-132の取扱説明書
- Kenwoodの製品カード
- パンフレット
- またはKenwood KDC-132の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Kenwood KDC-132の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Kenwood KDC-132の取り付け説明書、サービスマニュアル、簡易説明書、またはKenwood KDC-132のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Kenwood KDC-132の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Kenwood KDC-132デバイスの取扱説明書はどのようなものですか？
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがKenwood KDC-132を使用するのを助ける技術的文書のことです。説明書は通常、全てのKenwood KDC-132ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Kenwoodの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Kenwood KDC-132の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははKenwood KDC-132の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Kenwood KDC-132に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Kenwood KDC-132デバイスの基本機能を使うにあたってのヒント。 Kenwood KDC-132のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Kenwood KDC-132に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるKenwood KDC-132のメーカー/サービスへの連絡先に関する情報。

Kenwood KDC-132についてご質問がありますか？

次のフォームを使用してください

見つけた説明書を読んでもKenwood KDC-132の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがKenwood KDC-132で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

Captcha
新しい画像

コメント (0)