Dell POWEREDGE CLUSTER SE100の取扱説明書

18ページ 0.1 mb
ダウンロード

ページに移動 of 18

Summary
  • Dell POWEREDGE CLUSTER SE100 - page 1

    Dell™ PowerEdge™ Cluster SE100, SE200, and SL200 PL ATFORM GUIDE ™ ww w .dell.com support.dell.com ...

  • Dell POWEREDGE CLUSTER SE100 - page 2

    Notes, Notices, Cautions, and Warnings Throughout this guide, blocks of text may be accompanied by an icon and printed in bold type or in italic type. These blocks are notes, notices, cautions, and warnings, and they are used as follows: NOTE: A NOTE indicates important information that helps you make better use of your computer system. NOTICE: A N ...

  • Dell POWEREDGE CLUSTER SE100 - page 3

    iii Contents PowerEdge Cluster SE100 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Windows 2000 Advanced Server . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Windows NT 4.0 Server , Enterprise Edition . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 W indows NT 4 ...

  • Dell POWEREDGE CLUSTER SE100 - page 4

    iv ...

  • Dell POWEREDGE CLUSTER SE100 - page 5

    support.dell.com Dell PowerEdge Cluster SE 100, SE200 , and SL200 Platform G uide 1 Dell ™ P owerEdge ™ Cluster SE100, SE200 , and SL200 Platform G uid e This guide p rovides the latest information on using M icrosoft ® W indows NT ® Server 4.0 , E nterprise Editi on operating system and Windows ® 2000 Advanced Server oper- ating system f or ...

  • Dell POWEREDGE CLUSTER SE100 - page 6

    2 Dell PowerEdge Cluster SE 100, SE200 , and SL200 Platform G uide P owerEdge Cluster SE10 0 The PowerEdge Cluster SE 100 supports clustering with Windows NT Server 4.0 , Enterprise Edition or Windows 2000 Advanced Serve r . See the following sections for information on supported configurations and service pa cks (SPs) for your Windows operating sy ...

  • Dell POWEREDGE CLUSTER SE100 - page 7

    support.dell.com Dell PowerEdge Cluster SE 100, SE200 , and SL200 Platform G uide 3 W indows NT 4.0 Service Pack Support Windows NT SP 6.0a or later is recommended for PowerEdge Cluster SE 10 0 s ystems. NOTE: Both nodes must be configured with similar drivers (network interface control- lers [NIC], redundant array of independent disks [RAID] contr ...

  • Dell POWEREDGE CLUSTER SE100 - page 8

    4 Dell PowerEdge Cluster SE 100, SE200 , and SL200 Platform G uide Adding Peripherals Required for PowerEdge 6300 or 6350 WARNING: Hardware installation should be performed only by trained service technicians. Before working inside the computer system, see the safety instructions in your PowerEdge system documentation to avoid a situation that coul ...

  • Dell POWEREDGE CLUSTER SE100 - page 9

    support.dell.com Dell PowerEdge Cluster SE 100, SE200 , and SL200 Platform G uide 5 Y our PowerEdge Cluster SE200 and S L2 00 system supports the following PowerEdge servers as cluster nodes in homogeneous pairs (same server) with Windows 2000 Advanced Server: • PowerEdge 2400 • PowerEdge 2450 • PowerEdge 4400 • PowerEdge 6 400 • PowerEdg ...

  • Dell POWEREDGE CLUSTER SE100 - page 10

    6 Dell PowerEdge Cluster SE 100, SE200 , and SL200 Platform G uide Windows NT 4.0 Service Pack Support Windows NT SP 6.0a or later is recommended for PowerEdge Cluster SE200 and SL200 systems. NOTE: Both nodes must be configured with similar drivers (NIC, RAID controlle r, and so on), utilities (Dell OpenManage s uite, PowerConsole, and so on), fir ...

  • Dell POWEREDGE CLUSTER SE100 - page 11

    support.dell.com Dell PowerEdge Cluster SE 100, SE200 , and SL200 Platform G uide 7 • N IC s — Y ou can install NICs in any available PCI slot . • DRAC 2 — I f you are currently using a DRAC 2 or p lan to use one in the future , install it in PCI slot 6 . NOTE: T o make sure that the SCSI or RAID controller attached to the boot drives initi ...

  • Dell POWEREDGE CLUSTER SE100 - page 12

    8 Dell PowerEdge Cluster SE 100, SE200 , and SL200 Platform G uide A dding Peripherals Required for PowerEdge 4400 Cluster Nodes WARNING: Hardware installation should be performed only by trained service technicians. Before working inside the computer system, see the safety instructions in your PowerEdge system documentation to avoid a situation th ...

  • Dell POWEREDGE CLUSTER SE100 - page 13

    support.dell.com Dell PowerEdge Cluster SE 100, SE200 , and SL200 Platform G uide 9 • P CI buses — PCI bus 1: PCI slot 1 is 32-bit, 33-MHz — PCI bus 2: PCI slots 2 through 5 are 64-bit, 33-MHz — PCI bus 3: PCI slots 6 and 7 are 64-bit, 33/66-MHz • RAID co ntrollers — R AID controllers can be installed in any available 32-bit, 33-MHz or ...

  • Dell POWEREDGE CLUSTER SE100 - page 14

    10 Dell PowerEdge Cluster SE 100, SE200 , and SL200 Platform G uide • RAID co ntrollers — Install the RAID controller for the server ’ s internal drives in PCI slot 1 . — In stall additional RAID controllers in any available 64-bit, 33-MHz or 32-bit, 3 3-M Hz P CI slot. — If you use multiple RAID controllers and there are available slots, ...

  • Dell POWEREDGE CLUSTER SE100 - page 15

    support.dell.com Dell PowerEdge Cluster SE 100, SE200 , and SL200 Platform G uide 11 • Storage array description for each storage array • Service tag information for each cluster component • Connectivity information to indicate the SCSI connector (A or B) on each shared storage system t hat connects to the RAID controller channel (A or B) o n ...

  • Dell POWEREDGE CLUSTER SE100 - page 16

    12 Dell PowerEdge Cluster SE 100, SE200 , and SL200 Platform G uide PowerEdge Cluster SE100 Configuration Matrix Cluster Type PowerEdge Cluster SE 100 Cluster Name Installer Date Installed Applications Location Notes Node PowerEdge Server Model Windows NT Name Node 1 Node 2 Storage Array Description (Drive letters, RAID types, applications/data ins ...

  • Dell POWEREDGE CLUSTER SE100 - page 17

    support.dell.com Dell PowerEdge Cluster SE 100, SE200 , and SL200 Platform G uide 13 PowerEdge Cluster SE200/SL200 C onfiguration Matrix Cluster Type PowerEdge Cluster SE200 or SL200 Cluster Name Installer Date Installed Applications Location Notes Node PowerEdge Server Model Windows NT Name Node 1 Node 2 Storage Array Description (Drive letters, R ...

  • Dell POWEREDGE CLUSTER SE100 - page 18

    14 Dell PowerEdge Cluster SE 100, SE200 , and SL200 Platform G uide ...

メーカー Dell カテゴリー Server

Dell POWEREDGE CLUSTER SE100のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- POWEREDGE CLUSTER SE100の取扱説明書
- Dellの製品カード
- パンフレット
- またはDell POWEREDGE CLUSTER SE100の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Dell POWEREDGE CLUSTER SE100の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Dell POWEREDGE CLUSTER SE100の取り付け説明書、サービスマニュアル、簡易説明書、またはDell POWEREDGE CLUSTER SE100のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Dell POWEREDGE CLUSTER SE100の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Dell POWEREDGE CLUSTER SE100デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがDell POWEREDGE CLUSTER SE100を使用するのを助ける技術的文書のことです。説明書は通常、全てのDell POWEREDGE CLUSTER SE100ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Dellの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Dell POWEREDGE CLUSTER SE100の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははDell POWEREDGE CLUSTER SE100の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Dell POWEREDGE CLUSTER SE100に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Dell POWEREDGE CLUSTER SE100デバイスの基本機能を使うにあたってのヒント。 Dell POWEREDGE CLUSTER SE100のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Dell POWEREDGE CLUSTER SE100に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるDell POWEREDGE CLUSTER SE100のメーカー/サービスへの連絡先に関する情報。

Dell POWEREDGE CLUSTER SE100についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもDell POWEREDGE CLUSTER SE100の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがDell POWEREDGE CLUSTER SE100で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)