日本語 dropdown-ico

Thermo Products CHB1-125の取扱説明書

18ページ 1.03 mb
ダウンロード

ページに移動 of 18

Summary
  • Thermo Products CHB1-125 - page 1

    GAS FURNACE HIGHBOY AND COUNTERFLOW USERS INFORMATION MANUAL MODELS FOR USE WITH NATURAL GAS OR LP GAS (PROPANE) CHB1-50 CDB1-50 MHA1-50 MDA1-50 CHX1-75 CHB1-75 CDX 1-75 CDB1-75 MHA1-75 MDA1-75 CHX1-100 CHB1-100 CDX1-100 CDB1-100 MHA1-100 MDA1-100 CHX1-125 CHB1-125 CDX1-125 CDB1-125 MHA1-125 MDA1-125 : IF YOU DO NOT FOLLOW THE SAFETY PRECAUTIONS BE ...

  • Thermo Products CHB1-125 - page 2

    INDEX SECTION B E G I N N I N G P A G E I . S A F E T Y I N F O R M A T I O N 1 I I . GENERAL INSTRUCTI ONS 5 III. FU R N AC E O P E RA T ION 1 0 A. W ARNI NGS BEFORE OPERATING 10 B. OP ERATI NG INSTRUCTIONS 10 C. SHUTDOWN PROC EDURE 11 I V. HOMEOWNER/USER MAINTENANCE I NSTRUCTI ONS 11 (ROUTINE MAI NTENANCE) A. ANNUAL INSPECTION 11 B. FI LTER MAI N ...

  • Thermo Products CHB1-125 - page 3

    All installations and ser vices m ust be perform ed by qualified se rvice personne l. 1 I. SAFETY INF ORMATION This and the following page contain reproductions of the various warning and instruction labels placed on the Thermo Pride Condensing Gas Furnaces. Please read and comply with the contents of these labels. ...

  • Thermo Products CHB1-125 - page 4

    All installations and ser vices m ust be perform ed by qualified se rvice personne l. 2 This and the previous page contain reproductions of the various warning and instruction labels placed on the Thermo P ride Two Stage Condensing Gas Furnaces. P lease read and comply with th e contents of these l abels. ...

  • Thermo Products CHB1-125 - page 5

    All installations and ser vices m ust be perform ed by qualified se rvice personne l. 3 ...

  • Thermo Products CHB1-125 - page 6

    All installations and ser vices m ust be perform ed by qualified se rvice personne l. 4 This page contains var ious warnings and cautions found t hroughout this m anual. P lease read and comply w ith the statements below . : IF YOU DO NOT FOLLOW THE SAFETY PRECAUTIONS BE LOW A ND IN THIS MA NUAL , A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERT Y DA ...

  • Thermo Products CHB1-125 - page 7

    All installations and ser vices must be pe rform ed by qualified se rvice pe rsonnel. 5 II. GENERAL INSTRUCTIONS 1. : Property damage, personal injury , or loss of life could result from repair or service of this furnace by any one other than a quali fied heating contractor. Only the routine maintenance described in this manual may be performed by ...

  • Thermo Products CHB1-125 - page 8

    All installations and ser vices must be pe rform ed by qualified se rvice pe rsonnel. 6 Figure 2 ...

  • Thermo Products CHB1-125 - page 9

    All installations and ser vices must be pe rform ed by qualified se rvice pe rsonnel. 7 Figure 3 ...

  • Thermo Products CHB1-125 - page 10

    All installations and ser vices must be pe rform ed by qualified se rvice pe rsonnel. 8 3. : To avoid injury from moving parts, shut off the power to the furnace before removing blower compartment door. 4. : Keep furnace free and clear of combustibl e materials, gasoline, and other flammable liquids and vapors. 5. The furnace needs air for combusti ...

  • Thermo Products CHB1-125 - page 11

    All installations and ser vices must be pe rform ed by qualified se rvice pe rsonnel. 9 8. The furnace should be inspected annually by a qualified heating contractor. 9. : Do not use this furnace if any part has been under water. Immediately call a qualified heating contractor t o inspect the furnace and to replace any part of the control sy stem a ...

  • Thermo Products CHB1-125 - page 12

    All installations and ser vices must be pe rform ed by qualified se rvice pe rsonnel. 10 III. FURNACE OP ERATION A. WARNINGS BEFORE OPERATING FOR YOUR SAFETY, READ BEFORE OPERATING : A fire or explosion may result causing property damage, personal injury or loss of life if y ou do not follow these instructions e xactly . A. This appliance does not ...

  • Thermo Products CHB1-125 - page 13

    All installations and ser vices must be pe rform ed by qualified se rvice pe rsonnel. 11 5. Turn gas control knob clockwise to “OFF ” position. (For g as valves with a switch, move the switch to the “OFF” position). 6. Wait five (5) minutes to clear out any gas. If y ou then smell gas, STOP! Follow Step B in the previous safety information. ...

  • Thermo Products CHB1-125 - page 14

    All installations and ser vices must be pe rform ed by qualified se rvice pe rsonnel. 12 NOTICE: This furnace has been shipped from the factory with a permanently lubricated circulating air blower motor. Any maintenance to this blower motor is to be performed only by a qualified heating contractor. B. FILTER MAINTENANCE P ROCEDURE 1. The return air ...

  • Thermo Products CHB1-125 - page 15

    All installations and ser vices must be pe rform ed by qualified se rvice pe rsonnel. 13 Figure 4. FILTER R EPLAC EMENT See Table 1 f or minimum heating filter areas re quired for the differe nt ty pes of filters ava ilable should the filter used require replacement. I f the unit is equipped with cooling, contact y our installer or a qualified serv ...

  • Thermo Products CHB1-125 - page 16

    All installations and ser vices must be pe rform ed by qualified se rvice pe rsonnel. 14 MINIMUM FILTER AREA REQUIRED (LENGTH X WIDTH, SQ. IN.) TABLE 1 FILTER TY PE MAXIM UM RATE AIR VELOCITY FURNACE MODEL CDB1, CHB1-50 MDA1, M HA1-50 CHX1, CDX1-75 CDB1, CHB1-75 MDA1, M HA1-75 CHX1, CDX1-100 CDB1, CHB1-100 MDA1, M HA1-100 CHX1, CDX1-125 CDB1, CDB1- ...

  • Thermo Products CHB1-125 - page 17

    All installations and ser vices must be pe rform ed by qualified se rvice pe rsonnel. 15 3. Flue Pipe Connection & Chimney for MDA1/MHA1: Visually check flue pipe and chimney for tightness, blockage and corrosion. I f fittings are loose or if blockage or corrosion is suspected to be a problem, contact a qualified heating contractor. Make sure h ...

  • Thermo Products CHB1-125 - page 18

    All installations and ser vices must be pe rform ed by qualified se rvice pe rsonnel. 16 9. Make sure the burner flames are in good adjustment (See Figure 6). B urner flames should not impinge or fire ag ainst the side of the tube opening. NOTICE: It is not unusual to have orangish flames visible in the tube for L P gas. Figure 6. : Call a qualifie ...

メーカー Thermo Products カテゴリー Furnace

Thermo Products CHB1-125のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- CHB1-125の取扱説明書
- Thermo Productsの製品カード
- パンフレット
- またはThermo Products CHB1-125の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Thermo Products CHB1-125の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Thermo Products CHB1-125の取り付け説明書、サービスマニュアル、簡易説明書、またはThermo Products CHB1-125のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Thermo Products CHB1-125の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Thermo Products CHB1-125デバイスの取扱説明書はどのようなものですか？
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがThermo Products CHB1-125を使用するのを助ける技術的文書のことです。説明書は通常、全てのThermo Products CHB1-125ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Thermo Productsの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Thermo Products CHB1-125の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははThermo Products CHB1-125の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Thermo Products CHB1-125に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Thermo Products CHB1-125デバイスの基本機能を使うにあたってのヒント。 Thermo Products CHB1-125のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Thermo Products CHB1-125に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるThermo Products CHB1-125のメーカー/サービスへの連絡先に関する情報。

Thermo Products CHB1-125についてご質問がありますか？

次のフォームを使用してください

見つけた説明書を読んでもThermo Products CHB1-125の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがThermo Products CHB1-125で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

Captcha
新しい画像

コメント (0)