-
Chamberlain HE60R - page 1
Installation and operating instructions for HomEntry garage door opener Model HE60R Chamberlain Australia Pty Ltd Phone toll free 1800 638 234 Fax toll free 1800 888 121 Chamberlain New Zealand Ltd Phone toll free 0800 637 546 Fax toll free: 0800 653 663 www .homentry .com.au This manual contains IMPORT ANT SAFETY information. DO NOT PROCEED WITH T ...
-
Chamberlain HE60R - page 2
...
-
Chamberlain HE60R - page 3
The Protector System must be used for all installations where the closing force as measured on the bottom of the door is over 400N (40kgf). Excessive force will interfere with the proper operation of the Safety Reverse System or damage the garage door . After installation, ensure that the parts of the door do not extend over public footpaths or roa ...
-
Chamberlain HE60R - page 4
T ools Required 2 1. Ladder (or similar device to safely support door weight) 2. Adjustable wrench for U-bolts already installed on the door 3. 8mm socket, 10mm socket and 13mm extended socket and socket wrench 4. 30mm socket extension (for minimum sideroom installations) 5. Drill and 5.5mm drill bit 6. Philips screw driver 7. Marker Pen 1. Instruc ...
-
Chamberlain HE60R - page 5
3 Door Requirements 3 Ensure that there is at least 45mm from the edge of the curtain to the edge of the bracket. If the roller door drums are on the edge of the curtain or are of small diameter additional clearance maybe required. If the drums are more than 60mm from the curtain edge or of small diameter extension poles maybe required. Different d ...
-
Chamberlain HE60R - page 6
T esting the door Disable all locks and remove any ropes connected to the garage door . Complete the following test to ensure your door is well balanced, and not sticking or binding: • Lift the door to about halfway and then release it. The door should remain suspended entirely by its spring. • Raise and lower the door to discover if there are ...
-
Chamberlain HE60R - page 7
5 Preparing the Opener 7 For left hand side installations the wire jumper should be removed . Place the Opener in Manual Release mode. • Pull the release cord down and across to engage the ball into the cup. The drive forks should now be able to be moved manually . NOTE: T o re-engage the opener , pull the release cord across and up. For right ha ...
-
Chamberlain HE60R - page 8
6 Installation steps 8 FOR RIGHT HAND INST ALLA TIONS (REFER SECTION 7, page 5) • Ensure that the opener position jumper (wire connector) is installed (refer Section 7, page 5). • Place the opener in manual release mode (refer Section 7, page 5). • Open the roller door fully . For safety , tie a rope around the door . Ensure that the U-bolt o ...
-
Chamberlain HE60R - page 9
Pinning the Door 11 Use two metal self tapping metal screws provided to hold the curtain to the door drum. Note: A ballooning may delay the safety response and can compromise your garage door security . • Pull the release cord down Firmly to disengage the motor . Once the door is closed pull the cord down firmly to re-engage the opener . • T ry ...
-
Chamberlain HE60R - page 10
Setting the Limits The T ravel Limits regulate the points at which the door will stop when moving UP or DOWN. During the SetUp procedure, the motor will run and operate the door . The Opener must be fully installed on the door and all installation steps completed before proceeding. Make sure the door is clear of obstruction. Ensure your hands are a ...
-
Chamberlain HE60R - page 11
Setting the Force The force, as measured on the closing edge of the door , should not exceed 400N (40kg). If the closing force is measured to more than 400N, the Protector System must be installed. See Section 16. The force setting regulates the amount of power required to open and close the door . • Door should be closed. • Press the PURPLE bu ...
-
Chamberlain HE60R - page 12
10 Install the Protector System™ (Safety Beams) Install this accessory for all installations where the closing force as measured on the bottom of the door is over 400N (40kgf). After opener has been installed and adjusted, The Protector System™ accessory can be installed. Instructions are included with this accessory . The Protector System™ p ...
-
Chamberlain HE60R - page 13
CARE OF YOUR OPENER When properly installed, your opener will provide high performance with minimal maintenance. The opener does not require additional lubrication. Limit and Force Settings: These settings must be checked and properly set when the opener is installed. Weather conditions may cause some minor changes in the door operation, requiring ...
-
Chamberlain HE60R - page 14
12 Troubleshooting 1. The opener doesn't operate from either the GREEN start button or the remote controls: • Does the opener have electric power? Plug a lamp into the outlet. If it doesn't light, check the fuse box. • Have you disabled all door locks? Review installation instruction warnings on page 1. • Is there a build-up of ice ...
-
Chamberlain HE60R - page 15
13 OPERA TION OF YOUR OPENER Y our opener can be activated by any of the following devices: • The green start button Hold the button down until door starts to move. • The W all Control, Outside Keylock or Keyless Entry System (if you have installed any of these accessories). • The Remote Control T ransmitter or Wireless W all Control (84330AM ...
-
Chamberlain HE60R - page 16
Liability – Australia only Under no circumstances shall the Seller be liable for consequential, incidental or special damages arising in connection with the use, or inability to use, the Unit. In no event shall the Seller's liability for damages or injury arising from breach of law or contract or for negligence, exceed the cost of repairing ...
Chamberlain HE60Rについてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもChamberlain HE60Rの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがChamberlain HE60Rで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。