Ryobi EJ101の取扱説明書

20ページ 0.47 mb
ダウンロード

ページに移動 of 20

Summary
  • Ryobi EJ101 - page 1

    OPERA T OR'S MANUAL 2 CYCLE GASOLINE POWERED RECIPROCA TING SA W MODEL NO. EJ101 For Questions, Call 1-800-525-2579 in the U.S. or 1-800-265-6778 in Canada www.ryobi.com SA VE THIS MANUAL FOR FUTURE REFERENCE SPECIFICATIONS: Length of stroke 1 in. (25.4mm) Strokes per minute 0-2000 spm Length (without blade) 17 in. (430 mm) Engine Type Air Coo ...

  • Ryobi EJ101 - page 2

    Page 2 TABLE OF CONTENTS ■ Table of Contents ........................................................................................................................................ 2 ■ Introduction ................................................................................................................................................. 2 ...

  • Ryobi EJ101 - page 3

    Page 3 Note: For users on U.S. Forest Land and in the states of California, Maine, Oregon and Washington. All U.S. Forest Land and the state of California (Public Resources Codes 4442 and 4443), Oregon and Washington require, by law that certain internal combustion engines operated on forest brush and/or grass-covered areas be equipped with a spark ...

  • Ryobi EJ101 - page 4

    Page 4 Look for this symbol to point out important safety precautions. It means attention!!! Y our safety is involved. The operation of any reciprocating saw can result in foreign objects being thrown into your eyes, which can result in severe eye damage. Before beginning power tool operation, always wear safety goggles or safety glasses with side ...

  • Ryobi EJ101 - page 5

    Page 5 READ ALL INSTRUCTIONS ■ KNOW YOUR POWER TOOL - Read operator's manual carefully. Learn its applications and limita- tions as well as the specific potential hazards re- lated to this tool. ■ KEEP GUARDS IN PLACE and in working order. ■ KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents. ■ AVOID DANGEROUS ENVIRONME ...

  • Ryobi EJ101 - page 6

    Page 6 ■ DRUGS, ALCOHOL, MEDICATION. Do not oper- ate tool while under the influence of drugs, alcohol, or any medication. ■ WHEN SERVICING USE ONLY IDENTICAL RYOBI REPLACEMENT PARTS. ■ WARNING: TO AVOID POSSIBLE SERIOUS IN- JURY, KEEP HANDS AND FINGERS FROM BE- TWEEN THE MOTOR HOUSING AND SAW BLADE CLAMP. ■ SAVE THESE INSTRUCTIONS. Refer t ...

  • Ryobi EJ101 - page 7

    Page 7 • Use only genuine Ryobi replacement parts when servicing this unit. These parts are available from your authorized service dealer. Do not use parts, accessories or attachments not authorized by Ryobi for this unit. Doing so could lead to serious injury to the user, or damage to the unit, and void your warranty. • Keep unit clean from fo ...

  • Ryobi EJ101 - page 8

    Page 8 STOP UNPACKING Your saw has been shipped completely assembled and ready for use. Inspect it carefully to make sure no breakage or damage has occurred during shipping. If any parts are damaged or missing, contact your nearest Ryobi dealer to obtain replacement parts before attempting to operate saw. A blade pack, spark plug wrench, 4 mm hex k ...

  • Ryobi EJ101 - page 9

    Page 9 FEA TURES SWITCH See Figure 2. Your saw is equipped with an On/Off Switch for starting and stopping the engine. You must slide the switch forward to the ON (I) position in order to allow for the engine to be started when pulling starter rope. Slide the switch back to OFF (0) position to stop engine. LOCK-OFF LEVER See Figure 2. Your saw is a ...

  • Ryobi EJ101 - page 10

    Page 10 OIL AND FUEL INFORMA TION OIL AND FUEL MIXING INSTRUCTIONS Old and/or improperly mixed fuel are the main reasons for the unit not running properly. Be sure to use fresh, clean unleaded fuel. Follow the instructions carefully for the proper fuel/oil mixture. DEFINITION OF BLENDED FUELS Today's fuels are often a blend of gasoline and oxy ...

  • Ryobi EJ101 - page 11

    Page 11 ST ARTING/ST OPPING INSTRUCTIONS PREPARING FOR OPERATION 1. Mix gas with oil. Fill fuel tank with fuel/oil mixture. See Oil and Fuel Mixing Instructions on previous page. 2. Do not overfill or spill fuel. 3. Replace gasoline cap on gas tank. Make sure it is securely tightened before attempting to start engine. 4. Make sure all screws and fa ...

  • Ryobi EJ101 - page 12

    Page 12 OPERA TION W ARNING: The engine of your saw should never be running when you are installing or removing blades. Stop the engine and let it cool to prevent accidental contact with the blade, muffler, etc. that could cause serious injury. Disconnect the spark plug to make sure the saw will not start. TO INSTALL BLADES See Figure 5. ■ Use th ...

  • Ryobi EJ101 - page 13

    Page 13 Fig. 8 Fig. 7 Fig. 9 OPERA TION GENERAL CUTTING See Figure 7. Hold your saw firmly in front of and clearly away from you. Make sure saw blade is clear of any foreign material. Be sure material to be cut is held firmly. Small work pieces should be securely clamped in a vise or with clamps to the work bench or table. Mark the line of cut clea ...

  • Ryobi EJ101 - page 14

    Page 14 W ARNING: When servicing use only identical Ryobi replacement parts. Use of any other parts may create a hazard or cause product damage. W ARNING: Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask. W ARNING: To prevent serious persona ...

  • Ryobi EJ101 - page 15

    Page 15 MAINTENANCE AIR FILTER MAINTENANCE See Figure 12. W ARNING: To avoid serious personal injury, always turn your saw off and allow it to cool before you clean or do any maintenance on it. 1. Using a small phillips screwdriver, loosen and remove the air filter cover screws (2) and air filter cover. 2. Separate and remove the air filter element ...

  • Ryobi EJ101 - page 16

    Page 16 MAINTENANCE CARBURETOR ADJUSTMENT See Figure 10. The carburetor on your saw has been factory set. After extended use of your saw adjustments may be required. The high speed needle has been permanently set from the factory at 1-1/4 turns counterclockwise from the closed position. No additional adjustments should be required or made to this n ...

  • Ryobi EJ101 - page 17

    Page 17 CLEANING AND ST ORAGE W ARNING: To avoid serious personal injury, always turn your saw off and allow it to cool before you clean or do any maintenance on it. GENERAL Avoid using strong detergents or solvents when cleaning plastic parts. Most plastics are susceptible to various types of commercial solvents and may be damaged by their use. Us ...

  • Ryobi EJ101 - page 18

    Page 18 TROUBLESHOOTING ENGINE LACKS POWER OR STALLS WHEN CUTTING ENGINE WILL NOT ACCELERATE ENGINE WILL NOT IDLE ENGINE WILL NOT START CAUSE ACTION On/Off Switch is in OFF position Turn On/Off Switch to ON Empty fuel tank Fill fuel tank with properly mixed fuel Primer bulb wasn't pressed enough Press primer bulb fully and slowly 5-7 times Eng ...

  • Ryobi EJ101 - page 19

    Page 19 NOTES ...

  • Ryobi EJ101 - page 20

    OPERA T OR'S MANUAL 2 CYCLE GASOLINE POWERED RECIPROCA TING SA W MODEL NO. EJ101 972000-634 8-99 Printed in U.S.A. R YOBI AMERICA CORP . 1424 Pearman Dairy Road Anderson, SC 29625 Post Office Box 1207 Anderson, SC 29622-1207 Phone 1-800-525-2579 R YOBI CANADA INC. Post Office Box 910 Cambridge, Ontario N1R 6K2 Phone 1-800-265-6778 • SER VICE ...

メーカー Ryobi カテゴリー Cordless Saw

Ryobi EJ101のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- EJ101の取扱説明書
- Ryobiの製品カード
- パンフレット
- またはRyobi EJ101の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Ryobi EJ101の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Ryobi EJ101の取り付け説明書、サービスマニュアル、簡易説明書、またはRyobi EJ101のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Ryobi EJ101の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Ryobi EJ101デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがRyobi EJ101を使用するのを助ける技術的文書のことです。説明書は通常、全てのRyobi EJ101ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Ryobiの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Ryobi EJ101の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははRyobi EJ101の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Ryobi EJ101に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Ryobi EJ101デバイスの基本機能を使うにあたってのヒント。 Ryobi EJ101のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Ryobi EJ101に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるRyobi EJ101のメーカー/サービスへの連絡先に関する情報。

Ryobi EJ101についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもRyobi EJ101の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがRyobi EJ101で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)