-
Kathrein UFE 371/S - page 1
Operating Instructions DVB-T Receiver UFE 371/S ...
-
Kathrein UFE 371/S - page 2
2 ...
-
Kathrein UFE 371/S - page 3
Preface 3 Preface Dear Customer, These operating Instructions will hel p you make optimum use of the many functions of your new DVB-T receiver. We have made the operating instructions as easy as possible to understand, and as short as possible. For environmental protection, we have equipped a power switch. Switch off your receiver to save el ectric ...
-
Kathrein UFE 371/S - page 4
Content 4 Content Preface ........................................................................................................................ ...................................... 3 Content ........................................................................................................................ ................................. ...
-
Kathrein UFE 371/S - page 5
Views and Connections 5 3 Views and Connections Front View 1) Operation/Stand-by key 2) Programme-selection keys 3) Programme display Rear View 1) TV antenna input socket 2) TV antenna input (looped-through signal) 3) RS 232 data interface for serial data transmi ssion during maintenance service (only with null modem) 4) SCART connection for TV set ...
-
Kathrein UFE 371/S - page 6
Remote Control 6 Remote Control 1 2 3 4 6 7 8 9 10 11 12 5 13 6 5 14 15 16 17 18 19 20 ...
-
Kathrein UFE 371/S - page 7
Remote Control 7 Functions of the Remote Control 1) POWER: switching on and stand-by mode 2) Numeric keypad (0-9): For entering programme numbers or menu parameters 3) QUALITY/P-: Displays the DVB-T signal level of the current programme. Also used for the antenna alignment and for paging (-) in lists 4) MENU: Call-up of the main menu 5) Up/Dow n: F ...
-
Kathrein UFE 371/S - page 8
Remote Control 8 Using the Remote Control You can use the OK key to confirm the individual settings in the menus or to call up sub-menus. Change each setting line by line, and confirm the entry by pressing the OK key. Press EXIT key to leave the menu, or change from a sub-menu to ist respective main menu. Use the / keys to navigate through ...
-
Kathrein UFE 371/S - page 9
Safety Notices 9 Safety Notices ...
-
Kathrein UFE 371/S - page 10
Operation 10 Operation First Installation When you have connected your receiv er properly, switch it on using the power switch on the rear of the unit. You will see the following: Now select the language in which you would like to see the menu by using the / keys. If you use a DVB-T indoor antenna (e.g. the Kathrein BZD 30), the antenna mus ...
-
Kathrein UFE 371/S - page 11
Operation 11 Programme Selection (TV and Radio) The receiver is preassigned for the most common programmes. Your terrestrial antenna must accurately aligned to achieve proper reception. Press the OK key to call up the list of existing programmes. Select the programme using the / keys, and press the OK key. Note: You may also call up the pro ...
-
Kathrein UFE 371/S - page 12
Operation 12 Programme Information When you change to another channel, the following information is displayed at the bottom of the screen: - The type of programme: TV or Radio (indicated by an icon) - The name of the programme - EPG (Electronic Programme Guide) reception, indicated by the letter ”E” - Videotext reception, indicated by the lette ...
-
Kathrein UFE 371/S - page 13
Operation 13 Electronic Programme Guide (EPG) The EPG (Electronic Programme Guide) key can be used to call up the programme information, if br oadcast by the programme provider. You can switch to the desired programme by pressing either or . For automatical programming, press the blue key. The timer will then be set automatically To have th ...
-
Kathrein UFE 371/S - page 14
Operation 14 You can also obtain detailed inform ation directly from the current programme, using the red key. You will then see a display of the desired data about the current TV progr amme without having to switch to EPG mode first (see illustration). To switch to the next or previous day, press the Recall/P+ or Quality/P- key, respectively. Note ...
-
Kathrein UFE 371/S - page 15
Operation 15 Pause and Zoom You can use these keys to make the picture smaller, or to switch to freeze image. The Quality Key (Auxiliary function for antenna adjustment) In addition to the display showing st rength and quality of reception, the receiver has also an auxiliary func tion with an acoustic signal for the antenna alignment. To use this f ...
-
Kathrein UFE 371/S - page 16
Main Menu 16 Main Menu Calling up the Main Menu (MENU key) Press the MENU key to call up the main menu, select the desired sub- menu, and press the OK key. There are five sub-menus avail able, which are explained below: 1) Timer Menu for setting time-delayed recording or automatic stop 2) Edit Channel List Allows the organisation, stori ng and the ...
-
Kathrein UFE 371/S - page 17
Main Menu 17 Organising Programmes and Favourites Sorting: Press the red key to call up the sort functions. When you exit the menu, the receiver prompts y ou for password confirmation. Attention! When sorting has been confirmed, acce ss to the previous lists is no longer possible. Favourites: Press the blue key in the “Programme Organisation” m ...
-
Kathrein UFE 371/S - page 18
Main Menu 18 Setting the Timer (Automatic Programming) Note: The timer can also be programmed with the Electronic Program me Guide (EPG). See Page 14. The clock must be set correctly in order that the timer is ready for operation (see Installation Menu). Programme the Timer Number (1 to 8), activate the timer to release the settings, and then selec ...
-
Kathrein UFE 371/S - page 19
Installation Menu 19 Installation Menu Adjusting the receiver to y our receiving installation: 1) Antenna alignment Select 5 V power supply (On/Off) for the antenna 2) Scan Auto Scan (overall search), Net Scan (network search), TP Scan (specific channels) and PID Scan (search for one specific programme, using the PID). 4) System setup Adjustment to ...
-
Kathrein UFE 371/S - page 20
Installation Menu 20 Antenna Type Note: Should you use a DVB-T indoor antenna (e.g. Kathrein BZD 30, visible in the background), it must receive a power supply of 5 V. If the antenna has its own power supply, the default setting of 5 V AUS (inactive) must be retained. Setting Up a Channel Although the receiver is preassigned, it may be necessary to ...
-
Kathrein UFE 371/S - page 21
Installation Menu 21 In this menu, you can carry out the programme search. 1) AutoScan All channels in the range of 177 MHz to 858 MHz are searched for programmes. 2) Net Scan The entire network is searched for network information. (Results only if this inform ation is transmitted with the programmes). 3) TP Scan Search for individual channels. 4) ...
-
Kathrein UFE 371/S - page 22
Installation Menu 22 System Configuration This menu allows the adaptation of y our receiver to your audio-visual surroundings, or the reset to the factory settings: Setting Languages Access to language selection. The following menu languages are available: German, Spanish, Italian, Czech and English. The preferred languages for audio and sub-titles ...
-
Kathrein UFE 371/S - page 23
Installation Menu 23 Setting TV Selection of video output standard (PAL, NTSC, SECAM, AUTO), screen format type (4/3 or 16/9) and the output signal which can be obtained at the TV output: CVBS: composite colour video signal RGB: separate signals for red/green/blue Note: The selection of the screen format type (4/3 or 16/9) always depends on your TV ...
-
Kathrein UFE 371/S - page 24
Installation Menu 24 Clock Parameters Date and time must be programmed in order that the receiver indicates the correct information messages when you use the timers, and in the information messages mode (and on the front in stand-by mode). The internal clock can be set as follows: a) The transmitted time of day can be used (default setting). In thi ...
-
Kathrein UFE 371/S - page 25
Installation Menu 25 System Information Display of the hardware and software versions of the receiver. Factory Settings This menu is protected with t he password “0000”. If you have changed the programming of the receiver and want to return it to the condition in which it was delivered, select this item. Press the OK key and enter the password. ...
-
Kathrein UFE 371/S - page 26
Installation Menu 26 Parental Lock In this menu, you can lock all m enus to prevent inadvertent wrong setting. The receiver is delivered with the installation menu locked, but the other menus are not protected. For child protection, it is necessary to lock all the menus. Attention: Keep the password in mind in case you have changed it. Should you f ...
-
Kathrein UFE 371/S - page 27
Installation Menu 27 Software Update Attention: A PC and a null-modem cable are required for the update process! If new software for your DVB-T rece iver should become available, you can download it from the following homepage: www.esc-kathrein.de/download/ There you will also find information and notes on the software update process via the RS 232 ...
-
Kathrein UFE 371/S - page 28
Games 28 Games Use the / keys in the main menu to select “Games” and press then OK . The following is then displayed: Choose one of the two games listed. Note: When you have selected a game, please follow the on-screen notes. All games are controlled with the keys shown below: ...
-
Kathrein UFE 371/S - page 29
Games 29 Tetris Snake ...
-
Kathrein UFE 371/S - page 30
Functions and Technical Data 30 Functions and Technical Data • Reception of free, digital terrestrial TV and radio programmes • 1000 Programme memory positions • Electronic Programme Guide (EPG), showing information on the current and the succeeding programmes of the next few days *) • 8 Timers – programmable also via EPG • Software upd ...
-
Kathrein UFE 371/S - page 31
Functions and Technical Data 31 Designation UFD 371/S Order Number 20210062 RF Characteristics Input frequency range MHz 177.5-226.5 and 474-858 Channel bandwidth MHz 7/8 switchable Modulation type COFDM 2k, 8k Mapping QPSK, 16-QAM, 64-QAM Guard Interval 1/4, 1/8, 1/16, 1/32 FEC 1/2, 2/3, 3/4, 5/6, 7/8 Input-level range/Impedance dBµV/ Ω 28-98/7 ...
-
Kathrein UFE 371/S - page 32
Connection Scheme 32 Connection Scheme Note: Of course, you may also connect a DVD recorder instead of a VCR (video recorder) ...
-
Kathrein UFE 371/S - page 33
DVB-T-Indoor-Antenne BZD 30 33 DVB-T-Indoor-Antenne BZD 30 The reception range of the antenna is 174-230 MHz in the VHF waveband, and 470-862 MHz in the UHF waveband. The BZD 30 has almost omnidirectional characteristics, so exact orientation is not necessary. Depending on how it is installed, both vertical and horizontal polarisation can be receiv ...
-
Kathrein UFE 371/S - page 34
Notice 34 Notice ...
-
Kathrein UFE 371/S - page 35
Notice 35 ...
-
Kathrein UFE 371/S - page 36
Int ern et: ht tp: //www. ka thr ein .de KATHREIN-Werke KG . Phone +49 8031 184-0 . Fax +49 8031 184-306 Anton-Kathrein-Straße 1 – 3 . P.O. Box 10 04 44 . 83004 Rosenheim . Germany 936.2637/A/0705/ZWT - Te chnical alterations reserved! ...
Kathrein UFE 371/Sについてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもKathrein UFE 371/Sの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがKathrein UFE 371/Sで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。