-
NEC NLT-20 - page 1
Owner's Manual Model : NL T -20 20.1" TFT LCD TV/MONITOR 3 W ar nings WARNING : To prevent fire or shock hazard, do not expose the set to rain or moisture. Do not rub or strike the Active Matrix LCD with anything hard as this may scratch, marked, or damage the Active Matrix LCD permanently. - The appliance is not intended for use by young ...
-
NEC NLT-20 - page 2
4 Service Never remove the back cover of the set as this can expose you to high voltage and other hazards. If the set does not operate properly, unplug it and call NEC service centre. Aerial Connect the aerial cable to the socket marked Ant. on the back. For the best reception an outdoor aerial should be used. Location Position your set so that no ...
-
NEC NLT-20 - page 3
6 Supplied Accessor ies L Make Sure the following accessories are provided with Product. 1. AC/DC adaptor 3. Remote controller 5. Owner’s manual 6. PC IN cable 4. Batteries (type AAA) 2. AC Cord POWER MENU TV/AV PR PR VOL VOL TV/PC SLEEP TEXT/MIX UPDATE TIME REVEAL HOLD Q.VIEW LIST PSM SSM I/II 123 456 789 ** 0 NS-201 Owner's Manual Model : ...
-
NEC NLT-20 - page 4
8 Controls All the functions can be controlled with the remote controller. Some functions can also be adjusted with the buttons on the front panel of the set. Remote controller Before you use the remote controller, please install the batteries. 1. POWER Turns the TV on from standby or off to standby mode. 2. MUTE Turns the sound on and off. 3. NUMB ...
-
NEC NLT-20 - page 5
10 ENGLISH T ur ning the TV On and Off Standby Setup: The AC-DC converter and the AC power cord must be set up and connected to have the TV in standby mode ready to be turned on. Press the power button on the front panel of the TV to go into standby mode. 1. If the TV is in standby mode, press the Power button on the remote controller or the TV its ...
-
NEC NLT-20 - page 6
12 ENGLISH Setting up TV Programme Once you have preset the programmes, you will be able to use the PR xy or NUMBER buttons to scan the programmes you programmed. Programmes can be tuned using automatic or manual modes. Auto programme All programmes that can be received are stored by this method. It is recommended that you use Auto programme during ...
-
NEC NLT-20 - page 7
14 ENGLISH Setting up TV Programme Programme edit This function enables you to delete or skip the stored programmes. Also you can move some programmes to other programme numbers or insert a blank programme data into the selected programme number. 1. Press the MENU button. 2. Select the Setup menu. Then press the VOL Ïq button. 3. Press the PR xy b ...
-
NEC NLT-20 - page 8
16 ENGLISH Sound Control You can select your preferred sound setting; Flat, Music, Movie or Speech and you can also adjust the sound frequency of equalizer, balance. If you switch AVL to on, the set automatically keeps on an equal volume level even if you change programmes. 1. Press the MENU button. 2. Select the Sound menu. Then press the VOL Ïq ...
-
NEC NLT-20 - page 9
18 ENGLISH Other functions Calling the programme list You can check the programmes stored in the memory by displaying the programme list. Displaying programme list 1. Press the LIST button to display the Programme list menu. The programme list appears on the screen. One programme list contains ten programmes as right. Note : a. You may find some bl ...
-
NEC NLT-20 - page 10
20 ENGLISH T elete xt Special T eletext functions Changes Teletext mode ; Only Teletext mode, text mode superimposed on the TV picture, TV mode Selects double height text. Press this button to enlarge the top half of the page. Press this button again to enlarge the bottom half of the page. Press this button again to return to the normal display. St ...
-
NEC NLT-20 - page 11
22 ENGLISH Exter nal Equipment Connection A/V OUT 1. Connect the Audio outputs(L, R) of the TV to Audio-IN(L, R) of another displayer or the amplifier system - If you connect the amplifier system, you can also play the TV sound through the stereo amplifier system. 2. Connect the Video output of the TV to Video IN of another displlayer. Note : If yo ...
-
NEC NLT-20 - page 12
24 Connecting PC as monitor Picture adjustment You can adjust picture Contrast, Brightness, Temperature, Horizontal/Vertical position, Clock, Phase, Auto and Reset as you prefer. 1. Press the TV/PC button to select the PC mode. 2. Press the MENU button. 3. Press the PR xy button to select the desired picture item. 4. Press the VOL Ïq button to mak ...
-
NEC NLT-20 - page 13
26 ENGLISH T roubleshooting No picture on screen and no sound from speakers. No picture/No picture from AV terminal. Picture is displayed, but no sound from the speakers. Picture is too light. Picture is too dark. Remote control does not work. The TV picture is not sharp. The TV picture moves. The TV picture is doubled/tripled (Ghosting) The TV pic ...
-
NEC NLT-20 - page 14
500-????031104 ...
NEC NLT-20についてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもNEC NLT-20の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがNEC NLT-20で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。