-
Chamberlain 5580A-2GB - page 1
Instructions – Garage Door Operator Model 5580A-2GB INT Int. Service(+49) 6838/907 172 www .iftmaster .de ...
-
Chamberlain 5580A-2GB - page 2
1-en 1 Before You Begin 1. Look at the wall or ceiling above the garage door. The header bracket must be securely fastened to structural supports. 2. Do you have a finished ceiling in your garage? If so, a support bracket and additional fastening hardware (not supplied) may be required. 3. Depending on your door's construction, you might need ...
-
Chamberlain 5580A-2GB - page 3
2-en Completed Installation As you proceed with the assembly, installation and adjustment procedures in this manual, you may find it helpful to refer back to this illustration of a completed installation. (1) Header Sleeve (2) Chain Pulley Bracket (3) Trolley (4) Rail (5) Chain (6) Hanging Bracket (7) Power Cord (8) Opener (9) Light Lens (10) Manua ...
-
Chamberlain 5580A-2GB - page 4
3-en 3 Position the Opener NOTE: A 25mm (1") board (1) is convenient for setting an ideal door- to-rail distance (unless headroom is not sufficient). Raise the opener onto a stepladder. Open garage door. Place a 25mm (1") board (1) laid flat on the top section of door near the centerline as shown. Rest the rail on the board. If the raised ...
-
Chamberlain 5580A-2GB - page 5
4-en 4 Fasten Door Bracket If yours is a canopy or dual-track one-piece style garage door, a door arm conversion kit is required. Follow the installation instructions included with the replacement door arm. Exercise care in removing and assembling arm conversion kit. Keep fingers away from the sliding parts. NOTE: Horizontal and vertical reinforcem ...
-
Chamberlain 5580A-2GB - page 6
5-en 5 Program your Keyless Entry (optional) Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should enter or leave garage while door is in motion. Do not allow children to operate push button(s) or remote(s). Do not allow children to play near the door. NOTE: Your new Keyless Entry must be progr ...
-
Chamberlain 5580A-2GB - page 7
6-en 6 Force Settings The force, as measured on the closing edge of the door, should not exceed 400N (40kg). If the closing force is measured to more than 400N, the Protector System must be installed See step 27. The force setting button is located on the back panel of the motor unit. The force setting regulates the amount of power required to open ...
-
Chamberlain 5580A-2GB - page 8
7-en Special Features A. Door within a door connection Disconnect opener from power! Remove cover. Locate auxiliary terminal block (TB1) on the control board. Remove jumper from terminal leads 1 and 2 (not shown). Replace with contact switch leads as shown. B. Flashing light connection The flashing light can be installed anywhere. Connect light lea ...
-
Chamberlain 5580A-2GB - page 9
8-en 8 • Delete all remote controls and reprogram. • Make sure remote push button is not stuck "on". • Disconnect all push buttons or key switches attached and wait one day. 9. Door stops but doesn't close completely: Review Limit Adjustment section. Repeat safety reverse test after any adjustment of door arm length, close forc ...
-
Chamberlain 5580A-2GB - page 10
9-en 9 When properly installed, opener will provide high performance with a minimum of maintenance. The opener does not require additional lubrication. Limit Adjustments: These adjustments must be checked and properly set when opener is installed. Only a screwdriver is required. Weather conditions may cause some minor changes in the door operation, ...
-
Chamberlain 5580A-2GB - page 11
10-en Max. Pull Force ...............800N Rated Power ...................400 W Motor Type ................................Permanent split capacitor Speed .............................1500 rpm Volts ................................230-240 Volts AC-50Hz Only Noise level ......................60dB Drive Mechanism Gears ..............................16 ...
-
Chamberlain 5580A-2GB - page 12
11-en Other Requirements: Operators used in the following installations must also be installed with the items noted below. Declaration of Conformity Automatic garage door openers, as stated, are in conformity to the applicable sections of EN55014-1 (2000), EN55014-2 (1997), EN61000-3-2 (2000), EN61000-3-3 (1995), EN 301 489-3 (V1.3.1), EN 300 220-3 ...
-
Chamberlain 5580A-2GB - page 13
A B E C D 1 1 2 1 2 The Chamberlain Group, Inc. F igure 2 - T o ols 4210E - 3/8/93 10mm, 8mm, 4,5mm, 4mm 1 1mm, 13mm 2 8 NOT ICE 1 (2x) 2 (4x) 3 (2x) 4 (2x) 5 (4x) 6 (1x) 7 (1x) 9 (2x) 10 (7x) 1 1 (7x) 12 (4x) 13 (4x) 14 (2x) 15 (2x) 16 (1x) 17 18 19 with rail bei der Schiene bij de rail lors du rail a la orilla del rail hos skinnen con la guida so ...
-
Chamberlain 5580A-2GB - page 14
1 14A3580-02.2008 1 3 2 7 6 L O C K L I GHT 5 L O C K L IGHT 4 K G 1 3 9 7 5 KG 1 3 9 7 5 22 12 4 3 7 LOCK LIGHT 5 LOCK LIGHT 6 LOCK LIGHT KG 1 3 9 7 5 KG 1 3 9 7 5 23 1 2 A. 0-100mm B. 150-250mm 7 6 2 9 1 12 10 1 0 11 8 4 5 3 A 4 3 5 B 7 6 6 1 2 6 4 5 7 3 AB 1 4 C 1 2 3 3 1 2 4 3 4 21 1 1 2 34 26 27 3 2 24 1 1 (2x) 1 1 (2x) 25 1 1 (2x) 1 1 (2x) A ...
Chamberlain 5580A-2GBについてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもChamberlain 5580A-2GBの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがChamberlain 5580A-2GBで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。