-
John Lewis JLBIHD908 - page 1
JLBIHD908 Built-in cook er hood Instruction manual ...
-
John Lewis JLBIHD908 - page 2
2 Impor tant safety inf ormation It is most important that this instruction manual should be retained with the appliance for futur e refer ence. Should the appliance be sold or transferr ed to another o wner , or should y ou mov e house and lea ve the appliance, alwa ys ensure that the book is supplied with the appliance in order that the new o wne ...
-
John Lewis JLBIHD908 - page 3
3 For the User Important Safety Information 2 Description of the Appliance 4 Using the cook er hood 9 Cooker Hood Contr ols 9 T o Operate 10 Recirculation 10 Extraction 10 Maintenance and Cleaning 11 External Cleaning 11 Cleaning the Ducting panels 11 Metal Grease Filters 11 Charcoal Filters 12 T o Remove/Replace Char coal Filter 12 Changing the Ha ...
-
John Lewis JLBIHD908 - page 4
4 Description of the appliance ...
-
John Lewis JLBIHD908 - page 5
5 Please ensure that when the applian ce is installed it is easily accessible to an engineer in the e vent of a breakdo wn. All installations must comply with the local authorities requir ements for the discharge of exhaust air . Incorrect installation ma y affect the safety of this cooker hood. Installation Requirements Before installation check t ...
-
John Lewis JLBIHD908 - page 6
6 Fitting the wall brackets • Dra w a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed. • Dra w a horizontal line at 850 mm above the hob. • Mark a point (1) on the horizontal line , 250 mm to the right of the vertical refer ence line . • Repeat th ...
-
John Lewis JLBIHD908 - page 7
7 Extraction (Ducted) The cooker hood is more effective when installed in the extraction mode (ducted to the outside). V enting kits ma y be pur chased through your retailer or DIY store, and must be evacuated through an outside vent of ø125 (5ins) or ø150mm (6ins). The ducting used must be manufactured from fire retard - ant material conforming ...
-
John Lewis JLBIHD908 - page 8
8 Electrical connection Electrical requir ements Any permanent electrical installation must comply with the latest I.E.E. Regulations and local Electricity Board regulations. For your own safety this should be under - taken by a qualified electrician e .g. your local Electricity Board, or a contractor who is on the roll of the National Inspection C ...
-
John Lewis JLBIHD908 - page 9
9 Using the cook er hood The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. The appliance can be installed to recirculate or extract contaminated air . Cook er hood contr ols The hood can be switched on pushing directly onto the requested speed without firstly ha ving to select 0/1 button. KEY LED ...
-
John Lewis JLBIHD908 - page 10
10 T o operate Select the requir ed fan speed and light if requir ed. Recir culation In the recirculation mode the contaminated air enters the cooker hood through the grease filters. The air is cleaned by passing through the charcoal filters before being passed back into the kitchen through the grilles in either side of the chimney stack. Extractio ...
-
John Lewis JLBIHD908 - page 11
11 Before car r ying out any maintenance or cleaning isolate the cooker hood fr om the mains supply . The cooker hood m ust be kept clean, as a build up of grease or fat can be a fir e hazard. External cleaning Wip e the cook er hood fre que ntl y with warm soap y wate r using a mild detergent. Nev er use scouring pads or abrasive cleaners. Nev er ...
-
John Lewis JLBIHD908 - page 12
12 Alarm signal reset • Stop the motor and switch off the lights. • Press button T3 for at least 3 seconds, until the LEDs start to flash. Before car r ying out any maintenance or cleaning isolate the cooker hood fr om the mains supply . Char coal filters In the recir culation mode the charcoal filters absorb smells and unwanted odours. This ch ...
-
John Lewis JLBIHD908 - page 13
13 Reset the alarm signal • Stop the motor and switch off the lights. • Press button T3 for at least 3 seconds, until the LEDs start to flash. This appliance can be a possible fir e hazard if the grease and charcoal filters ar e not cleaned and replaced as r ecommended. Changing the halogen spot lamp • Remove the lamp from the holder by pulli ...
-
John Lewis JLBIHD908 - page 14
14 Something not w orking Repairs and after sales ser vice If the appliance is not working cor rectly , please carry out the following checks, before contacting y our local Service For ce agent. IMPOR T ANT: If y ou call out an engineer to a fault listed below , or to repair a fault caused by incorrect use or instal - lation, a charge will be made ...
-
John Lewis JLBIHD908 - page 15
...
-
John Lewis JLBIHD908 - page 16
436004228_04 - 080703 John Lewis Par tnership 171 Victoria Street London SW1E 5NN www .johnlewis.com ...
John Lewis JLBIHD908についてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもJohn Lewis JLBIHD908の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがJohn Lewis JLBIHD908で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。