Hitachi CP-A300Nの取扱説明書

22ページ 4.88 mb
ダウンロード

ページに移動 of 22

Summary
  • Hitachi CP-A300N - page 1

    1 ENGLISH Projector CP-A220N/CP-A300N User's Manual (concise) Thank you for purchasing this projector . Please read through this manual before using this product, in order to use safely and utilize well the product. WARNING ►Before using this product, be sure to read all manuals for this product. See the “Using the CD manual” (  20 ) ...

  • Hitachi CP-A300N - page 2

    2 Fir st of all Entries and gr aphical symbols explana tion The following entries and graphical symbols are used for the manuals and the product as follows, for safety purpose. Please know their meanings beforehand, and heed them. Impor tant safety instr uction The followings are important instructions for safely using the product. Be sure to follo ...

  • Hitachi CP-A300N - page 3

    3 ENGLISH R e gulator y notices About Electro-Ma gnetic Interference Thi s is a C lass A pr odu ct. I n a dome sti c env iro nment th is produ ct may c aus e rad io interference in which case the user may be required to take adequate measures. This product may cause interference if used in residential areas. Such use must be avoided unless the user ...

  • Hitachi CP-A300N - page 4

    4 Contents of package Y our projector should come with the items shown below . Check that all the items are included. Require of your dealer immediately if any items are missing. (1) Remote control with the two AA batteries (2) Power cord (3) Computer cable (4) Parts of cable cover (5) User ’s manuals (Book x1, CD x1) (6) Security label (7) Appli ...

  • Hitachi CP-A300N - page 5

    5 ENGLISH WARNING ►Install the projector in a stable horizontal position. ► Place the projector in a cool place, and ensure that there is sufcient ventilation. Do not place the projector where the air from an air conditioner or similar unit will blow on it directly . ►Do not place the projector anyplace where it may get wet. ► Use only t ...

  • Hitachi CP-A300N - page 6

    6 Access point COMPUTER IN1 COMPUTER IN2 HDMI USB TYPE B S-VIDEO VIDEO AUDIO OUT AUDIO IN3 AUDIO IN1 AUDIO IN2 MIC MONITOR OUT CONTROL USB TYPE A DC5V 0.5A R L COMPONENT Cb/Pb Y Cr/Pr AUDIO OUT HDMI R L R L VIDEO S-VIDEO AUDIO OUT AUDIO OUT AUDIO OUT USB (A) DISPLA Y RS-232C LAN VCR/DVD/Blu-ray Disc player Computer Connecting with your de vices Be ...

  • Hitachi CP-A300N - page 7

    7 ENGLISH USB storage device Connecting with your devices (continued) COMPUTER IN1 COMPUTER IN2 HDMI USB TYPE B S-VIDEO VIDEO AUDIO OUT AUDIO IN3 AUDIO IN1 AUDIO IN2 MIC MONITOR OUT CONTROL USB TYPE A DC5V 0.5A R L RGB IN Microphone system Speakers (with an amplier) Monitor NO TE • If a loud feedback noise is produced from the speaker , move t ...

  • Hitachi CP-A300N - page 8

    8 Connecting pow er suppl y 1. Put the connector of the power cord into the AC IN (AC inlet) of the projector . 2. Firmly plug the power cord’s plug into the outlet. In a coup le of sec onds afte r the pow er supply connection, the POWER indicator will light up in steady orange. Please remember that when the DIRECT POWER ON function activated, th ...

  • Hitachi CP-A300N - page 9

    9 ENGLISH Using the cable co ver Utilize the cable cover as the guard and blind for the connecting parts. 1. Connect the signal cables and the power cord to the projector rst. 2. Combine parts as shown in gure, and assemble the cable cover . 3 . Insert the three knobs on the cable cover into the three holes on the projector as shown in the ? ...

  • Hitachi CP-A300N - page 10

    10 Preparing for the remote contr ol Please insert the batteries into the remote control before using it. If the remote control starts to malfunction, try to replace the batteries. If you will not use the remote control for long period, remove the batteries from the remote control and store them in a safe place. 1. Holding the hook part of the batt ...

  • Hitachi CP-A300N - page 11

    11 ENGLISH T ur ning on the pow er 1. Make sure that the power cord is rmly and correctly connected to the projector and the outlet. 2. Make sure that the POWER indicator is steady orange. 3. Conrm that there is nothing that the lens door hits while opening. Press the ST ANDBY/ON button on the projector or the remote control. The lens door op ...

  • Hitachi CP-A300N - page 12

    12 Adjusting the projector's eleva tor The projector has Front foot for inclinations and Rear foot for horizontals. Spacers on the each elevator foot are installed at the time of shipment, and projector is in a condition to be able to just project. If necessary , detach the spacer , and the elevator feet can be manually twisted to make more pr ...

  • Hitachi CP-A300N - page 13

    13 ENGLISH F ocusing Use the FOCUS + and FOCUS – buttons on the projector or remote control to adjust the screen focus. Selecting an aspect ratio Each time you press the ASPECT button on the remote control, it switches the aspect ratio of the image, in turn. Zooming Use the D-ZOOM + and D-ZOOM – buttons on the remote control to adjust the scree ...

  • Hitachi CP-A300N - page 14

    14 T ur ning of f the power 1. Press the ST ANDBY/ON button on the projector or the remote control. The message “Power off?” will appear on the screen for about 5 seconds. 2. Conrm that there is nothing that the lens door hits while closing. Press the ST ANDBY/ON button again while the message appears. The projector lamp will go off, and the ...

  • Hitachi CP-A300N - page 15

    15 ENGLISH R eplacing the lamp A lamp has nite product life. Using the lamp for long periods of time could cause the pictures darker or the color tone poor . Note that each lamp has a different lifetime, and some may burst or burn out soon after you start using them. Preparation of a new lamp and early replacement are recommended. T o prepare a ...

  • Hitachi CP-A300N - page 16

    16 HIGH VOL T AGE HIGH TEMPERA TURE HIGH PRESSURE WARNING ► The projector uses a high-pressure mercury glass lamp. The lamp can break with a loud bang, or burn out, if jolted or scratched, handled while hot, or worn over time. Note that each lamp has a different lifetime, and some may burst or burn out soon after you start using them. In addition ...

  • Hitachi CP-A300N - page 17

    17 ENGLISH The air lter has two kinds of lters inside. Please check and clean the air lter periodically . When the indicators or a message prompts you to clean the air lter , comply with it as soon as possible. If the lters are damaged or heavily soiled, replace them with the new ones. T o prepare the new lters, make contact with ...

  • Hitachi CP-A300N - page 18

    18 1. T urn the projector off, and unplug the power cord. Allow the projector to cool sufciently . 2. After making sure that the projector has cooled adequately , slowly turn over the projector , so that the bottom is facing. 3. Turn the battery cover fully in the direction indicated “OPEN” using a coin or the like, and pick the cover up to ...

  • Hitachi CP-A300N - page 19

    19 ENGLISH Caring for the mir ror and lens If the projection mirror or lens is awed, soiled or fogged, it could cause deterioration of display quality . Please take care of the mirror and lens, being cautious of handling. 1. T urn the projector off and unplug the power cord from the power outlet. And cool the projector down by leaving it for a w ...

  • Hitachi CP-A300N - page 20

    20 Using the CD manual The other manuals for this product are written into the included CD-ROM titled “User ’s Manual (detailed)”. Before using the CD-ROM, please read the following to ensure the proper use. System requir ements The system for using the CD-ROM requires the following. Windows ® : OS:Microsoft ® Windows ® 98, Windows ® 98SE ...

  • Hitachi CP-A300N - page 21

    21 ENGLISH 345 303 94 124 85 72 130 308 119 192 Item Specication Product name Liquid crystal projector Liquid Crystal Panel 786,432 pixels (1024 horizontal x 768 vertical) Lamp 210W UHP Speaker 10W Power supply AC 100-120V/ 3.1A , AC 220-240V /1.6A Power consumption AC 100-120V:310 W , AC 220-240V :300W T emperature range 5 ~ 35°C (Operating) S ...

  • Hitachi CP-A300N - page 22

    22 T roubleshooting - War r anty and after-ser vice If an abnormal operation (such as smoke, strange odor or excessive sound) should occur , stop using the projector immediately . Otherwise if a problem occurs with the projector , rst refer to “T roubleshooting” of “Operating Guide” and “Network Guide”, and run through the suggested ...

メーカー Hitachi カテゴリー Projector

Hitachi CP-A300Nのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- CP-A300Nの取扱説明書
- Hitachiの製品カード
- パンフレット
- またはHitachi CP-A300Nの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Hitachi CP-A300Nの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Hitachi CP-A300Nの取り付け説明書、サービスマニュアル、簡易説明書、またはHitachi CP-A300Nのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Hitachi CP-A300Nの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Hitachi CP-A300Nデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがHitachi CP-A300Nを使用するのを助ける技術的文書のことです。説明書は通常、全てのHitachi CP-A300Nユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Hitachiの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Hitachi CP-A300Nの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははHitachi CP-A300Nの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Hitachi CP-A300Nに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Hitachi CP-A300Nデバイスの基本機能を使うにあたってのヒント。 Hitachi CP-A300Nのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Hitachi CP-A300Nに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるHitachi CP-A300Nのメーカー/サービスへの連絡先に関する情報。

Hitachi CP-A300Nについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもHitachi CP-A300Nの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがHitachi CP-A300Nで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)