Garmin TR-1の取扱説明書

13ページ 1.13 mb
ダウンロード

ページに移動 of 13

Summary
  • Garmin TR-1 - page 1

    TR-1 Gladiator LCD Heading Display Installation & Operations Owner ’ s Manual 1-800-588-7655 www .nautamatic.com 906-2700-00 V ersion 03 ...

  • Garmin TR-1 - page 2

    TR-1 Gladiator LCD Heading Display Installation and User Guide Introduction: The TR-1 LCD display connects to the TR-1 Gladiator Autopilot. It displays current heading, and displays the current autopilot mode. In addition it allows the operator to command a new desired heading or command a rate of turn. W ith an optional rudder reference indicator; ...

  • Garmin TR-1 - page 3

    Y ou are responsible for the safe and prudent operation of your vessel. Y our TR-1 Autopilot is a tool that will enhance your capability to operate your boat and catch sh. It does not r elieve you fr om the r esponsibility for safe operation of your vessel. Y ou must avoid hazards to navigation and never leave the helm unattended. • Y ou must ...

  • Garmin TR-1 - page 4

    Installation of Basic LCD Display Installation Overview: • Figure out where on your dash you want to mount the display , or optional mounting panel. Be sure to allow plenty of room in the back of the display for mounting accessibility . • Y ou will need good visibility and convenient reach of the display . • Cut a 3-3/4” hole in the desired ...

  • Garmin TR-1 - page 5

    Mounting the Display Unit Page 4 Y ou will want to decide where to mount the display unit. Mount the display in a place where you have good visibility and a convenient reach to the dial. (The outside diameter is 4” and 4-1/2” with the trim ring.) Using template (A) provided, you have two options for mounting the Standard display unit: T ype I T ...

  • Garmin TR-1 - page 6

    Page 5 Connection to Optional rudder indicator unit. Red= ( + ) Positive Black= (- ) Signal Silver= (Grnd) Connecting the Display W iring T o Optional Rudder Indicator Connects to the autopilot’ s handheld Connects to the ECU’ s Connection # 3 ...

  • Garmin TR-1 - page 7

    Connecting the Display W ith W ireless Remote Page 6 Connects to the ECU’ s Connection # 3 Connects to the autopilot’ s handheld Connects to the autopilot’ s handheld Connects to the ECU’ s Connection # 3 Display Display W ireless Receiver W ireless Receiver Option 1 Option 2 ...

  • Garmin TR-1 - page 8

    Operating the Display Backlit For Easy Night V ision Shows Current Heading Steer to a new Desired Heading Directional Input Dial Steering Mode Rudder Angle or T urn Rate Indicator The heading display displays the current heading of the vessel. The compass must be calibrated and north set for this display to be correct. Please see your Gladiator ’ ...

  • Garmin TR-1 - page 9

    Display Elements: The Three large digits on the display show the current heading in degrees. (See Figure 10) If the autopilot is in calibration mode, (Autotune, Compass Calibration, or rudder calibration) the three digits will display “CAL”. The Three smaller digits display a horizontal bar (See Figure 12) if the heading command mode is availab ...

  • Garmin TR-1 - page 10

    Heading Command Display The heading command display will be blank if the heading command function is unavailable. See Figure 16. The heading command is available whenever the autopilot is in heading hold (AUT O) and the display turn rate command is inactive. It will display a single horizontal bar until the operator enters a heading command by turn ...

  • Garmin TR-1 - page 11

    Rate of T urn Command Dial The turn rate command is activated by a single press of the directional control dial. A single centered vertical bar will indicate the mode is active. See Figure 18 Figure 18 The “Rate of T urn Command Dial” on the display controls the boat somewhat like your steering wheel at the helm. T urning the dial either clockw ...

  • Garmin TR-1 - page 12

    Rudder Position Display The rudder position display is optional. If you wish to use this portion of the display , you will need to purchase an aftermarket transducer unit. The rudder position display is activated by a mode selection from the handheld on the autopilot. A rudder position transducer must be installed and calibrated before this mode wi ...

  • Garmin TR-1 - page 13

    to illuminate the 5 LED, and pressing and releasing the [Right Chevron Button] Three (3) times to illuminate the 9 LED. 3. Press the [up arrow] button on the handheld remote, the up arrow LED will light and the display will indicate CAL. 4. Using the steering wheel at the helm, turn the rudder all the way to starboard. 5. Using the steering wheel a ...

メーカー Garmin カテゴリー Computer Monitor

Garmin TR-1のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- TR-1の取扱説明書
- Garminの製品カード
- パンフレット
- またはGarmin TR-1の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Garmin TR-1の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Garmin TR-1の取り付け説明書、サービスマニュアル、簡易説明書、またはGarmin TR-1のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Garmin TR-1の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Garmin TR-1デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがGarmin TR-1を使用するのを助ける技術的文書のことです。説明書は通常、全てのGarmin TR-1ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Garminの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Garmin TR-1の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははGarmin TR-1の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Garmin TR-1に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Garmin TR-1デバイスの基本機能を使うにあたってのヒント。 Garmin TR-1のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Garmin TR-1に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるGarmin TR-1のメーカー/サービスへの連絡先に関する情報。

Garmin TR-1についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもGarmin TR-1の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがGarmin TR-1で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)