-
True Manufacturing Company TCGD-50 - page 1
............ www .truemfg.com ............ INST ALLA TION MANUAL FOR TCGD DISPLA Y CASES (DR Y BAKER Y) MODELS CUR VED GLASS DISPLA Y CASES - DR Y BAKER Y - CONGRA TULA TIONS! Y ou have just purchased the finest display case available. Y ou can expect many years of trouble-free operation. TCGD-77 TCGD-50 TRUE FOOD SERVICE EQUIPMENT , INC. 2001 East ...
-
True Manufacturing Company TCGD-50 - page 2
...
-
True Manufacturing Company TCGD-50 - page 3
............ www .truemfg.com ............ T rue Food Service Equipment, Inc. 1 1 SAFETY INFORMA TION • This display case must be pr operly installed and located in accordance with the Installation Instructions before it is used. • Do not allow childr en to climb, stand or hang on the shelves in the displa y case. The y could dam- age the cabin ...
-
True Manufacturing Company TCGD-50 - page 4
............ www .truemfg.com ............ T rue Food Service Equipment, Inc. 2 2 SAFETY INFORMA TION PROPER DISPOSAL OF THE DISPLA Y CASE DANGER! RISK OF CHILD ENTRAPMENT USE OF EXTENSION CORDS NEVER USE AN EXTENSION CORD! TRUE will not warranty any display case that has been connected to an extension cord (applies to cabinets ordered with optiona ...
-
True Manufacturing Company TCGD-50 - page 5
............ www .truemfg.com ............ T rue Food Service Equipment, Inc. 3 3 Bef ore your ne w display case is connected to a power suppl y , chec k the incoming voltag e with a voltmeter . If anything less than 100% of the rated voltag e f or operation is noted, correct immediately . Have the cir cuit chec ked by a qualified electr ician to m ...
-
True Manufacturing Company TCGD-50 - page 6
............ www .truemfg.com ............ T rue Food Service Equipment, Inc. 4 4 INST ALLA TION / OPERA TION INSTRUCTIONS T o insure that your unit wor ks properl y from the first day , it must be installed properly . W e highly recommend a trained mec hanic and electrician install your T r ue equipment. The cost of a profes- sional installation i ...
-
True Manufacturing Company TCGD-50 - page 7
............ www .truemfg.com ............ T rue Food Service Equipment, Inc. 5 5 INST ALLA TION / OPERA TION INSTRUCTIONS TOOLS REQUIRED: • Phillips screw driver • 3 / 8 ” (9.5 mm) socket or 3 / 8 ” (9.5 mm) wrench Step 2 A. Use a Phillips screw diver and r emove f our screws fr om the L-bracket connected the unit to the wood skid (imag e ...
-
True Manufacturing Company TCGD-50 - page 8
............ www .truemfg.com ............ T rue Food Service Equipment, Inc. 6 6 INST ALLA TION / OPERA TION INSTRUCTIONS Step 4 NOTE Hard wiring is required on standard "Dry" Baker y Cases. NOTE Optional 12" (30.5 cm) corded model available, fac- tory installed only . (exterior scale receptacle will not be included with this option ...
-
True Manufacturing Company TCGD-50 - page 9
............ www .truemfg.com ............ T rue Food Service Equipment, Inc. 7 7 INST ALLA TION / OPERA TION INSTRUCTIONS CONDUCTORS AND CIRCUITS Wire Guage for 2% V oltage Drop in Supply Circuits. 115 Volt Distance In Feet T o Center of Load Amps 20 30 40 50 60 70 80 90 100 120 140 160 2 14 14 14 14 14 14 14 14 14 14 14 14 3 14 14 14 14 14 14 14 ...
-
True Manufacturing Company TCGD-50 - page 10
............ www .truemfg.com ............ T rue Food Service Equipment, Inc. 8 8 INST ALLA TION / OPERA TION INSTRUCTIONS SHEL VING INST ALLA TION ("DRY" BAKERY) SHELF INST ALLA TION: A. Lift each door up and out of track (do not dis- connect elastic tubing). Stretch elastic surgical tubing and set doors on each side of unit. B. Locate b ...
-
True Manufacturing Company TCGD-50 - page 11
............ www .truemfg.com ............ T rue Food Service Equipment, Inc. 9 9 INST ALLA TION / OPERA TION INSTRUCTIONS CASTOR INST ALLA TION: TOOLS REQUIRED: • Castor wrenc h (if not included contact T rue) • Adjustable wrenc h NOTE Castors not available for hard wired models. WARNING Make sure unit is empty of all its contents (shelv- ing, ...
-
True Manufacturing Company TCGD-50 - page 12
............ www .truemfg.com ............ T rue Food Service Equipment, Inc. 10 10 INST ALLA TION / OPERA TION INSTRUCTIONS FORMICA KIT INST ALLA TION: FORMICA KIT COMPONENTS: (2) F or mica T op End Panels 10 3 / 4 "w x 33"h (27.3 cm x 83.8 cm). (2) Bottom End P anels (1) left side, (1) r ight side (F or mica glued to black plastic panel ...
-
True Manufacturing Company TCGD-50 - page 13
............ www .truemfg.com ............ T rue Food Service Equipment, Inc. 11 11 MAINTENANCE, CARE & CLEANING • The e xterior may be wiped clean with mild soap and water . Use a g ood stainless cleaner on coun- tertop. CAUTION: Do not use any steel wool, abrasive or chlorine based products to clean stainless steel sur - faces. • The inte ...
-
True Manufacturing Company TCGD-50 - page 14
............ www .truemfg.com ............ T rue Food Service Equipment, Inc. 12 12 MAINTENANCE, CARE & CLEANING LIGHT BULB REPLACEMENT SHELF MOUNTED BULB REPLACEMENT : WARNING When replacing a light bulb make sure power to the unit is either turned off or unplugged. A. Unplug the light assembly from the receptac le on the interior side wall. R ...
-
True Manufacturing Company TCGD-50 - page 15
............ www .truemfg.com ............ T rue Food Service Equipment, Inc. 13 13 W ARRANTY INFORMA TION (U.S.A. and Canada ONL Y!) note: warranty information regarding refrigeration components not applicable to non-refrigerated cabinets. ONE YEAR P ARTS & LABOR W ARRANTY TRUE warrants to the original purchaser of every new TRUE refrigerated ...
True Manufacturing Company TCGD-50についてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもTrue Manufacturing Company TCGD-50の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがTrue Manufacturing Company TCGD-50で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。