Mitsubishi Electronics 100の取扱説明書

20ページ 1.27 mb
ダウンロード

ページに移動 of 20

Summary
  • Mitsubishi Electronics 100 - page 1

    Air-Conditioners PEAD-RP71, 100, 125, 140JAA English OPERA TION MANUAL For safe and correct use, please read this oper ation manual thoroughly before opera t ing the air-conditioner unit. FOR USER English KD79D904H01_Cover.fm Page 1 Friday, October 14, 2011 9:58 AM ...

  • Mitsubishi Electronics 100 - page 2

    2 Contents s Before operating the unit, make sure you read all the “Safety precautions”. s “Safety precautions” lists important points about safety . Please be sure to follow them. Symbols used in the text W arning: Describes precautions that should be observed to avoid the risk of injury or death to the user . Caution: Describes precaution ...

  • Mitsubishi Electronics 100 - page 3

    3 2. Parts Names ■ Indoor Unit PEAD-RP · JAA Fan steps 3 steps V ane – Louver – Filter Normal Filter cleaning indication – 1.2. During operation Caution: • Do not use any sharp object to push the buttons, as this may damage the remote controller . • Do not twist or tug on the remote controller cord as this may damage the remote control ...

  • Mitsubishi Electronics 100 - page 4

    4 ■ Wired Remote-Controller (P AR-21MAA option) Display Section For purposes of this explanation, all parts of the display are shown as lit. During actual operation, only the relevant items will be lit. ˚ F ˚ C ˚ F ˚ C ERROR CODE AFTER TIMER TIME SUN MON TUE WED THU FRI SAT ON OFF Hr AFTER FILTER FUNCTION ONLY1Hr. WEEKLY SIMPLE AUTO OFF Ident ...

  • Mitsubishi Electronics 100 - page 5

    5 1 2 3 ■ Wireless Remote-Controller (option) 2. Parts Names ■ When using the wireless remote controller , point it towards the receiver on the indoor unit. ■ If the remote controller is operated within approximately two minutes after power is supplied to the indoor unit, the indoor unit may beep twice as the unit is performing the initial au ...

  • Mitsubishi Electronics 100 - page 6

    6 AAA AAA CLOCK CHECK RESET SET TEST RUN MODE FAN VANE LOUVER min h AUTO START AUTO STOP ON/OFF TEMP 1 2 5 6 3 3 5 6 2 Note: The day and time will not appear if clock use has been disabled at Function Selection of remote controller . 3. Screen Configuration <Screen T ypes> For details on setting the language for the remote controller display ...

  • Mitsubishi Electronics 100 - page 7

    7 ■ Because the room temperature is automatically adjusted in order to maintain a fixed effective temperature, cooling operation is performed a few degrees warmer and heating operation is performed a few degrees cooler than the set room temperature once the temperature is reached (automatic energy-saving operation). 5.3. T emperature setting s s ...

  • Mitsubishi Electronics 100 - page 8

    8 5. Operation 6.1. For Wired Remote-controller (option) Y ou can use Function Selection of remote controller to select which of three types of timer to use: 1 Weekly timer , 2 Simple timer , or 3 Auto Off timer . 6.1.1. Weekly T imer ■ The weekly timer can be used to set up to eight operations for each day of the week. • Each operation may con ...

  • Mitsubishi Electronics 100 - page 9

    9 6. T imer 6.1.2. Simple Timer ■ You can set the simple timer in any of three ways. • Start time only: The air conditioner starts when the set time has elapsed. • Stop time only: The air conditioner stops when the set time has elapsed. • Start & stop times: The air conditioner starts and stops at the respective elapsed times. ■ The s ...

  • Mitsubishi Electronics 100 - page 10

    10 6. T imer 7. After completing steps 3 to 6 above, press the Filter button 4 to lock in the value. Note: Y our new settings will be cancelled if you press the Mode (Return) button 2 before pressing the Filter button 4 . 8. Press the Mode (Return) button 2 to return to the standard control screen. 9. Press the Timer On/Off button 9 to start the ti ...

  • Mitsubishi Electronics 100 - page 11

    11 AAA AAA CLOCK CHECK RESET SET TEST RUN MODE FAN VANE LOUVER min h AUTO START AUTO STOP ON/OFF TEMP 13 2 D A C B 6. Timer <Checking the Current Auto Off Timer Setting> 1. Be sure that the “ Auto Off ” is visible on the screen (at 1 ). 2. Hold down the Timer Menu button B for 3 seconds , so that “ Monitor ” is indicated on the screen ...

  • Mitsubishi Electronics 100 - page 12

    12 7. Other Functions ON/OFF ERROR CODE If you have entered contact number to be called in the event of a prob- lem, the screen displays this number . (Y ou can set this up under Func- tion Selection of remote controller . For information, refer to section 8.) Indoor Unit ’ s Refrigerant Address Error Code Indoor Unit No. Alternating Display ON/O ...

  • Mitsubishi Electronics 100 - page 13

    13 8. Function Selection [Function selection flowchart] Setting language (English) OFF on1 on2 OFF ON OFF ON OFF OFF CALL- ON OFF ON OFF ° C ° F PAR-21MAA ON/OFF FILTER CHECK OPERATION CLEAR TEST TEMP. MENU BACK DAY MONITOR/SET CLOCK ON/OFF F E G C D H B A I G G G G G G E E G G G G G E G E G G G G G G D D D D D D D D D D D D D D D D D D D D D D D ...

  • Mitsubishi Electronics 100 - page 14

    14 8. Function Selection [Detailed setting] [4] – 1. CHANGE LANGUAGE setting The language that appears on the dot display can be selected. • Press the [[ MENU] button G to change the language. 1 English (GB), 2 German (D), 3 Spanish (E), 4 Russian (RU), 5 Italian (I), 6 Chinese (CH), 7 French (F), 8 Japanese (JP) Refer to the dot display table. ...

  • Mitsubishi Electronics 100 - page 15

    15 8. Function Selection [Dot display table] W aiting for start-up Operation mode Cool Dry Heat Auto Auto(Cool) Auto(Heat) Fan V entilation Stand by (Hot adjust) Defrost Set temperature Fan speed Not use button Check (Error) T est run Self check Unit function selection Setting of ventilation Selecting language English Germany Spanish Russian Italy ...

  • Mitsubishi Electronics 100 - page 16

    16 s s s s s Cleaning the filters • Clean the filters using a vacuum cleaner . If you do not have a vacuum cleaner , tap the filters against a solid object to knock off dirt and dust. • If the filters are especially dirty , wash them in lukewarm water . T ake care to rinse off any detergent thoroughly and allow the filters to dry com- pletely b ...

  • Mitsubishi Electronics 100 - page 17

    17 1 1. T rouble Shooting Having trouble? Air conditioner does not heat or cool well. When heating operation starts, warm air does not blow from the indoor unit soon. During heating mode, the air conditioner stops before the set room tem- perature is reached. When the airflow direction is changed, the vanes always move up and down past the set posi ...

  • Mitsubishi Electronics 100 - page 18

    18 1 1. T rouble Shooting Having trouble? Here is the solution. (Unit is operating normally .) Noise is louder than specifications. Nothing appears in the wireless remote controller display , the display is faint, or signals are not received by the indoor unit unless the remote con- troller is close. The operation lamp near the receiver for the wir ...

  • Mitsubishi Electronics 100 - page 19

    19 KB79U748H01_EN.pm65 2011.10.18, 11:54 AM 19 ...

  • Mitsubishi Electronics 100 - page 20

    KD79D904H01 Please be sure to put the cont act address/telephone number on this manual before handing it to the customer . HEAD OFFICE : TOKYO BLDG ., 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAP AN KD79D904H01_Backcove r.fm Page 24 Fr iday, October 14, 2011 9:47 AM ...

メーカー Mitsubishi Electronics カテゴリー Air Conditioner

Mitsubishi Electronics 100のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 100の取扱説明書
- Mitsubishi Electronicsの製品カード
- パンフレット
- またはMitsubishi Electronics 100の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Mitsubishi Electronics 100の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Mitsubishi Electronics 100の取り付け説明書、サービスマニュアル、簡易説明書、またはMitsubishi Electronics 100のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Mitsubishi Electronics 100の製品を使用するにあたって最も人気のある説明書を閲覧できます。

Mitsubishi Electronics 100デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがMitsubishi Electronics 100を使用するのを助ける技術的文書のことです。説明書は通常、全てのMitsubishi Electronics 100ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Mitsubishi Electronicsの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Mitsubishi Electronics 100の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははMitsubishi Electronics 100の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Mitsubishi Electronics 100に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Mitsubishi Electronics 100デバイスの基本機能を使うにあたってのヒント。 Mitsubishi Electronics 100のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Mitsubishi Electronics 100に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるMitsubishi Electronics 100のメーカー/サービスへの連絡先に関する情報。

Mitsubishi Electronics 100についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもMitsubishi Electronics 100の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがMitsubishi Electronics 100で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)