EverFocus EHD300の取扱説明書

13ページ 0.33 mb
ダウンロード

ページに移動 of 13

Summary
  • EverFocus EHD300 - page 1

    EVERFOCUS 1/3” Color Rugged Dome Camera Operation Instructions Model No. EHD300 Please read this manual first for correct installa tion and operation. This m anual should be retained for future reference. The information in th is manual was curren t when published. The manufacturer reserves the righ t to revise and improve its products. All speci ...

  • EverFocus EHD300 - page 2

    6. Do not operate the camera beyond the specified temperatur e, humidity or power sour ce ratings. Use the camera at temperatures with in –10 ℃ ~ 50 ℃ /14 ℉ ~ 122℉ and humidity between 20%~ 80%. The input power source is 12VDC/24V AC. PREF ACE The most technically advanced EHD series are the newest vandal-resistant Color Rugged Dome Camer ...

  • EverFocus EHD300 - page 3

    INST ALLA TION 1. Loosen the 4 fix screws on the housing cover by using the attached wrench (Figure 1). Please pay attention not to damage the lens. Figure 1 2. Remove the camera. V ari-Focal Lens Locking Screws Figure 2 T o remove the camera, first unplug the wire connection on the back of the cam era. Then loosen the 2 locking screws on the camer ...

  • EverFocus EHD300 - page 4

    3. Mounting the base. Attach the base to the wall or ceiling , fix the base by the 4 setscrews attached in the accessory pack. Please make sure if the m ounting is strength ened enough to support it, if not, please reinforce the mounting according to the environm ent. Side conduit entry Note : The diameter of the screw hole is ψ 4.7mm. Conduit plu ...

  • EverFocus EHD300 - page 5

    Back conduit entry (PF1/2) Conduit plug The camera comes with a conduit plug pre-installed in the PF 1/2 conduit entry on the side. The screw can be rem oved and installed in the back conduit entry . Loosen the conduit plug setscrew (as shown in Figure 4) before removing the conduit plug. Side conduit entry (PF1/2) Figure 4 Caution: T o prevent moi ...

  • EverFocus EHD300 - page 6

    Micro Switch for Alarm trigger V ideo Alarm COM GND Alarm NO Power In (+) Power In (-) Alarm NC V . Phase Adjustment VR Figure 5 Connect the power supply cable (12 VDC/24V AC), video output and alarm output to the proper connect ors shown as Figure 5. The V. Phase adjustment screw is located on the termination board. The vertical phase may require ...

  • EverFocus EHD300 - page 7

    60 ° Lens fixing Screws 360 ° 140 ° Figure 6 6 ...

  • EverFocus EHD300 - page 8

    DIP SWI TCH FUNCTION V ari-Focal Lens FL (Flickerless Functio n) ON/OFF When picture flicker fiercely , turn FL on, th en the camera will stabilize the speed of electronic shutter at 1/100(NTSC) or 1/120(P AL) automa tically , and reduce the flicker immediately . The default setting is OFF . Mirror ON/OFF Mirror ON: Set a horizontal image inversion ...

  • EverFocus EHD300 - page 9

    D/N OFF: Camera stays in color mode. Note: when AGC setting is OFF , then D/N function will be inactive. The default setting is OFF . IRIS Level Adjustment Brightness Level can be adjust ed from the IRIS level VR.  T urn counterclockwise to L to get darker picture.  T urn clockwise to H to get brighter picture. 8 ...

  • EverFocus EHD300 - page 10

    SIMPLE INSTRUCTIONS FOR THE DESICCANT P ACK Due to the camera lens blurred from the hum idity inside the camera. The desiccant pack absorbs the humidity; p lease refer to the easy instruction as follows: 1. Adjust all settings first and pl ace the desiccant pack on the ho rizontal rod, then bend the horizontal rod and fix it. 2. Install the outer c ...

  • EverFocus EHD300 - page 11

    SPEC IFICA TIONS Pickup Device 1/3'' SONY Super HAD CCD Video Format NTSC or PAL NTSC: 525 TV lines, 60 fields/sec. Scanning System PAL: 625 TV lines, 50 fields/sec. Picture Elements 768 x 494(NTSC) ; 752 x 582(PAL) Horizontal Resolution 520TVL Sensitivity 0.4Lux/F=1.2 S/N Ratio Over 48dB (AGC off) Electronic Shutter 1/50(1/60)~1/100,000 ...

  • EverFocus EHD300 - page 12

    CONTENT LIST S tandard Accessories 1. Camera Unit 2. Operation Instruction (this document) 3. Accessory Pack 4. W aterproof Connector 5. Power & V ideo Cable Optional Accessory 1. W all Mount Bracket (BA-EHD) 11 ...

  • EverFocus EHD300 - page 13

    EverFocus Electr onics Corp. Headquarter Office 12F , No.79 Sec.1 Shin-T ai Wu Road, Hsi-Chi, T aipei, T aiwan T e l: +886-2-26982334 Fax: +886-2-26982380 Beijing office Room 609,T echnology T rade Building. Shangdi Information Industry Base, Haidian District,Beijing Chi na T e l: +86-10-62971096 Fax: +86-10-62971423 European Office Albert-Einstein ...

メーカー EverFocus カテゴリー Security Camera

EverFocus EHD300のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- EHD300の取扱説明書
- EverFocusの製品カード
- パンフレット
- またはEverFocus EHD300の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、EverFocus EHD300の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、EverFocus EHD300の取り付け説明書、サービスマニュアル、簡易説明書、またはEverFocus EHD300のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、EverFocus EHD300の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

EverFocus EHD300デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがEverFocus EHD300を使用するのを助ける技術的文書のことです。説明書は通常、全てのEverFocus EHD300ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

EverFocusの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. EverFocus EHD300の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははEverFocus EHD300の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。EverFocus EHD300に関してこのドキュメントで見つけることができる全てのヒントの目次
3. EverFocus EHD300デバイスの基本機能を使うにあたってのヒント。 EverFocus EHD300のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。EverFocus EHD300に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるEverFocus EHD300のメーカー/サービスへの連絡先に関する情報。

EverFocus EHD300についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもEverFocus EHD300の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがEverFocus EHD300で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)