-
Dual MXD40 - page 1
INSTALLATION/OWNERS MANUAL AM/FM/CD Marine Receiver with Detach Face MXD40 MARINE ...
-
Dual MXD40 - page 2
2 MXD40 INSTALLATION Preparation Please read entir e manual before installation. Before You Start • Disconnect negative battery terminal. (consult a qualified technician for instr uctions) • A void installing the unit where it would be subject to high temper atures, such as fr om direct sunlight, or wher e it would be subject to dust, dirt or e ...
-
Dual MXD40 - page 3
AMP Remote Turn-On Connect to amplifier or power antenna. Insulate wire if not used. RCA Cable (sold separately) BLUE Antenna Connector Rear Preamp Output Connect to amplifier RCA Input GRAY Ground Connect to chassis ground. BLACK Accessory Connect to existing ignition circuit or switched 12 volt source. RED Right Front Gray/Black (-) Gray (+) Left ...
-
Dual MXD40 - page 4
4 MXD40 OPERATION Control Locations Release V olume T une/T rack Up Band Bass Boost Eject Display Play/Pause Auto Stor e/Preset Scan 1 2 3 4 5 6 7 8 9 Preset 6 Preset 5 Preset 4/CD Random Preset 3/CD Repeat Preset 2/CD Intr o Preset 1/CD T op Audio Power T une/T rack Down 10 11 12 13 14 15 16 17 18 17 16 15 14 13 12 11 10 9 8 7 1 2 3 4 5 6 18 The M ...
-
Dual MXD40 - page 5
General Operation 5 MXD40 OPERATION Press REL and pull away from the left side to r emove. T o re-install, insert right side of faceplate first then push left side to secure. *For semi-permanent faceplate installation, remov e trim ring and install supplied Phillips head #1 screw through left side of mounting fr ame into faceplate. Press PWR to tur ...
-
Dual MXD40 - page 6
6 MXD40 OPERATION General Operation Press and hold for mor e than 2 seconds to RESET the unit upon initial installation. The RESET button is located behind the faceplate. Press AUD to select between V olume (default), Bass, T reble, Balance & Fader . Press AUD until BA appears Press VOL ▼ or ▲ to adjust (6 maximum / -6 minimum) Press AUD un ...
-
Dual MXD40 - page 7
7 MXD40 OPERATION Tuner Operation Press TUNE or momentarily to seek the next strong station. Press TUNE or for more than 2 seconds, then press TUNE or momentarily to move radio frequency up or down one step at a time. Pr ess and hold to advance quickly . If tuning is not adjusted for 2 seconds, the unit will retur n to seek tuning mode (default). P ...
-
Dual MXD40 - page 8
8 MXD40 OPERATION CD Player Operation With the label facing up, insert a standard 5" CD into the CD slot. The CD will automatically begin playback. Press the EJECT button to stop and eject the CD. T he unit will change to tuner mode. Press TR ACK to skip to the beginning of the next track. Press TR ACK to retur n to the beginning of the curren ...
-
Dual MXD40 - page 9
9 MXD40 WARRANTY Limited One-Year Warranty This warr anty gives you specific legal rights. Y ou may also have other rights which vary fr om state to state. Namsung America Inc. warrants this pr oduct to the original purchaser to be fr ee from defects in material and workmanship, under normal conditions, for a period of one year from the date of the ...
-
Dual MXD40 - page 10
10 MXD40 OPERATION Specifications Signal-to-noise: >86dB Fr equency response: 20Hz-20kHz, ±3dB Channel separation @ 1kHz: >65dB D/A converter: 16 Bit T uning range: 87.5MHz-107.9MHz FM mono sensitivity: 12dBf 50dB quieting sensitivity (stereo): 16dBf Stereo separ ation @ 1kHz: 40dB Fr equency response: 30Hz-13kHz, ±3dB T uning range: 530kHz ...
-
Dual MXD40 - page 11
MXD40 OPERATION Troubleshooting 11 Problem Cause Action Y ellow wire not connected or incorrect voltage Red wire not connected or incorrect voltage Check connections for proper voltage (11~16VDC) Black wire not connected Check connection to ground Fuse blown Replace fuse Speaker wires not connected Check connections at speakers One or more speaker ...
-
Dual MXD40 - page 12
Namsung America Inc. 21318 64th Ave. South Kent, W A 98032 T oll Fr ee: 1-866-626-7863 ©2003 Namsung America, Inc. EVOK0603-V01 ...
-
Dual MXD40 - page 13
INSTALLATION/OWNERS MANUAL 6.5" Dual Cone Marine Speakers DMP65 MARINE ...
-
Dual MXD40 - page 14
2 DMP65 INSTALLATION Preparation/Installation Please read entir e manual before installation. Before You Start • Disconnect negative battery terminal. (consult a qualified technician for instructions) • Use extreme caution when drilling holes to avoid damaging fuel lines, hydraulic lines or existing wiring. Getting Started • Determine where t ...
-
Dual MXD40 - page 15
3 DMP65 WARRANTY Limited One-Year Warranty T his warr anty gives you specific legal rights. Y ou may also have other rights which vary from state to state. Namsung America Inc. warrants this pr oduct to the original purchaser to be fr ee from defects in material and workmanship, under normal conditions, for a period of one year from the date of the ...
-
Dual MXD40 - page 16
7.13" 2.5" .88" 5.13" 45Hz-18kHz, ±3dB 90dB 1W/1M 4 ohms 20 W atts 60 W atts Specifications subject to change without notice Outside Diameter Mounting Depth Mounting Height Cut-out Diameter Frequency Response Sensitivity Impedance RMS Power Peak Power Namsung America Inc. 21318 64th Ave. South Kent, W A 98032 T oll Free: 1-866- ...
Dual MXD40についてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもDual MXD40の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがDual MXD40で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。