Brinkmann Sl 7の取扱説明書

12ページ 0.71 mb
ダウンロード

ページに移動 of 12

Summary
  • Brinkmann Sl 7 - page 1

    R 140-6007-0 2/96 MODEL SL-7 OWNER’S MANUAL ASSEMBL Y AND OPERA TING INSTRUCTIONS INSTR-SM SL-7.q 4/22/02 11:29 AM Page 1 ...

  • Brinkmann Sl 7 - page 2

    1 The Home Security Motion Activated Lighting System is designed to turn on automatically at night when a person enters the detection zone. The light will stay on as long as the motion detector senses motion in the zone. The light will turn off in approximately 90 sec- onds after the person leaves the detection zone or stops moving. During the day ...

  • Brinkmann Sl 7 - page 3

    2 ASSEMBL Y INSTRUCTIONS Inspect contents of the box to ensure all parts are included and undamaged. A Phillips screwdriver will be required. 1 P ARTS LIST : Home Security Main Housing Main Housing Mounting Screws (2) Solar Panel Module with Cord Solar Panel Module Mounting Screws (3) SL-7 Owner’ s Manual 2 3 4 5 3 4 Step 1 Select a location and ...

  • Brinkmann Sl 7 - page 4

    3 8 Step 3 Slide the two slots in the back of main housing onto the screws. Step 4 Select a location within 15 feet from the main housing to mount the solar panel module. The solar panel module must be mounted where it will receive full, direct sunlight for several hours each day . Step 5 Firmly plug the solar panel module cord into the main housin ...

  • Brinkmann Sl 7 - page 5

    4 7 Step 8 Point the two floodlights in the desired direction. Y ou may want to adjust the floodlights after letting the unit operate for a few nights. Step 9 Position the detector head in the direction you want to cover . Never aim the motion detector head directly at the sun or above a 90° angle (horizon- tal level). Do not rotate the head more ...

  • Brinkmann Sl 7 - page 6

    T erminal Wire Connector Changing Batteries 1. Unscrew the four screws in front housing and separate it from rear housing. 2. Carefully peel the tape off the battery , leaving wires attached to tape. 3. Remove the battery from rear housing, being careful not to pull on wires. 4. Disconnect wires from battery terminals and remove battery . 5. Connec ...

  • Brinkmann Sl 7 - page 7

    T erminal Wire Connector Changing Batteries 1. Unscrew the four screws in front housing and separate it from rear housing. 2. Carefully peel the tape off the battery , leaving wires attached to tape. 3. Remove the battery from rear housing, being careful not to pull on wires. 4. Disconnect wires from battery terminals and remove battery . 5. Connec ...

  • Brinkmann Sl 7 - page 8

    4 7 Step 8 Point the two floodlights in the desired direction. Y ou may want to adjust the floodlights after letting the unit operate for a few nights. Step 9 Position the detector head in the direction you want to cover . Never aim the motion detector head directly at the sun or above a 90° angle (horizon- tal level). Do not rotate the head more ...

  • Brinkmann Sl 7 - page 9

    3 8 Step 3 Slide the two slots in the back of main housing onto the screws. Step 4 Select a location within 15 feet from the main housing to mount the solar panel module. The solar panel module must be mounted where it will receive full, direct sunlight for several hours each day . Step 5 Firmly plug the solar panel module cord into the main housin ...

  • Brinkmann Sl 7 - page 10

    1 The Home Security Motion Activated Lighting System is designed to turn on automatically at night when a person enters the detection zone. The light will stay on as long as the motion detector senses motion in the zone. The light will turn off in approximately 90 sec- onds after the person leaves the detection zone or stops moving. During the day ...

  • Brinkmann Sl 7 - page 11

    R 140-6007-0 2/96 MODEL SL-7 OWNER’S MANUAL ASSEMBL Y AND OPERA TING INSTRUCTIONS INSTR-SM SL-7.q 4/22/02 11:29 AM Page 1 ...

  • Brinkmann Sl 7 - page 12

    2 ASSEMBL Y INSTRUCTIONS Inspect contents of the box to ensure all parts are included and undamaged. A Phillips screwdriver will be required. 1 P ARTS LIST : Home Security Main Housing Main Housing Mounting Screws (2) Solar Panel Module with Cord Solar Panel Module Mounting Screws (3) SL-7 Owner’ s Manual 2 3 4 5 3 4 Step 1 Select a location and ...

メーカー Brinkmann カテゴリー Greenhouse Kit

Brinkmann Sl 7のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- Sl 7の取扱説明書
- Brinkmannの製品カード
- パンフレット
- またはBrinkmann Sl 7の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Brinkmann Sl 7の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Brinkmann Sl 7の取り付け説明書、サービスマニュアル、簡易説明書、またはBrinkmann Sl 7のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Brinkmann Sl 7の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Brinkmann Sl 7デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがBrinkmann Sl 7を使用するのを助ける技術的文書のことです。説明書は通常、全てのBrinkmann Sl 7ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Brinkmannの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Brinkmann Sl 7の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははBrinkmann Sl 7の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Brinkmann Sl 7に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Brinkmann Sl 7デバイスの基本機能を使うにあたってのヒント。 Brinkmann Sl 7のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Brinkmann Sl 7に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるBrinkmann Sl 7のメーカー/サービスへの連絡先に関する情報。

Brinkmann Sl 7についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもBrinkmann Sl 7の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがBrinkmann Sl 7で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)