Bryston SP2 PREAMPの取扱説明書

20ページ 2.8 mb
ダウンロード

ページに移動 of 20

Summary
  • Bryston SP2 PREAMP - page 1

    SP2 PREAMP/PROCES SOR OWNER’S MANU AL ...

  • Bryston SP2 PREAMP - page 2

    1 IMPORTANT SAFETY INSTRUCTIONS The lightning flash with arrowhead symbol within an equilateral triangle, is intended to aler t the user to the presence of un-insu- lated “dangerous voltage “ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an eq ...

  • Bryston SP2 PREAMP - page 3

    T ABLE OF CONTENTS: 1. Safety Instructions & Warranty . . . . . . . . . . . 1 2. Contact information . . . . . . . . . . . . . . . . . . 2 3. Introduction, Accessories and Power . . . . . . . . . 3 4. Front Panel Controls and Indicators . . . . . . . . 4~6 a. Using the Dynamic R ange Control . . . . . . . . . 4 5. Rear Panel Input and Output Co ...

  • Bryston SP2 PREAMP - page 4

    INTRODUCTION Congratulations on your purchase of the Bryston SP2 pre-amplifier/processor . This product will pro- vide you with the finest av ailable signal control and DSP audio processing available. Like all Bryston products the SP2 has been carefully designed and engineered to deliver a lifetime of enjoyment. The SP2 offers both pre-amplifier an ...

  • Bryston SP2 PREAMP - page 5

    SP2 PREAMP/PROCESSOR SP2 FRONT P ANEL CONTROLS & INDICA T ORS 1: POWER SWIT CH (momentary) 2: ST ANDBY & INFRA-RED ACTIVITY INDICAT OR 3: INFRA-RED RECIEVER (sensor) 4: D YNAMIC RANGE CONTROL 5: ALPHA-NUMERIC DISPLA Y 6: MENU CONTROL Buttons 7: SOURCE SELECT Buttons & Indicators 8: DIGIT AL MODE Switch & Indicator 9: SURROUND MODE S ...

  • Bryston SP2 PREAMP - page 6

    6: MENU CONTROL BUTTONS SEL These three buttons labeled “  ” , “  ” , and “SEL ” (SELECT) are used to con- trol the menu and setup functions dis- played on the LCD . T o enter a menu mode, you can press any one of these buttons. This will bring up the main menu. Navigating any menu or sub- menu is done using the two arrow (  an ...

  • Bryston SP2 PREAMP - page 7

    SP2 PREAMP/PROCESSOR resents different mixing coefficients for the centre and surround channel signals. These will be detected by the SP2 and used to pro- duce the downmix if this mode is selected. 12: “THX” BUTTON THX This button allows selection of THX post pro- cessing modes. The default mode, which is normally Surround-EX , can be selected ...

  • Bryston SP2 PREAMP - page 8

    are now in the ‘Other Settings’ (Optical/THX) Menu. 2 . Move the cursor to the Optical Input (OPT1 or OPT2) you want to change the input assign- ment for . Hit ‘Select’ . (see figure below) 3 . Now you can assign the optical input to any one of the 6 inputs selectors. Doing this will override the digital coax connector on that input. Hit ? ...

  • Bryston SP2 PREAMP - page 9

    SP2 PREAMP/PROCESSOR 3 . T o change the source, use the “<” button. T o toggle the trigger setting On or Off , use the “>” button. Hit ‘Select’ to exit when finished. 8: AUX IR RECEIVER The Aux IR Input is a miniature mono phone jack connector . This is used to connect externally mounted IR LED receivers, or other extenders that p ...

  • Bryston SP2 PREAMP - page 10

    SP2 Remote Control continued... 1: SOURCE SELECT BUTTONS These buttons are used to select the desired source. TV/SA T , DVD, CD, AUX, VCR, and T APE function exactly like their corresponding buttons on the SP2 front panel. 2: BYP ASS BUTTONS T o use the 5.1 channel analog input, press the 6CH BYPA SS button. T o go back to the previous select- ed s ...

  • Bryston SP2 PREAMP - page 11

    SP2 PREAMP/PROCESSOR may have one.) IMPORTANT : When using the Pink Noise genera- tor within the SP2 for speaker level calibration, the salient point is that all channels measure equal dB. After pushing the test button, the pink noise will start in the front left speaker . Record the dB level from this speaker (with the level trim value at 0 dB on ...

  • Bryston SP2 PREAMP - page 12

    any system which you expect to effectively handle the low frequency dynamics of modern motion picture soundtrack sources such as DVD or HDTV feeds, and many other discrete multi-channel pro- gramming sources. If in any doubt choose small, especially if you are using a subwoofer , since this will insure that all the appropriate low frequency informa ...

  • Bryston SP2 PREAMP - page 13

    SP2 PREAMP/PROCESSOR 4 : Once you have selected the desired crossover frequency , press SELECT to exit this menu and return to the Speaker Config menu. The select- ed frequencies are common to all speakers defined as ‘SMALL ’ . Crossover frequency can be set independently for Front, Centre, Surround and Back speakers. NOTE 1 : The crossover act ...

  • Bryston SP2 PREAMP - page 14

    2 : Next move the cursor to “L VL ” . Hit ‘SELECT’ - Y ou are now in the Level T rim Menu. 3 : Move the cursor to the speaker(s) you want to change the level for using the arrow keys (L, C, R, RS, LS, RB, LB, SUB). Hit ‘SELECT’ . Now you can adjust the Level for the selected speaker using the arrow buttons. 4 : Hit ‘SELECT’ when fin ...

  • Bryston SP2 PREAMP - page 15

    SP2 PREAMP/PROCESSOR  ● ON : DTS-ES Matrix will be forced on for all DTS 5.1 channel input bit- streams, if the back channels are enabled. ● AUTO : DT S-ES Matrix will be decode if the incoming DTS bitstream is flagged as having DTS-ES encoded con- tent, and if the back channels are enabled. ENABLING THX SURROUND EX™ DECODING THX Surround ...

  • Bryston SP2 PREAMP - page 16

    3 : Panorama Mode extends the front stereo image to include the surround speakers for an exciting “wrap around” effect with side wall imaging. PLII Music also applies a mild high-frequency shelf filter to the surround channels for a more natural soundfield. Auto-balance is disabled. T o change the PLII Music settings: 1 : First enter the main m ...

  • Bryston SP2 PREAMP - page 17

    SP2 PREAMP/PROCESSOR ers. Surround Modes: HALL : This Sound Field Mode emulates a medium or large concert hall. It provides a longer reverber- ation time than other modes and gives the effect that music is heard at a greater distance from the performers. It is ideal for orchestral classical music and light orchestral music, such as that found on ma ...

  • Bryston SP2 PREAMP - page 18

    17 P ower OFF . . . . . . . . . . . . 000 TV/SA T ............................001 DVD .................................002 CD ...................................003 AUX .................................004 VCR .................................005 T A P E ................ 0 0 6 V olume UP . . . . . . . . . . . . 007 V olume DOWN . . . . . . . . . 00 ...

  • Bryston SP2 PREAMP - page 19

    SP2 PREAMP/PROCESSOR 18 ...

  • Bryston SP2 PREAMP - page 20

    SP2-OWNERS-MANUAL -20060112 STP / 19 SUGGESTED SURROUND SPEAKER PLA CEMENT ...

メーカー Bryston カテゴリー Stereo Amplifier

Bryston SP2 PREAMPのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- SP2 PREAMPの取扱説明書
- Brystonの製品カード
- パンフレット
- またはBryston SP2 PREAMPの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Bryston SP2 PREAMPの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Bryston SP2 PREAMPの取り付け説明書、サービスマニュアル、簡易説明書、またはBryston SP2 PREAMPのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Bryston SP2 PREAMPの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Bryston SP2 PREAMPデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがBryston SP2 PREAMPを使用するのを助ける技術的文書のことです。説明書は通常、全てのBryston SP2 PREAMPユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Brystonの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Bryston SP2 PREAMPの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははBryston SP2 PREAMPの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Bryston SP2 PREAMPに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Bryston SP2 PREAMPデバイスの基本機能を使うにあたってのヒント。 Bryston SP2 PREAMPのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Bryston SP2 PREAMPに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるBryston SP2 PREAMPのメーカー/サービスへの連絡先に関する情報。

Bryston SP2 PREAMPについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもBryston SP2 PREAMPの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがBryston SP2 PREAMPで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)