Shure SCM410Eの取扱説明書

18ページ 1.18 mb
ダウンロード

ページに移動 of 18

Summary
  • Shure SCM410E - page 1

    SCM410/SCM410E FOUR CHANNEL AUT OMA TIC MICROPHONE MIXER Shure Brothers Incorporated 222 Hartrey Avenue Evanston IL 60202-3696 U.S.A. Model SCM410/SCM410E User Guide 27A8690 (SG)  1999, Shure Brothers Incorporated Printed in U.S.A. U.S. Patents 4,658,425; 5,297,210 ...

  • Shure SCM410E - page 2

    2 T ABLE OF CONTENTS DESCRIPTION 3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . FEA TURES 3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Shure SCM410E - page 3

    3 DESCRIPTION The Shure Model SCM410/E is a four-channel automatic mi- crophone mixer designed for use in sound reinforcement, au- dio recording, and broadcast applications. The SCM410 dra- matically improves audio quality in any application where mul- tiple microphones are required. Any low-impedance dynamic or condenser microphone (including wire ...

  • Shure SCM410E - page 4

    4 REAR P ANEL MODEL SCM410 REAR P ANEL FIGURE 2 1. Power Connector: Unit is energized when the power cord is plugged into a 100–120 V ac (SCM410) or 220–240 V ac (SCM410E) power source. Can be internally modified.Refer to the “Internal Modification” section. NOTE: There is no power On/Off switch on this mixer . 2. DIP Switch: The 4-position ...

  • Shure SCM410E - page 5

    5 INST ALLA TION SUPPLIED HARDW ARE  4 rubber feet  1 rackmount bracket, long  1 rackmount bracket, short  2 straddle brackets  10 bracket screws, 6 mm (1/4 in.)  4 rackmount screws, 2.54 cm (1 in.)  4 plastic washers  4 wood screws, 1.25 cm (1/2 in.) RACK MOUNTING The SCM410 is supplied with hardware for mounting one or two ...

  • Shure SCM410E - page 6

    6 T ABLE-TOP MOUNTING Adhere the four (4) supplied rubber feet to the bottom of the mixer at each corner , as shown in Figure 9. This will keep it from sliding and protect the table surface. A TT ACHING RUBBER FEET FOR T ABLE–TOP MOUNTING FIGURE 9 FIXED MOUNTING T op Mount 1. Fasten the straddle brackets to the recessed edges of the chassis, u si ...

  • Shure SCM410E - page 7

    7 SCM410 CONNECTIONS 1. Connect microphone signal sources to the Channel Input connectors, as shown in Figure 14. Use conventional 2-con- ductor shielded audio cables. 2. I f any condenser microphones are connected, set the +12V phantom power DIP switch to ON. 3. Connect the SCM410 Mic/Line Level Output to the input of mixers, EQs, amplifiers or re ...

  • Shure SCM410E - page 8

    8 BASIC MIXER OPERA TION 1. Adjust each channel level so that its Overload LED flickers only during very loud speech or noise. 2. Adjust the Low-Cut and High-Frequency controls adjacent to each Input Gain control so that the microphones sound similar . 3. Adjust the Master level control for the required output level, as indicated by the output peak ...

  • Shure SCM410E - page 9

    9 SPECIFICA TIONS Measurement Conditions (unless otherwise specified): Line voltage 120 V ac, 60 Hz (SCM410) or 230 V ac, 50 Hz (SCM410E); full gain; 1 kHz, one channel activated; source impedances: Mic 150 Ω ; terminations: Line/Mic Aux 10 k Ω Frequency Response (at 1 kHz, channel controls centered) 50 Hz to 20 kHz ± 2 dB; -3 dB corner at 25 ...

  • Shure SCM410E - page 10

    10 Replacement Parts Knob, Master (white) 95A8238 . . . . . . . . . . . . . . . . . . . . . . . Knob, Channel Gain (blue) 95B8238 . . . . . . . . . . . . . . . . . Line (Power) Cord (SCM410) 95A8762 . . . . . . . . . . . . . . . Line (Power) Cord (SCM410E) 95A8778 . . . . . . . . . . . . . . Link Cable 95A8889 . . . . . . . . . . . . . . . . . . . ...

  • Shure SCM410E - page 11

    11 ADV ANCED FUNCTIONS CAUTION : Use of Advanced Functions is recommended only for qualified audio technicians. LOGIC CONNECTION SPECIFICA TIONS The SCM410 logic functions expand the range of installation an d control options. Logic can be used for everything from sim- ple cough switches to elaborate computer-controlled room systems. (Shure’s AMS ...

  • Shure SCM410E - page 12

    12 SUGGESTED LOGIC APPLICA TIONS This section contains suggestions on the uses of the SCM410’s logic capabilities. Note that uses of these functions ar e not limited to the listed applications. The user is limited only by imagination and creativity . For additional suggestions and solutions to installation problems, contact the Shure Applica- tio ...

  • Shure SCM410E - page 13

    13 Inhibiting Gating for Unwanted Sounds MaxBus attempts to activate only one microphone per sound source. Muting a microphone channel prevents its audio from appearing at the mixer ’ s output. However , the muted micro- phone still communicates with other mic channels via Max- Bus. A sound source picked up by a muted microphone will not activate ...

  • Shure SCM410E - page 14

    14 Inhibit Function For information on the inhibit function, refer to the Internal Modifications section. Remote V olume Control Th e level of the Aux or Master output can be controlled from an external VCA (V oltage Controlled Amplifier) such as the RU- VCA1 from Radio Design Labs (T el. 1–800–281–2683, or www .rdlnet.com). T o connect a VCA ...

  • Shure SCM410E - page 15

    15 INTERNAL MODIFICA TIONS W ARNING: V oltages in this equipment are hazardous to life. No user-serviceable parts inside. Refer all servicing to qualified service personnel. NOTE: • Only make changes to jumpers (X) and resistors (R). The circuit board contains holes where resistors are to be added. • For Channel modifications, the first charact ...

  • Shure SCM410E - page 16

    16 INSERTING AN INPUT LINE P AD T o insert a 40 dB line pad for a given microphone input, remove the resistors specified in the following table. Channel Remove Resistor 1 R1005, R1006 2 R2005, R2006 3 R3005, R3006 4 R4005, R4006 DISABLING THE MASTER LEVEL CONTROL Th e Master gain control can be disabled to prevent tampering. Refer to the following ...

  • Shure SCM410E - page 17

    17 When both MUTE IN and OVERRIDE IN logic are grounded, the Override mode will take precedence (as supplied, the MUTE IN takes precedence over OVERRIDE IN). Procedure: 1. Short jumper X1005. 2. Remove resistor R1087. DEAD ZONE ON MUTE IN DEFEA T As supplied, MUTE IN is intended for use as a momentary cough button or privacy function (mute when nec ...

  • Shure SCM410E - page 18

    18 This modification is equivalent to shorting one of the channel OVERRIDE IN t o the LOGIC GROUND pin via the high density DB-15 logic connector . With this modification, a channel is al- ways on. Procedure: Short jumper X1003. SHORTING MUTE IN T O LOGIC GROUND INTERNALL Y This modification is equivalent to shorting a channel MUTE IN to the LOGIC ...

メーカー Shure カテゴリー Musical Instrument

Shure SCM410Eのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- SCM410Eの取扱説明書
- Shureの製品カード
- パンフレット
- またはShure SCM410Eの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Shure SCM410Eの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Shure SCM410Eの取り付け説明書、サービスマニュアル、簡易説明書、またはShure SCM410Eのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Shure SCM410Eの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Shure SCM410Eデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがShure SCM410Eを使用するのを助ける技術的文書のことです。説明書は通常、全てのShure SCM410Eユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Shureの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Shure SCM410Eの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははShure SCM410Eの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Shure SCM410Eに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Shure SCM410Eデバイスの基本機能を使うにあたってのヒント。 Shure SCM410Eのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Shure SCM410Eに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるShure SCM410Eのメーカー/サービスへの連絡先に関する情報。

Shure SCM410Eについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもShure SCM410Eの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがShure SCM410Eで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)