Cannon Mag 5 Hsの取扱説明書

16ページ 3.81 mb
ダウンロード

ページに移動 of 16

Summary
  • Cannon Mag 5 Hs - page 1

    OWNER’S MANU AL NOTE: Do not return your CANNON® Do wnrigger to your retailer. Your retailer is not authorized to repair or replace this unit. You may obtain service by: • calling CANNON® at 1-800-227-6433; • returning your do wnrigger to the Factory Service Center; • sending or taking your d ownrigger to any CA NNON® Authorized Service ...

  • Cannon Mag 5 Hs - page 2

    2 Parts Description 1. Reel This is used to spool the cable, available in length s ranging from 150 to 400 feet. 2. Boom This is used to extend the weight out from the body of the downrigger and has a pulley fixed to its end. Boom lengths range from 24 to 53 inches. 3. Swivel Head This relays the cable at the end of the boom to lower the wei ght. 4 ...

  • Cannon Mag 5 Hs - page 3

    3 Downrigger Mounting on Boats A downrigger should be mounted where ever it is easy to operate and observe. You want to be able to see your fishing rod and to react quickly. So, choosing a good spot to mount your downrigger on your boat is 99% of the job. Due to the great variety of boats available, mounting your downrigger can be a dilemma. Having ...

  • Cannon Mag 5 Hs - page 4

    4 Side Rail Mounting Side/Rail mounts can be mounted to a welded T-section. It can also be used at the two rail section butt joint. In both installations it is recommended to use a non-slip material, such as rubber or a thin wood sheet, between metal surfaces. You can also use these for mounting to a very narrow side gunwale. There is a plate provi ...

  • Cannon Mag 5 Hs - page 5

    5 FOR MAG 10 HS and MAG 10 TS: The Low-Profile Swivel Base mounting follows the same procedure as for the deck plate except that four 1/4”-20 x 2 1/2" truss head screws are used to fasten the mounting base and four additional 1/4”-20 x 2 1/2" truss head screws fix the swivel base to the boat deck. If access to the underside of the dec ...

  • Cannon Mag 5 Hs - page 6

    6 Mounting the Downrigger on the Base Slide body over the lip of the base, with boom outboard or facing the stern. Lift Lock Knob to hold threaded shaft clear of base until body completely covers base. Turn Lock Knob clockwise to tighten the downrigger to the base. Tip: Periodically check base to ensure integrity. The base should be replaced at lea ...

  • Cannon Mag 5 Hs - page 7

    7 T erminating the Downrigger Cable Cannon Uni-Release The Cannon Uni-Release attaches directly to the downrigger weight. Attach fishing line to the clip at the end of the release, and then click through a series of increasing tension settings. The release can be used with any test line on salt or fresh water and may be adjusted from 2 to 22 pounds ...

  • Cannon Mag 5 Hs - page 8

    8 CAUTION: This rod holder is intended for use of up to 30 lb. test line only, and is not recommended for use with any tackle IGFA rated higher than 30 lb. A safety strap (not included) is recommended for all applications. The rod holder assembly is not warranted when used with tackle above 30 lbs. Equipment placed in the rod holders and the loss t ...

  • Cannon Mag 5 Hs - page 9

    9 Wiring Y our Downrigger Your Boat's Electrical Condition It is important to make sure that your boat is properly set up before installing your Mag 10HS Mag 10TS Mag 5HS with Positive Ion Control. Whenever a boat is in water, various submerged parts interact to create weak electrical currents. These weak electrical currents must be contro ...

  • Cannon Mag 5 Hs - page 10

    10 Operating Y our Downrigger After mounting the Cannon downrigger to your boat, release some line from your rod and reel so that the lure is anywhere from 5 to 100 feet behind the boat. This is called drop back. Attach the fishing line firmly into the line release. Press and hold the toggle switch down to lower the weight to the desired depth as i ...

  • Cannon Mag 5 Hs - page 11

    11 Adjusting the Depth Meter The Cannon Depth Meter provides non-slip accuracy, plus easy resetting. To reset, just slide the meter away from the reel until the gears are disengaged. Spin meter gear to change setting. NOTE: Actual fishing depth may vary from depth shown on meter due to trolling speed and weight of cannon ball. (See "Blowback&q ...

  • Cannon Mag 5 Hs - page 12

    12 The Positive Ion Control System Your boat has an electrical charge around the hull in water. If a boat is properly bonded and properly zinced, that charge should be slightly positive when measured from ground to the downrigger cable. Positive Ion Control (PIC) is the use of electricity to control that charge and its fluctuation so that it is alw ...

  • Cannon Mag 5 Hs - page 13

    13 T rouble Shooting PROBLEM: Up or down will not work. SOLUTION: Check the battery cable polarity then check the battery voltage. A properly connected and charged battery is important for safety and for proper operation of the downrigger. PROBLEM: The Mag 10HS Mag 10TS Mag 5HS fails to continue running after toggle switch is pushed up and held ...

  • Cannon Mag 5 Hs - page 14

    14 T en Good T r olling T ip s 1) Test your lures over the boat side before sending them down and back. Do this to make sure the lure wiggles and wobbles properly without going belly up or wandering off. Some lures can be adjusted, fine tuned actually, to impart maximum action. For example, a slight bend in the tail of a spoon or twist of the hook ...

  • Cannon Mag 5 Hs - page 15

    15 CANNON ® SERVICE POLICY AFTER THE APPLICABLE WARRANTY PERIOD After the applicable warranty period, or, if one of the above exclusions applies, Cannon® products will be repaired for a charge of parts plus labor. All factory r epairs, after the applicable warranty period, carry a 90-Day Limited Warrant y, subject t o the exclusions and limitatio ...

  • Cannon Mag 5 Hs - page 16

    16 All CANNON Downriggers are covered by US Pat.D-269, 9 92. Co pyright 2006 Johnson Outdoors, Inc. All rights reserved. Conforms to 89/336/EEC (EMC) under standa rds EN 55022A, EN 50082-2 since 1996 LN V9677264 WA RN ING : This product contains chemical (s) known to the state of California to c ause cancer and/or repr oductive toxicity. Form No. 3 ...

メーカー Cannon カテゴリー Fish Finder

Cannon Mag 5 Hsのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- Mag 5 Hsの取扱説明書
- Cannonの製品カード
- パンフレット
- またはCannon Mag 5 Hsの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Cannon Mag 5 Hsの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Cannon Mag 5 Hsの取り付け説明書、サービスマニュアル、簡易説明書、またはCannon Mag 5 Hsのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Cannon Mag 5 Hsの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Cannon Mag 5 Hsデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがCannon Mag 5 Hsを使用するのを助ける技術的文書のことです。説明書は通常、全てのCannon Mag 5 Hsユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Cannonの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Cannon Mag 5 Hsの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははCannon Mag 5 Hsの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Cannon Mag 5 Hsに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Cannon Mag 5 Hsデバイスの基本機能を使うにあたってのヒント。 Cannon Mag 5 Hsのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Cannon Mag 5 Hsに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるCannon Mag 5 Hsのメーカー/サービスへの連絡先に関する情報。

Cannon Mag 5 Hsについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもCannon Mag 5 Hsの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがCannon Mag 5 Hsで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)