Wagner SprayTech Power Painterの取扱説明書

19ページ 関係なし
ダウンロード

ページに移動 of 19

Summary
  • Wagner SprayTech Power Painter - page 1

    English Owner’s Manual Read this manual for complete instructions Table of Contents Safety Information ................................................... 2 What’s in the Box .................................................... 3 Before you Begin ..................................................... 4 Selecting the proper spray tip............. ...

  • Wagner SprayTech Power Painter - page 2

    This symbol indicates a hazardous situation, which, if not not avoided could result in death or serious injury. HAZARD: INJECTION INJURY A high pressure stream of paint produced by this equipment can pierce the skin and underlying tissues, leading to serious injury and possible amputation. DO NOT TREAT AN INJECTION INJURY AS A SIMPLE CUT! Injection ...

  • Wagner SprayTech Power Painter - page 3

    3 English Important Safety Information · Read all safety information before operating the equipment. SAVE THESE INSTRUCTIONS. Grounding Instructions This product must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This product is equipped ...

  • Wagner SprayTech Power Painter - page 4

    English 4 Before You Begin Important Preparation Tips: Selecting the Proper Spray Tip: • It is important to mix the material thoroughly before you begin. Do not shake the material to mix it. Always stir the material gently but thoroughly before use. • Remove any skin that has formed on the top of the material. Do not mix the skin into the mater ...

  • Wagner SprayTech Power Painter - page 5

    5 English Material Container Setup 1. Remove the material container from the pump housing by turning the pump housing ring counterclockwise. 7. Twist the pump housing ring to thread the container onto the pump housing. Plug in the unit. 3. Fill the container with the material to be used. 5. Insert the suction tube into the intake opening. 2. Remove ...

  • Wagner SprayTech Power Painter - page 6

    English 6 Remote Suction Set Setup (optional) 1. Remove the material container from the pump housing by turning the pump housing ring counterclockwise. 7. Submerge the suction tube assembly into the material container and attach the container clip (l) to the side to hold it securely. Make certain the return line (m) is inside the container. 3. Plac ...

  • Wagner SprayTech Power Painter - page 7

    7 English Flow Control Knob / Practice Spraying 1. Turn the ow knob fully counterclockwise to maximum. 3. Turn the ow knob clockwise until you have a good spray pattern. 2. Point the sprayer at a scrap piece of wood or cardboard, and pull the trigger to prime the sprayer. Release trigger when material sprays evenly from the spray gun. 4. A po ...

  • Wagner SprayTech Power Painter - page 8

    English 8 Title Usage Overspray: Priming with the Remote Suction Set: 1. If you are using the remote suction set, you will need to prime the sprayer by removing air from the system. To prime: Make sure the sprayer is plugged in, and turn the ow control knob counterclockwise to maximum. 3. Aim the sprayer at a piece of scrap wood or cardboard. Sq ...

  • Wagner SprayTech Power Painter - page 9

    9 English Title Spraying Technique 1. Keep your arm moving at constant speed and keep the sprayer at a constant distance from the surface. The sprayer should be triggered at the beginning of the stroke and released at the end of the stroke. 2. Keep the sprayer at right angles to the surface. This means moving your entire arm back and forth rather t ...

  • Wagner SprayTech Power Painter - page 10

    English 10 Title Using the Quick Flush Lid (latex materials only) Cleaning the material container: 1. Unplug the sprayer. Pour the remaining material back into the original container. Remove the suction tube. 4. Slide the pump housing assembly off the sprayer. Remove the piston and spring from the pump housing. Place all removed parts (except the p ...

  • Wagner SprayTech Power Painter - page 11

    11 English Title Using the Quick Flush Lid (latex materials only) Cleaning the Remote Suction Set: You will need a garden hose to complete the steps below. If you do not have a garden hose available, or if you used oil- based materials, follow the Cleanup for Oil-Based Materials instructions on page 12-13 . 1. To remove any remaining material that ...

  • Wagner SprayTech Power Painter - page 12

    English 12 Title Cleanup - Oil-based Materials Cleaning the Material container: 1. Unplug the sprayer. Pour the remaining material back into the original container. 2. Fill the container half full of the cleaning solution appropriate to the type of material you sprayed (warm, soapy water for latex-based materials; mineral spirits for oil-based mate ...

  • Wagner SprayTech Power Painter - page 13

    13 English Cleanup - Oil-based Materials Cleaning the Remote Suction Set: 1. Make sure the sprayer is unplugged. 2. Remove the suction tube from the material container and submerge into a container of the solvent appropriate to the type of material you sprayed (warm, soapy water for latex-based materials; mineral spirits for oil-based materials. 3. ...

  • Wagner SprayTech Power Painter - page 14

    English 14 Title Cleaning the Components - Oil-based materials Reassembly - all materials 1. Turn the spray tip counterclockwise until it is removed. Pull out the atomizer valve, being careful not to lose it. 1. Slide the spring onto the front end of the piston. 4. Place the locking nut onto the motor housing. Press in while turning the locking nut ...

  • Wagner SprayTech Power Painter - page 15

    15 English Maintenance Replacement Parts 1. Turn the sprayer upside-down while the material container is removed. Squeeze a small amount of standard household oil into both the intake (a) and return (b) openings on the pump housing. Atomizer valve: The atomizer valve is shaped to cause the material to spin as it comes out of the sprayer. The spinni ...

  • Wagner SprayTech Power Painter - page 16

    English 16 Troubleshooting Problem A. Motor will not run. B. Motor has a low hum and does not spray. C. Motor operates properly but does not spray. D. Material spitting or globbing. E. Excessive fogging. F. Runs and sags in paint. G. Material drips from spray tip guard. H. Motor overheats. I. Material leaking from between spray tip and locking nut. ...

  • Wagner SprayTech Power Painter - page 17

    50 Parts list • Liste de pièces • Lista de piezas (i) (a) (g) (h) (j) (p) (q) (r) (m) (b) (c) (d) (e) (f) (k) (l) (n) (o) ...

  • Wagner SprayTech Power Painter - page 18

    51 Parts list • Liste de pièces • Lista de piezas Item Article Articulo Part No. Nº de piéce Pieza No. English Description Français Description Español Descripción Quantity Quantite Cantidad a) ---------- Sprayer assembly Pulvérisateur Rociador 1 b) 0525351 Pump housing ring Anneau du corps de pompe Anillo de la caja de la bomba 1 c) 052 ...

  • Wagner SprayTech Power Painter - page 19

    52 Warranty • Garantie • Garantía Wagner Spray Tech Corporation 1770 Fernbrook Lane Plymouth, Minnesota 55447 Telephone 1-800-328-8251 Copyright © Wagner Spray Tech Corporation. All rights reserved, including right of reproduction in whole or in part, in any form. WAGNER ONE-YEAR LIMITED WARRANTY - Keep on File This product, manufactured by W ...

メーカー Wagner SprayTech カテゴリー Paint Sprayer

Wagner SprayTech Power Painterのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- Power Painterの取扱説明書
- Wagner SprayTechの製品カード
- パンフレット
- またはWagner SprayTech Power Painterの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Wagner SprayTech Power Painterの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Wagner SprayTech Power Painterの取り付け説明書、サービスマニュアル、簡易説明書、またはWagner SprayTech Power Painterのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Wagner SprayTech Power Painterの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Wagner SprayTech Power Painterデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがWagner SprayTech Power Painterを使用するのを助ける技術的文書のことです。説明書は通常、全てのWagner SprayTech Power Painterユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Wagner SprayTechの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Wagner SprayTech Power Painterの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははWagner SprayTech Power Painterの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Wagner SprayTech Power Painterに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Wagner SprayTech Power Painterデバイスの基本機能を使うにあたってのヒント。 Wagner SprayTech Power Painterのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Wagner SprayTech Power Painterに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるWagner SprayTech Power Painterのメーカー/サービスへの連絡先に関する情報。

Wagner SprayTech Power Painterについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもWagner SprayTech Power Painterの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがWagner SprayTech Power Painterで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)