Dynacord DEM 313の取扱説明書

11ページ 0.36 mb
ダウンロード

ページに移動 of 11

Summary
  • Dynacord DEM 313 - page 1

    CHARGING UNIT DEM 313 Features — fully automatic charging unit 24V/4A for constant I/U battery charging in continuous batt ery power supply mode — regulation of charging voltage with high-efficiency primary switched chopper regulat or — charging output with short-circuit and reverse voltage protection — integrated battery monitoring module ...

  • Dynacord DEM 313 - page 2

    The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to ale ...

  • Dynacord DEM 313 - page 3

    1 3-digit LC display for charging voltage or charging current 2 LC display switch showing the charging voltage in V or the charging current in A 3 LED function and failure indications: Failure indication for overvoltage OVERVOLTAGE Failure indication for low voltage LOW VOLTAGE Function indication for mains voltage LINE VOLTAGE Function indication ...

  • Dynacord DEM 313 - page 4

    LIST OF CONTENTS SAFETY INSTRUCTIONS / SERVICE INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 1. Application . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 2. Installation instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Dynacord DEM 313 - page 5

    1. Application The charging unit DEM 313 was especially designed for fully automatic charging and monitor ing of batteries in the emergency power supplies of alarm devices. In conjunction with the batt ery modules DEM 316 with 38 Ah or DEM 317 with 65 Ah rated capacity, this combination results in a reliabl e and failsafe emergency power source for ...

  • Dynacord DEM 313 - page 6

    Fig. 1 Connection of the battery to the charging unit 3.1 Control connector BATTERY CONTROL Various control input/outputs are available at the 15-pole D-sub pin connector BATTERY CONT ROL (9): (Also see Figure 2): - Input temperature sensor +TEMP/-TEMP - Output exhaustive discharge relay +LVR/-LVR - Failure signal output FAILURE Fig. 2 Connections ...

  • Dynacord DEM 313 - page 7

    Fig. 3 PCB 85254 Location of the wire jumpers S501 - S504 for altering mains voltage and position of the output fuse F503 5. Battery charging 5.1 Charging the batteries in the battery modules DEM 316 or DEM 317 Once the charging unit has been connected to the battery module correctly, (see Section 3) and the mains voltage is present the green LEDs ...

  • Dynacord DEM 313 - page 8

    - max. value - rated value - min. value 5.2 Charging of other batteries DYNACORD battery modules DEM 316, DEM 317 or other maintenance - free 24V lead-acid batter ies with a rated capacity up to 65 Ah can be charged with the charging unit DEM 313. To do so, the charging output CHARGE OUTPUT + (8) is to be connected with the plus pole and the chargi ...

  • Dynacord DEM 313 - page 9

    6.1 OVERVOLTAGE protection This circuit monitors the value of the output voltage of the charging unit. lf the output vo ltage exceeds the pre-set upper threshold, the red LED OVERVOLTAGE lights up, the charging unit is disconnect ed from battery and consumers automatically, activating the error message. Thereby the batter y remains connec - ted to ...

  • Dynacord DEM 313 - page 10

    6.8 Volt-/Amperemeter A 3-digit LC display (1) with toggle switch (2) is provided for measurement of the battery v oltage or the charging current. With the switch V/A at the front panel in position V, the battery vollage is shown. Likewise the charging current is shown with the switch in position A. 6.9 Temperature tracking The charging voltage req ...

  • Dynacord DEM 313 - page 11

    9. Approvals and standards - The charging units correspond to the following standards: EN 55014-2 Immunity requirements for household appliances, electric tools and similar electrical appliances EN 50082-1 Basic standard for interference rejection; living area, business areas as well as small enterprises EN 60065 Safety requirements for mains-opera ...

メーカー Dynacord カテゴリー Battery Charger

Dynacord DEM 313のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- DEM 313の取扱説明書
- Dynacordの製品カード
- パンフレット
- またはDynacord DEM 313の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Dynacord DEM 313の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Dynacord DEM 313の取り付け説明書、サービスマニュアル、簡易説明書、またはDynacord DEM 313のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Dynacord DEM 313の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Dynacord DEM 313デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがDynacord DEM 313を使用するのを助ける技術的文書のことです。説明書は通常、全てのDynacord DEM 313ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Dynacordの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Dynacord DEM 313の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははDynacord DEM 313の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Dynacord DEM 313に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Dynacord DEM 313デバイスの基本機能を使うにあたってのヒント。 Dynacord DEM 313のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Dynacord DEM 313に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるDynacord DEM 313のメーカー/サービスへの連絡先に関する情報。

Dynacord DEM 313についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもDynacord DEM 313の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがDynacord DEM 313で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)