-
Telex Plasma Series - page 1
ELECTRO-VOICE ® Plasma Series High Powered Loudspeaker Owner s Manual - P1 (Left & Right) - P2 Subwoofer ...
-
Telex Plasma Series - page 2
ELECTRO-VOICE ® Note: SAFETY COMPONENT (HAS TO BE REPLACED WITH ORIGINAL P ART ONL Y) 1 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water . 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufact ...
-
Telex Plasma Series - page 3
ELECTRO-VOICE ® 2 T able of Contents Important Safety/Service Instructions .......................................................................................... .1 Plasma Series Owner ’s Manual ................................................................................................... 2 Safety First ................................. ...
-
Telex Plasma Series - page 4
ELECTRO-VOICE ® 3 Safety First When setting up, installing and using Electro-V oice ® Plasma speaker systems, there are a number of precautions that you should follow: · When Electro-V oice ® Plasma speakers are used for portable applications in which they will be stacked directly on the floor , make sure that the floor or stage is solid and se ...
-
Telex Plasma Series - page 5
ELECTRO-VOICE ® 4 Description Electro-V oice ® Plasma high powered loudspeakers are fully integrated audio systems with carefully matched electronics and transducers. These products make it easy to setup a high- quality sound system quickly with a minimum of cables and external electronics. It retains typical EV ruggedness, reliability and impecc ...
-
Telex Plasma Series - page 6
ELECTRO-VOICE ® 5 P1 and P2 Amplifiers Input Signal Electronically balanced inputs for the connection of high-level signal sources such as mixers, signal processors, etc. Establishing the connection is possible via phone or XLR-type jacks. Balanced connection is recommended to prevent noise or HF-interference. Caution: Before connecting or disconn ...
-
Telex Plasma Series - page 7
ELECTRO-VOICE ® 6 Status Indicators These indicators provide information about the actual operational state of the Plasma’s internal power amplifier . Signal Indicates that an audio signal is present at the input and that it is output. Limit When lit this indicator signals that the internal power amplifier actually operated at the threshold of c ...
-
Telex Plasma Series - page 8
ELECTRO-VOICE ® 7 Setup Diagrams for Plasma · Plug a line input into either the ¼-inch or the 3-pin XLR-type input connector . The ¼- inch input is in the center of the XLR connector and can accept unbalanced or balanced lines (TRS ¼-inch). The line input level required to drive the unit to full power is from – 12 dBu to 0 dBu. The system’ ...
-
Telex Plasma Series - page 9
ELECTRO-VOICE ® 8 Using Plasma P1’ s as Floor Monitors · The Plasma P1 is perfect for use as a powered floor monitor . Figure 3: Rigging Hardware for the Plasma P1 Figure 4: Suspending the Plasma P1 W ARNING: Suspending any object is potentially dangerous and should only be attempted by individuals who have a thorough knowledge of the technique ...
-
Telex Plasma Series - page 10
ELECTRO-VOICE ® 9 Suspending Plasma P1 Speaker Systems P1 enclosures have L-track located on the top, bottom, and on one side. Single or double stud ring fittings can be attached to the L-track to be used as suspension points. These points are located at the center of gravity to allow the system to hang straight when used either vertically , or ho ...
-
Telex Plasma Series - page 11
ELECTRO-VOICE ® 10 : ) B d 3 - ( e s n o p s e R . q e r Fz H 0 0 1 - z H 0 4 ) B d 0 1 - ( e g n a R . q e r F 1 :z H 0 1 1 - z H 0 3 : L P S x a M d e t a l u c l a CB d 2 3 1 : n g i s e D r e i f i l p m AH s s a l C : D H T% 5 0 . 0 < : e c n a d e p m I t u p n IK 0 2 Ω : r e w o P r e i f i l p m A) k a e P W 0 0 8 ( S M R W 0 5 5 : r ...
-
Telex Plasma Series - page 12
ELECTRO-VOICE ® Plasma P2 Subwoofer Front View Side V iew T op View Dimensions (Plasma P2 Subwoofer) 11 ...
-
Telex Plasma Series - page 13
ELECTRO-VOICE ® Block Diagrams 12 Plasma P2 Plasma P1 ...
-
Telex Plasma Series - page 14
ELECTRO-VOICE ® Notes 13 ...
-
Telex Plasma Series - page 15
ELECTRO-VOICE ® Notes 14 ...
-
Telex Plasma Series - page 16
ELECTRO-VOICE ® U.S.A. and Canada: For customer orders, contact the Customer Service department at: 800/392-3497 Fax: 800/955-6831 For warranty repair or service information, cont act the Service Repair Department at: 800/685-2606 For technical assistance, contact T echnical Support at: 866/78 AUDIO S pecifications subject to change without notice ...
Telex Plasma Seriesについてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもTelex Plasma Seriesの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがTelex Plasma Seriesで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。