Spirit UltraMic Plusの取扱説明書

19ページ 3.61 mb
ダウンロード

ページに移動 of 19

Summary
  • Spirit UltraMic Plus - page 1

    Featuring ...

  • Spirit UltraMic Plus - page 2

    P age 2 SAFETY PRECAUTIONS The SPIRIT MONITOR 2 mixer must only be connected through the P ower Supply supplied. The wires in the mains lead are coloured in accordance with the following code: Earth: Green and Y ellow (Green/Y ellow - US) Neutral: Blue (White - US) Live: Brown (Black - US) As the colours of the wires in the mains lead may not corre ...

  • Spirit UltraMic Plus - page 3

    P age 3 INPUTS 24 Connecting Up ...

  • Spirit UltraMic Plus - page 4

    USING MONITOR 2 Mono Input Channel XLR Input The UltraMic Plus padless input preamp is designed to accept BALANCED or UNBALANCED signals at a wide range of input levels up to +28dBu. When using microphones, professional dynamic, condenser or ribbon mics are best because these will be L OW IMPEDANCE. Y ou can use low -cost HIGH IMPEDANCE mics, but t ...

  • Spirit UltraMic Plus - page 5

    P age 5 MONITOR SENDS These controls route the input channel signal to any one or more Monitor busses and the associated Monitor Outputs, allowing a number of unique monitor mixes to be created. The sends are arranged as a group of mono sends (1-8) and two stereo pairs (9/10 & 11/12). Each group of sends is normally POST -F ADE, POST -EQ but ma ...

  • Spirit UltraMic Plus - page 6

    P age 6 9 10 8 7 6 1 2 3 4 5 11 OUTPUT SECTION MONITOR OUTPUTS These outputs provide summing of the corresponding input channel monitor sends, and drive XLR -type output sockets from impedance balanced outputs. A break-point is included before each output socket for the connection of an external graphic equaliser . Outputs 1-8 are configured as mon ...

  • Spirit UltraMic Plus - page 7

    P age 7 MASTER SECTION WEDGE SOURCE The Engineer s W edge outputs are normally fed from a mix of the MNTR feeds from outputs 1-12. The pre-fade wedge signal feeds the headphones and meters and the post-fade signal feeds the XLR outputs. Pressing the WEDGE SOURCE switch selects monitor outputs 11-12 as the source for the wedge outputs, and would ...

  • Spirit UltraMic Plus - page 8

    P age 8 Setting Up & T roubleshooting Initial Set Up Once you have connected up your system (see the sections on connection and wiring earlier in this manual for guidance) you are ready to set initial positions for the controls on your mixer . The front panel drawing on page 17 shows typical initial control positions which may serve as a useful ...

  • Spirit UltraMic Plus - page 9

    P age 9 BAND INSTRUMENTS/VOCALS Live Monitor with Effects APPLICA TIONS ...

  • Spirit UltraMic Plus - page 10

    BAND INSTRUMENTS/VOCALS P age 10 Live Monitor with In-Ear Monitoring ...

  • Spirit UltraMic Plus - page 11

    P age 11 Theatre ...

  • Spirit UltraMic Plus - page 12

    P age 12 FOH Console ...

  • Spirit UltraMic Plus - page 13

    P age 13 FOH Console with Subgrouping ...

  • Spirit UltraMic Plus - page 14

    P age 14 3 3 3 3 3 1 1 1 1 1 2 2 2 2 2 +48V +48V +48V +48V MIC INPUT SPLIT SPLIT OUTPUT (Internal Link) Link - Grounded No Link - Ground Lift TIP: SEND RING: RETURN HOUSE MICS FX RET 1 LEFT HOUSE FX RET 1 FX RET 2 HOUSE SENS FX RET 2 LEFT FX RET 1 RIGHT FX RET 2 RIGHT LEFT RIGHT T/B MIC T/B SENS PHASE INPUT SENS MONITOR 1 2 3 4 5 6 7 8 9 9-10 PA N ...

  • Spirit UltraMic Plus - page 15

    Balanced Unbalanced Insert Leads ’Y’ Leads (Unbalanced) Lamp Connections ’Y’ Leads (Balanced) Headphone Splitter P age 15 Connecting Leads ...

  • Spirit UltraMic Plus - page 16

    Control Position Sheet Y ou may freely copy this page to mark control positions to assist in resetting the desk between performances. ...

  • Spirit UltraMic Plus - page 17

    P age 17 INPUTS MONITOR 2 CONSOLE T ypical Starting Out Control Positions ...

  • Spirit UltraMic Plus - page 18

    P age 18 Specifications Noise Measured RMS, 22Hz to 22kHz Bandwidth. Inputs at unity gain and terminated 150 W Output Noise 24 inputs routed, sends down, master @ unity < -80dBu EIN Mic EIN @ max. gain (150 W terminated) -129dBu THD+N Mic sens. -10dBu, Faders @ unity , send at max., +20dBu at all outputs @ 1kHz <0.005% Crosstalk (@1kHz) T ypi ...

  • Spirit UltraMic Plus - page 19

    A Harman International Company P art No: ZM0192 ...

メーカー Spirit カテゴリー Music Mixer

Spirit UltraMic Plusのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- UltraMic Plusの取扱説明書
- Spiritの製品カード
- パンフレット
- またはSpirit UltraMic Plusの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Spirit UltraMic Plusの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Spirit UltraMic Plusの取り付け説明書、サービスマニュアル、簡易説明書、またはSpirit UltraMic Plusのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Spirit UltraMic Plusの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Spirit UltraMic Plusデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがSpirit UltraMic Plusを使用するのを助ける技術的文書のことです。説明書は通常、全てのSpirit UltraMic Plusユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Spiritの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Spirit UltraMic Plusの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははSpirit UltraMic Plusの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Spirit UltraMic Plusに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Spirit UltraMic Plusデバイスの基本機能を使うにあたってのヒント。 Spirit UltraMic Plusのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Spirit UltraMic Plusに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるSpirit UltraMic Plusのメーカー/サービスへの連絡先に関する情報。

Spirit UltraMic Plusについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもSpirit UltraMic Plusの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがSpirit UltraMic Plusで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)