-
Pelco c3419m - page 1
INSTALLATION Heavy-Duty Spectra ® IV Series C3419M (8/06) In-Ceiling Back Box ...
-
Pelco c3419m - page 2
2 C3419M (8/06) Installation BACK MOUNTING PLA TES MOUNTING RING CEILING 1 5 36 4 2 ...
-
Pelco c3419m - page 3
C3419M (8/06) 3 1. Locate the center point of the mounting location and insert the compass tool. Draw a circle. 2. Cut the circle out of the ceiling. 3. Use the mounting ring as a template and mark the screw hole pattern onto the mounting surface. Prepare the holes. 4. Install the mounting plates. Use the eight 10-32 x 3-inch screws (supplied) and ...
-
Pelco c3419m - page 4
4 C3419M (8/06) 7 8 VIDEO UTP+ UTP- RX- RX- TX- TX- PWR- PWR+ GND AUX2 GND GND NO NC COM 7 6 5 4 3 2 1 ALARMS AUX1 ...
-
Pelco c3419m - page 5
C3419M (8/06) 5 7. Install the back box by compressing the spring clips and pushing the back box through the hole. T ighten the screws until you hear a clicking noise. 8. Connect wiring to the circuit board inside the back box. When finished, close the door to the back box and turn on the power . The green LED will light. NOTES: • Aux 1: Maximum ...
-
Pelco c3419m - page 6
6 C3419M (8/06) TRIM LEASH BALL STUD BALL STUD RECEIVER BARREL KEY LOCK SWITCH 1 AND 2 11 9 10 ...
-
Pelco c3419m - page 7
C3419M (8/06) 7 9. Configure DIP switches SW1 and SW2 located on the top of the dome drive. For DIP switch settings, refer to the labels located on the top of the dome drive or to the Switch Settings section of this manual. NOTE: When connecting more than one Spectra dome to a single controller , terminate the unit farthest from the controller . T ...
-
Pelco c3419m - page 8
8 C3419M (8/06) Switch Settings WARNING: If you are using D-type or P-type control, your system may not operate if the baud rate and address switches are not set correctly . The switches are set at the factory at the defaults for D-type control (2400 baud and address 1). T able D. Switch Settings for SW2 Special Systems Switch Number 123456789 1 0 ...
-
Pelco c3419m - page 9
C3419M (8/06) 9 T able E. Switch Settings for SW1, P-T ype Control NOTE: For Coaxitron controls, SW1 is not used; set all switches OFF . For D-type control systems, refer to T able F. T able F . Switch Settings for SW1, D-T ype Control NOTE: For Coaxitron controls, SW1 is not used; set all switches OFF . For P-type control systems, refer to T able ...
-
Pelco c3419m - page 10
10 C3419M (8/06) SPECTRA ADDRESS SWITCH SETTING SW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-8 71 ON ON ON OFF OFF OFF ON OFF 72 OFF OFF OFF ON OFF OFF ON OFF 73 ON OFF OFF ON OFF OFF ON OFF 74 OFF ON OFF ON OFF OFF ON OFF 75 ON ON OFF ON OFF OFF ON OFF 76 OFF OFF ON ON OFF OFF ON OFF 77 ON OFF ON ON OFF OFF ON OFF 78 OFF ON ON ON OFF OFF ON OFF 7 ...
-
Pelco c3419m - page 11
C3419M (8/06) 11 SPECTRA ADDRESS SWITCH SETTING SW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-8 151 ON ON ON OFF ON OFF OFF ON 152 OFF OFF OFF ON ON OFF OFF ON 153 ON OFF OFF ON ON OFF OFF ON 154 OFF ON OFF ON ON OFF OFF ON 155 ON ON OFF ON ON OFF OFF ON 156 OFF OFF ON ON ON OFF OFF ON 157 ON OFF ON ON ON OFF OFF ON 158 OFF ON ON ON ON OFF OFF ON 1 ...
-
Pelco c3419m - page 12
12 C3419M (8/06) SPECTRA ADDRESS SWITCH SETTING SW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-8 223 ON ON ON ON ON OFF ON ON 224 OFF OFF OFF OFF OFF ON ON ON 225 ON OFF OFF OFF OFF ON ON ON 226 OFF ON OFF OFF OFF ON ON ON 227 ON ON OFF OFF OFF ON ON ON 228 OFF OFF ON OFF OFF ON ON ON 229 ON OFF ON OFF OFF ON ON ON 230 OFF ON ON OFF OFF ON ON ON 231 ...
-
Pelco c3419m - page 13
C3419M (8/06) 13 Specifications GENERAL Construction Back Box Aluminum Dome Drive Aluminum, thermoplastic Lower Dome Clear polycarbonate, 0.090-inch thick Cage Thickness 0.12 x 0.30-inch cast stainless steel Cage Color Black, for maximum discreetness Cable Entry (Back Box) 0.75-inch conduit fitting Pan Movement 360° continuous pan rotation V ert ...
-
Pelco c3419m - page 14
14 C3419M (8/06) The materials used in the manufacture of this document and its components are compliant to the requirements of Directive 2002/95/EC This equipment contains electrical or electronic components that must be recycled properly to comply with Directive 2002/96/EC of the European Union regarding the disposal of waste electrical and elect ...
-
Pelco c3419m - page 15
PRODUCT WARRANTY AND RETURN INFORMA TION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FR/FT/FS Series fiber optic products and TW3000 Series unshielded twisted ...
-
Pelco c3419m - page 16
W orldwide Headquarters 3500 Pelco W ay Clovis, California 93612 USA USA & Canada T el: 800/289-9100 Fax: 800/289-9150 International T el: 1-559/292-1981 Fax: 1-559/348-1120 www .pelco.com ISO 9001 Australia | Canada | Finland | France | Italy | Russia | Singapore | Spain | Sweden | The Netherlands | United Arab Emirates | United Kingdom | Unit ...
Pelco c3419mについてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもPelco c3419mの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがPelco c3419mで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。