-
Bunn MCPA - page 1
USE AND CARE OF YOUR My Café ™ T ea & Coffee Pod Brewer P2896 Model MCP A COMMERCIAL AND HOUSEHOLD TYPE The Bunn logo is a registered trademark of Bunn-O-Matic Corporation. My Café is a trademark of Bunn-O-Matic Corporation. 36989.0001B 10/05 ©2005 BUNN-O-MA TIC CORPORA TION ® MODEL: SERIAL NUMBER: Record these numbers from the bottom of ...
-
Bunn MCPA - page 2
2 Hazardous Voltage! Can Cause Fire Or Electrical Shock! Do Not Disassemble The Brewer! There Are No User Serviceable Parts Inside! The only user replacement parts are shown on page 19. Repair Should Be Done By Authorized Service Personnel! T ABLE OF CONTENTS WARNINGS ................................................................................. ...
-
Bunn MCPA - page 3
3 USER NOTICES Carefully read and follow all notices on the equipment and in this manual. They were written for your protection. All notices on the equipment should be kept in good condition. Replace any unreadable or damaged labels by visiting our web site at www .bunn.com. INTRODUCTION The BUNN ® My Café ™ T ea & Coffee Pod Brewer is desi ...
-
Bunn MCPA - page 4
4 IMPOR T ANT SAFEGUARDS Follow these basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, and/or personal injury: • Read all instructions. • Do not touch hot surfaces. Use handles or knobs. • T o protect against electric shock, do not place cord, plug, or brewer in water or liquid. • Close ...
-
Bunn MCPA - page 5
5 • Use CAUTION when dispensing hot water from the brewer . The water from your BUNN ® Pod brewer is approximately 93°C (200°F). This is approximately 10°C (50°F) hotter than the hot water from your faucet and must be handled with care. • This brewer is designed to remain plugged in at all times (except during initial installation, cleanin ...
-
Bunn MCPA - page 6
6 FIG 1. Exploded View FIG 2. Control Panel WA TER RESERVOIR SLIDE LID POD HOLDER RELEASE BUTTON POD HOLDER INSERT POD HOLDER DRIP TRA Y GRA TE DRIP TRA Y POWER SWITCH CONTROL P ANEL VOLUME CONTROL SLIDE LEVER HEA TING INDICA TOR REFILL WA TER INDICA TOR POD HOLDER INDICA TOR COFFEE BREW BUTTON* TEA BREW BUTTON* VOLUME CONTROL INDICA TORS P2897 P28 ...
-
Bunn MCPA - page 7
7 DEFINITIONS COMPONENTS • WA TER RESERVOIR - Holds reserve water for brewing. The reser voir can be removed and filled separately at a sink or other clean water source or by pouring water through the slide lid. (Holds 1.7 L (46 oz.) to the maximum line.) • SLIDE LID - The slide lid allows access to the reservoir . Water can be poured through ...
-
Bunn MCPA - page 8
8 • HEA TING INDICA TOR - This light indicates that the heater is bringing water up to temperature. A brew cycle cannot be started until the indicator has gone out. (During a brew cycle, this light will come on indicating the tank heater is warming the new water entering the tank.) • POD HOLDER INDICA TOR - This indicator identifies a missing ...
-
Bunn MCPA - page 9
9 INITIAL BREWER SET -UP 1. Remove the lid and water reservoir . (CAUTION: Do not place the brewer in a sink or other water source.) 8. Place a mug or bowl that will hold at least 414 ml (14 fl. oz.) onto the drip tray grate. 4. Replace the reservoir and lid and close the slide lid. 9. Press and release the coffee brew button to fill the internal ...
-
Bunn MCPA - page 10
10 BREWING DELICIOUS COFFEE OR TEA (CAUTION: Do not place brewer in sink or other water source.) (NOTE: Minimum volume is approx. 118 ml (4 oz.) Maximum is approx. 355 ml (12 oz.) Settings are in 30 ml (1 oz.) increments.) 5. Place a mug, larger than the volume selected, on the drip tray grate below the pod holder outlet. 6. Press and hold the pod ...
-
Bunn MCPA - page 11
11 HOT W A TER The same basic steps used to brew coffee or tea can be used to obtain hot water by leaving the coffee pod or tea bag/pod out of the pod holder . CAUTION: The water from your BUNN ® Pod brewer is approximately 93°C (200°F). This is hotter than the hot water from your faucet and must be handled with care. COFFEE FUNDAMENT ALS Brewin ...
-
Bunn MCPA - page 12
12 ROUTINE CLEANING Before beginning any cleaning procedure, unplug the brewer to avoid the accidental start of a brew cycle. Clean the pod holder , drip tray and drip tray grate after each use, using a damp cloth and mild detergent and rinse. With the pod holder and drip tray removed, use a damp cloth with mild detergent to wipe the area below the ...
-
Bunn MCPA - page 13
13 8) When the cycle has finished, empty the cup. Repeat step 7 at least two more times to remove the solution from the tank. 9) Clean the pod holder with a mild detergent and rinse thoroughly . 10) Proceed to the “Cleaning The Sprayhead/Seal” section. CLEANING THE SPRA YHEAD/SEAL 1) Press the Power Switch into the off “O” position. 2) Unp ...
-
Bunn MCPA - page 14
14 INSPECTING THE SPRA YHEAD SEAL When disassembling your brewer for cleaning, inspect the sprayhead seal for cracks, tears and holes. Although the seal should last for an extended period of time, damage can occur through handling. CAUTION: The seal confines the hot liquid to the pod holder . Replace the seal if it becomes damaged. Parts are avail ...
-
Bunn MCPA - page 15
15 TROUBLESHOOTING SITUA TION EXPLANA TION Nothing happens when the COFFEE BUTTON or TEA BUTTON is pressed. This is the first time you have used your brewer . The Initial Brewer Set-up procedure must be performed first. Please follow the directions on page 9 before attempting to run a brew cycle. Y our brewer is not plugged in. Check to make sure ...
-
Bunn MCPA - page 16
16 SITUA TION EXPLANA TION The REFILL WA TER INDICA TOR has come on. The POD HOLDER INDICA TOR has come on. The water shuts off and comes back on again when brewing. The WA TER RESERVOIR has run low on water . Slide the lid open and pour additional water into the reservoir , or remove the reser voir and fill it at a sink, or other water source. CA ...
-
Bunn MCPA - page 17
17 TROUBLESHOOTING (Cont.) SITUA TION EXPLANA TION The Pod Holder will not come out of the brewer . Water is appearing on the counter around the base of the brewer . Water leaks out around the sprayhead. The pod in the POD HOLDER may have swelled to a point where the holder does not slide out easily . Wait at least 10 minutes and then try carefully ...
-
Bunn MCPA - page 18
18 SITUA TION EXPLANA TION The BUNN ® (POD HOLDER RELEASE BUTTON) indicator is not on all of the time. The HEA TING INDICA TOR comes on when the COFFEE or TEA button is pressed. The HEA TING INDICA TOR comes on during a brew cycle. When the BUNN ® button (Also known as the POD HOLDER RELEASE BUTTON) is lit, this indicates that the power to the ma ...
-
Bunn MCPA - page 19
19 BUNN ® REPLACEMENT P ARTS SLIDING LID Dishwasher Safe. POD HOLDER Dishwasher safe. WA TER RESERVOIR Holds 1.7 L (46 oz.) of fresh water for quick brewing. Dishwasher safe. DRIP TRA Y AND GRA TE Dishwasher safe. Catches up to 177 ml (6 oz.) of liquid. SPRA YHEAD Precision Jetstream ™ sprayhead for full flavor extraction. T o purchase replacem ...
-
Bunn MCPA - page 20
20 LIMITED W ARRANTY Bunn-O-Matic Corporation (“Bunn” or “we”) warrants to the original user (the “buyer” or “you”) of this Pod Brewer that the Pod Brewer is free from defects in material and workmanship existing at the time of manufacture and appearing within two years of the date of original purchase of the Pod Brewer . If such a ...
Bunn MCPAについてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもBunn MCPAの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがBunn MCPAで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。