Winegard MV-0099の取扱説明書

12ページ 0.26 mb
ダウンロード

ページに移動 of 12

Summary
  • Winegard MV-0099 - page 1

    1 Movin’ View TM Digital Satellite Mobile Antenna for Single Receiver Model MV-0099 Made in the U.S.A. U.S. Patent Nos. 6,023,247; 6,188,300 Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 319/754-0600 • FAX 319/754-0787 • www.winegard.com Printed in U.S.A. © Winegard Company 2002 2451007 Rev. 2/10/04 WINEGARD Æ ...

  • Winegard MV-0099 - page 2

    2 DIRECTV Æ is an official trademark of DIRECTV , a unit of GM Hughes Electronics Corporation. DISH Network TM is an official trademark of EchoStar Communications Corporaton. DIGITAL BROADCAST SYSTEM SATELLITE(S) Introduction Congratulations! Y ou have purchased one of W inegardí s latest developments in the mobile satel- lite reception product l ...

  • Winegard MV-0099 - page 3

    3 2. Determine which programming you will be using. This will determine how you set your switches. For DIRECTV Æ set switches to 101 ∞ . NOTICE! This model is PRESET for DISH Network TM receivers. If you have a DIRECTV ® or ExpressVu ® (Canada) receiver, you must change the numbered switches inside the dome. For Expr essV u Æ , set switches t ...

  • Winegard MV-0099 - page 4

    4 2. After signal is acquired, the system will continuously fine-tune for 8 minutes. At the end of 8 minutes, it will enter sleep mode. Y ou have 6 minutes to complete Check Switch test. Consult DISH receiver manual. 3. During the Check Switch T est, the receiver will be- gin checking your switch by toggling between satellites. When this is complet ...

  • Winegard MV-0099 - page 5

    5 6. T o check voltage at connections, see Figure 9 on page 10. FOLLOW THE NUMERICAL SE- QUENCE ON THE DRA WING AND CHECK VO L T AGE A T : #1. LNBF voltage. Disconnect the coax cable from the LNBF . Check voltage from the middle wire to the shield. There should be +12 to +19 VDC. If no voltage is present , make sure receiver is on and check again f ...

  • Winegard MV-0099 - page 6

    6 1 lar ge yellow spade connector 2 small red spade connectors All required screws and washers 1 base with electronics, dish, single LNBF 1. Open box and remove packing material. 2. Lift unit out of box vertically . Do not turn box and ì r ollî out, or turn upside down to r emove. ! USE 2 PEOPLE when removing the unit from the carton. Parts Inclu ...

  • Winegard MV-0099 - page 7

    7 Installation Diagram FRONT OF VEHICLE REAR BASE FOOT MUST DIRECTLY FACE REAR OF VEHICLE REAR FOOT REFLECTOR AZ MOTOR GPS ANTENNA SWITCH LOCATION BASE FOOT EL MOTOR POWER SUPPLY BASE FOOT HEYCO CONNECTORS FIGURE 1 DVB ...

  • Winegard MV-0099 - page 8

    8 6. Clean roof area where the base feet will be at- tached to the roof. Do not erase your marks! 7. Put approved sealant in the area under the base foot location. 8. After all base brackets are secured to roof, put sealant on top of foot and screws. FIGURE 2 ! Installation Install in DRY conditions only! Installing unit on roof of vehicle — IMPO ...

  • Winegard MV-0099 - page 9

    9 Installation The GPS antenna is pre-wired and has a 1 meter foot cable running through one of the Heyco Æ connectors. Determine location for GPS antenna. It is recom- mended you place the GPS antenna 1 meter from dome. The recommended location for the GPS antenna is based on having a level location and a clear view of the sky for the best satell ...

  • Winegard MV-0099 - page 10

    10 1. Connnect the coax cable from the roof to the ìSatellite Inî connection on the receiver . (A dual receiver upgrade kit is available. Contact W inegard Company for more information.) CONNECTING THE RECEIVER — Installation • Wiring Satellite Receiver Initializing — 1. Be sure vehicle is in a location free of all obstruc- tions and with a ...

  • Winegard MV-0099 - page 11

    11 Base Diagram FIGURE 6 TO DVB TO LNBF CONTROL BOX DETAIL DO NOT USE AZ MOTOR EL MOTOR 8-PIN POWER T A CONTROL BOX (DETAIL BELOW) POWER SUPPLY POWER SUPPLY (POWER WIRE, SEE DETAIL) #3 COAX CABLE AT CONTROL BOX #2 CONTROL BOX TO LNBF EL MOTOR AZ MOTOR GPS ANTENNA DVB DVB BACK OF VEHICLE HEYCO CON- NECTORS #1 LNBF VOLTAGE ...

  • Winegard MV-0099 - page 12

    12 Winegard Company ï 3000 Kirkwood S treet ï Burlington, IA 52601 ï 319/754-0600 Fax 319/754-0787 ï www .winegard.com Printed in U.S.A. © 2002 Winegard Company 2451007 Rev . 2/10/04 TWO YEAR LIMITED WARRANTY Winegard Company warrants this Winegard product (excluding receiver) against any defects in materials or workmanship within two (2) year ...

メーカー Winegard カテゴリー Stereo System

Winegard MV-0099のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- MV-0099の取扱説明書
- Winegardの製品カード
- パンフレット
- またはWinegard MV-0099の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Winegard MV-0099の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Winegard MV-0099の取り付け説明書、サービスマニュアル、簡易説明書、またはWinegard MV-0099のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Winegard MV-0099の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Winegard MV-0099デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがWinegard MV-0099を使用するのを助ける技術的文書のことです。説明書は通常、全てのWinegard MV-0099ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Winegardの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Winegard MV-0099の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははWinegard MV-0099の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Winegard MV-0099に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Winegard MV-0099デバイスの基本機能を使うにあたってのヒント。 Winegard MV-0099のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Winegard MV-0099に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるWinegard MV-0099のメーカー/サービスへの連絡先に関する情報。

Winegard MV-0099についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもWinegard MV-0099の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがWinegard MV-0099で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)