Konica Minolta TC-Xの取扱説明書

22ページ 1.88 mb
ダウンロード

ページに移動 of 22

Summary
  • Konica Minolta TC-X - page 1

    Konica TC-X posted 5-11-'03 This camera manual library is for reference and historical purposes, all rights reserved. This page is copyright by mike@butkus.org, M. Butkus, NJ. This page may not be sold or distributed without the expressed permission of the producer I have no connection with any camera company On-line camera manual library If y ...

  • Konica Minolta TC-X - page 2

    (4) A new design extremely bright viewfinder makes accurate focusing easier, increases visibility of in-finder data. (5) Accepts the full range of Hexanon interchangeable lenses and a wide range of Konica accessories, including a electronic flash unit. *DX: Films designed for use in DX Code System cameras. The Konica TC-X can accept this film. Koni ...

  • Konica Minolta TC-X - page 3

    Film advance: Single action top lever, wind angle of 135°, 20° play. Film rewind: Crank driven rewind mechanism, film rewind button resets automatically Frame counter: Additive type, auto-reset 4.butkus.org Size, weight: Body 130 x 84 x 44mm ( 5. I I x 3.11 1 x 1.73"). 375g ( 13.2 oz) (without battery) Note: Specifications and design subject ...

  • Konica Minolta TC-X - page 4

    1. Changing the lens ...

  • Konica Minolta TC-X - page 5

    1. Changing the lens Attaching the lens: Align the red dot on the lens barrel with the red dot (22) on the camera body and gently insert the lens barrel into the camera. Grip the lens and turn clockwise until it locks. Removing the lens: While the lens release button (25) is kept depressed, turn the lens barrel counterclockwise until the red dots o ...

  • Konica Minolta TC-X - page 6

    2 . Inserting Battery The Konica TC-X uses a single LR03, R03 dry battery (AAA size) as the power source for the AE system 4.butkus.org 1) Open the battery chamber cover (36) by pushing the cover in (he direction of the arrow. 2) Place a fresh battery in the chamber, making sure that the " + " and "" -- "" poles of the ...

  • Konica Minolta TC-X - page 7

    3. Power switch The power switch functions as the power ON-OFF/shutter release button safety lock system. 1) When the power switch (2) is turned "ON" the light meter is activated and the shutter release is unlocked. 2) When the switch is turned "OFF the meter is turned off and the shutter release locks. *When the camera is not in use ...

  • Konica Minolta TC-X - page 8

    1) When the film speed dial (14) is set at "DX" " the camera automatically reads the film speed of the film magazine, so manual film speed setting is unnecessary. This is only effective with "DX" type films. 2) When non-Ding type film is used, turn the film speed dial (14) to set the camera for the rating of the film. 4.but ...

  • Konica Minolta TC-X - page 9

    5. Loading film ...

  • Konica Minolta TC-X - page 10

    5. Loading film 1) Turn the power switch (2) "on." Pull the rewind knob (16) all the way out and the back cover (37) of the camera will open. 2) Place a roll film into the film cassette chamber (31), then push the rewind knob all the way back down. 3) Pull the tip of the film out a few centimeters until it reaches the film take-up spool ( ...

  • Konica Minolta TC-X - page 11

    (6) Turn the film advance lever (1) as far as it turns and press the shutter release button (7). Repeat until the number " I " appears in the frame counter (26). *When the film is advancing properly, the film rewind knob will turn counterclockwise. *Film should be loaded or unloaded in the shade or indoors, avoiding direct sunlight. 4.but ...

  • Konica Minolta TC-X - page 12

    6. Automatic exposure system (AE) 1) Set the aperture ring (7) at the "AK" mark (18), and the aperture ring is then locked. 2) Turn the shutter speed dial (3) and set it at the desired speed. With ISO 100 film, for example, a typical shutter speed for shooting outdoors in clear weather is 1/125 or 1/250 see, 1/30 or 1/60 for indoors. *The ...

  • Konica Minolta TC-X - page 13

    Microdiaprism Split image Matted plane Focus at the center of the viewfinder When focusing, point the camera directly at the main subject (area of the picture that is most important), to use the split image and microdiaprism for precise focusing. Split image: The lens is focused when the upper and lower halves of the image in the center of the find ...

  • Konica Minolta TC-X - page 14

    clear when using the camera with close-up attachment and telephoto lens, for example. Checking the exposure Checking the aperture: The correct aperture setting for the shutter speed to which the camera is set will be shown by the needle in the finder. The camera will automatically select this aperture when the shutter is pressed. * The proper expos ...

  • Konica Minolta TC-X - page 15

    7. Unloading film 7. Unloading film After shooting a whole roll of film, the film must be rewound before being removed from the camera. 1) With "DX" type film, the roll is finished when the number in the frame counter (26) is the same as the number in the film check window (41). To rewind film: 2) Push the film rewind button (34) down. 8. ...

  • Konica Minolta TC-X - page 16

    3) Flip up the film rewind crank (15) and turn it in the direction of the arrow. 4) When film is completely rewound, rewind crank will turn freely. Then open the back cover and remove the film magazine for processing. 8. Operation in manual mode Stopped-down metering: When am extension ring or bellows is used for close- up photography, or under oth ...

  • Konica Minolta TC-X - page 17

    1) Press the AE release button (24) and turn the aperture ring (7) to set the aperture manually. *A red warning mark will appear m the finder to show that the camera is set for manual aperture control. 2) Correct exposure can be obtained by turning the aperture ring or shutter speed dial (3), while looking through the finder, until the meter needle ...

  • Konica Minolta TC-X - page 18

    9. Using the self-timer 9. Using the self-timer Turn the self-timer lever (10) counterclockwise (in the direction of the arrow) as far as it goes. Then press the shutter release button. The shutter will be released automatically in approx. 10 seconds Exposure meter range - CLICK HERE FOR METER RANGE CHART Depending on the ISO rating (film speed) of ...

  • Konica Minolta TC-X - page 19

    1) Attach the Konika X-20N AUTO to the hot shoe (13) on the camera. 2) Switch from AE to manual aperture mode and set the aperture at f/4 (ISO 100) or at f/8 (ISO 400), according to the film speed. 3) Set the shutter speed to 1/60 sec. 4.butkus.org 4) Set the power switch of the electronic flash at "A" and wait until the Flash Ready Light ...

  • Konica Minolta TC-X - page 20

    Bright subject, dark background If the subject in the frame is brightly lit (ea. by direct sunlight) and the background is dark, the subject will be overexposed in normal AE photography. To prevent this, move up close to the subject and press the shutter half way down to lock the AE mechanism. Then move back to frame and shoot the picture you want. ...

  • Konica Minolta TC-X - page 21

    Using depth of field Depth of field is the range in front of and behind the point on which the lens is actually focused which also appears In sharp focus in the photograph. It has the following features: 1) The smaller the lens aperture ("F" stop) the greater the depth of field. 2) Wide angle lenses have greater depth 4.butkus.org 3) Dept ...

  • Konica Minolta TC-X - page 22

    A. Depth-of-field for f/16 B. Depth of field for F4 C. Depth-of-field scale D. Distance/Aperture scale index mark E. Infrared mark F. Distance scale ...

メーカー Konica Minolta カテゴリー Digital Camera

Konica Minolta TC-Xのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- TC-Xの取扱説明書
- Konica Minoltaの製品カード
- パンフレット
- またはKonica Minolta TC-Xの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Konica Minolta TC-Xの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Konica Minolta TC-Xの取り付け説明書、サービスマニュアル、簡易説明書、またはKonica Minolta TC-Xのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Konica Minolta TC-Xの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Konica Minolta TC-Xデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがKonica Minolta TC-Xを使用するのを助ける技術的文書のことです。説明書は通常、全てのKonica Minolta TC-Xユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Konica Minoltaの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Konica Minolta TC-Xの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははKonica Minolta TC-Xの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Konica Minolta TC-Xに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Konica Minolta TC-Xデバイスの基本機能を使うにあたってのヒント。 Konica Minolta TC-Xのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Konica Minolta TC-Xに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるKonica Minolta TC-Xのメーカー/サービスへの連絡先に関する情報。

Konica Minolta TC-Xについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもKonica Minolta TC-Xの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがKonica Minolta TC-Xで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)