Wolf W302210Iの取扱説明書

24ページ 1.42 mb
ダウンロード

ページに移動 of 24

Summary
  • Wolf W302210I - page 1

    I NST ALLA TION I NSTR UCTIONS P RO W ALL V ENTILA TION H OODS ...

  • Wolf W302210I - page 2

    As you follow these instructions, you will notice W ARNING and CAUTION symbols. This blocked information is important for the safe and efficient installation of Wolf equip- ment. There are two types of potential hazards that may occur during installation. Another footnote we would like to identify is IMPORT ANT NOTE: This highlights informa- tion t ...

  • Wolf W302210I - page 3

    3 INST ALLA TION REQUIREMENTS IMPORT ANT NOTE: This installation must be completed by a qualified installer or W olf authorized service center technician. Installer: Please read the entire Installation Instructions prior to installation. Save these instructions for the local inspector’ s refer- ence, then leave them with the homeowner . Homeowner ...

  • Wolf W302210I - page 4

    4 W OLF PRO W ALL VENTILA TION HOODS IMPORT ANT NOTE: W olf recommends that the Pro wall ventilation hood be installed 30" (762) to 36" (914) above the countertop. Rail option (R) wall hoods come with a classic stainless steel decorative rail and stand-offs. Optional platinum or brass rails are available to match W olf dual fuel range bez ...

  • Wolf W302210I - page 5

    5 Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION INSTRUCTIONS 10" (254) O VERALL HEIGHT O VERALL WIDTH 4" (102) 22" (559) O VERALL DEPTH 12" (305) 2" (51) 3 / 4 " (19) DIAMETER OF RAIL O VERALL WIDTH 4" (102) 24" (610) O VERALL DEPTH 12" (305) 18" (457) O VER ...

  • Wolf W302210I - page 6

    6 W OLF PRO W ALL VENTILA TION HOODS 30" TO 36" (762 –914) TO COUNTER T OP 30" TO 36" (762 –914) TO COUNTER T OP 10" (254) 18" (457) HEIGHT OF HOOD 22" (559) 24" (610) DEPTH OF HOOD WIDTH OF HOOD NOTE: Low-profile and 24" (610) deep wall hoods have a v ertical or hor izontal discharge; discharge dire ...

  • Wolf W302210I - page 7

    7 Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION INSTRUCTIONS INST ALLA TION SPECIFICA TIONS The following chart provides dimensions specific to each wall hood model. These dimensions are critical for proper installation. Also refer to the illustration below . Low-Profile Wall Hoods Model (A) (B) (C) (D) W30 ...

  • Wolf W302210I - page 8

    8 LO W -PROFILE AND 24" (610) HOODS STEP 1: INST ALL DUCTW ORK IMPORT ANT NOTE: W olf recommends that the Pro wall ventilation hood be installed 30" (762) to 36" (914) above the countertop. IMPORT ANT NOTE: Consult a qualified HV AC Engineer for specific ducting applications. IMPORT ANT NOTE: All W olf Pro wall hoods must exhaust to ...

  • Wolf W302210I - page 9

    LO W -PROFILE AND 24" (610) HOODS Always install a roof or wall cap if you are not installing a remote blower . Connect 8" (203) round metal ductwork for low-profile hoods or 10" (254) round metal ductwork for 24" (610) deep hoods to the cap and work back towards the hood. Use duct sealing tape on joints between ductwork section ...

  • Wolf W302210I - page 10

    10 W OLF PRO W ALL VENTILA TION HOODS A CCESSORIES Optional acces- sories are available through your Wolf dealer . T o obtain local dealer information, visit the Locator section of our website, wolfappliance.com. LO W -PROFILE AND 24" (610) HOODS STEP 2: W ALL PREP ARA TION Construct the wood wall framing flush with the wall studs and centered ...

  • Wolf W302210I - page 11

    11 Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION INSTRUCTIONS 17 " (432) 8" (203) W all Cut-Out Area Hood Centerline 4 1 /2 " (114) 4 11 /16 " (119) 4" (102) T ransition Centerline Wall cut-out for low-profile hoods – horizontal discharge 21" (533) W all Cut-Out Area Hood Cen ...

  • Wolf W302210I - page 12

    12 W OLF PRO W ALL VENTILA TION HOODS Rough-In Plate Mounting Holes Soffit Hood installation LO W -PROFILE AND 24" (610) HOODS STEP 5: INST ALL THE HOOD IMPORT ANT NOTE: If a backsplash is to be used, it should be installed before the wall hood is mounted. Align the hood assembly with the marked location. Install the #10 x 2" (59) screws ...

  • Wolf W302210I - page 13

    13 Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION INSTRUCTIONS 30" TO 36" (762 –914) COUNTERT OP TO BO TT OM OF VENTILA TION HOOD 18" (457) HEIGHT OF HOOD W ALL HOOD DUCTWORK INST ALLA TION THROUGH ROOF 36" (914) ST ANDARD FLOOR TO COUNTERT OP HEIGHT 27" (686) DEPTH OF HOOD 10" ...

  • Wolf W302210I - page 14

    The hood assembly is shipped with the rough-in plate / transition attached. The transition is shipped upside down in the top of the hood. It must be removed and rein- stalled in the proper position. Remove the filters by pushing each filter up at the angle it is placed in, and rotate down. Remove the center filter first. Then take out the grease cu ...

  • Wolf W302210I - page 15

    15 Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION INSTRUCTIONS Rough-In Plate Soffit Mounting Holes Hood installation 27" (686) DEEP W ALL HOODS If you are installing WBLOWER-90INT or WBLOWER-120INT , refer to the internal blower information on page 17 and follow installation instructions provided with ...

  • Wolf W302210I - page 16

    Remove the electrical box cover from the rough-in plate. Connect black wire to power supply black wire, white wire to power supply white wire and green wire to green wire or bare wire. Place all wiring connections inside the elec- trical box and reinstall on the rough-in plate in the upper right-hand corner . Make sure that the wires are secure and ...

  • Wolf W302210I - page 17

    17 Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION INSTRUCTIONS INTERNAL BLO WERS IMPORT ANT NOTE: Refer to the specific installation instructions provided with each internal blower for additional mounting and wiring instructions. IMPORT ANT NOTE: Use wire connectors or wire nuts approved by UL or C/UL. IMPOR ...

  • Wolf W302210I - page 18

    18 W OLF PRO W ALL VENTILA TION HOODS A CCESSORIES Optional acces- sories are available through your Wolf dealer . T o obtain local dealer information, visit the Locator section of our website, wolfappliance.com. 11 3 / 4 " (298) 21 1 / 2 " (546) 24 3 / 8 " (619) 18 1 / 2 " (470) 12 1 / 4 " (311) 4 1 / 2 " (114) IN-LIN ...

  • Wolf W302210I - page 19

    19 Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION INSTRUCTIONS IN-LINE AND REMO TE BLO WERS BLO WER WIRING IMPORT ANT NOTE: Refer to the specific installation instructions provided with each blower for additional wiring instructions. Follow wiring instructions at the blower as outlined in the specific instal ...

  • Wolf W302210I - page 20

    20 W OLF PRO W ALL VENTILA TION HOODS REMO TE BLOWERS BLOWER-60REM (801640) – 600 CFM remote blower for low-profile wall hoods (except Models W302210I and W362210I), and Models W302418 and W302718. BLOWER-90REM (801641) – 900 CFM remote blower for low-profile wall hoods (except Models W302210I and W362210I), and 24" (610) and 27" (686 ...

  • Wolf W302210I - page 21

    21 Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION INSTRUCTIONS A CCESSORIES Optional acces- sories are available through your Wolf dealer . T o obtain local dealer information, visit the Locator section of our website, wolfappliance.com. INST ALL FIL TERS / GREASE CUPS Remove all packaging material from the ...

  • Wolf W302210I - page 22

    22 CONT ACT INFORMA TION Wolf Customer Service: 800-332-9513 Website: wolfappliance.com TROUBLE SHOO TING IMPORT ANT NOTE: If the Pro wall ventilation hood does not operate properly , follow these troubleshooting steps: V erify that power is being supplied to the ventilation hood. Check electrical connections to ensure that the installation has bee ...

  • Wolf W302210I - page 23

    23 CUT -OUT FOR LOGO PLACEMENT BO TT OM EDGE OF HOOD FOLD LINE FOR LOGO PLACEMENT LEFT OUTER EDGE OF HOOD ...

  • Wolf W302210I - page 24

    809340 7 / 2006 WOLF APPLIANCE COMP ANY , INC. P . O. BO X 44848 MADISON, WI 53744 800-332-9513 W OLF APPLIANCE.COM ...

メーカー Wolf カテゴリー Ventilation Hood

Wolf W302210Iのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- W302210Iの取扱説明書
- Wolfの製品カード
- パンフレット
- またはWolf W302210Iの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Wolf W302210Iの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Wolf W302210Iの取り付け説明書、サービスマニュアル、簡易説明書、またはWolf W302210Iのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Wolf W302210Iの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Wolf W302210Iデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがWolf W302210Iを使用するのを助ける技術的文書のことです。説明書は通常、全てのWolf W302210Iユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Wolfの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Wolf W302210Iの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははWolf W302210Iの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Wolf W302210Iに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Wolf W302210Iデバイスの基本機能を使うにあたってのヒント。 Wolf W302210Iのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Wolf W302210Iに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるWolf W302210Iのメーカー/サービスへの連絡先に関する情報。

Wolf W302210Iについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもWolf W302210Iの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがWolf W302210Iで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)