-
Miele DAR 1220 - page 1
Installation Instr uctions DAR 1120, DAR 1130 en - CA DAR 1150, DAR 1220 DAR 1230, DAR 1250 Installation, repair and maintenance work should be performed by a Miele authorized service technician in accordance with national and local safety regulations and the provided installation instructions. ...
-
Miele DAR 1220 - page 2
Disposal of packing material The cardboard box and packing materials protect the appliance during shipping. They have been designed to be biodegradable and recyclable. Please recycle. , DANGER Ensure that any plastic wrappings, bags, etc., are disposed of safely and kept out of the reach of babies and young children. Danger of suffocation! Disposal ...
-
Miele DAR 1220 - page 3
Appliance dimensions 19 ...
-
Miele DAR 1220 - page 4
Appliance dimensions 20 ...
-
Miele DAR 1220 - page 5
a The hood with exhaust collar is only used in air venting mode with an internal or external blower. b Installation area; Wall/ceiling area respectively for vent hole and outlet installation. For recirculation mode only the outlet installation is required. Appliance dimensions 21 ...
-
Miele DAR 1220 - page 6
a The hood with exhaust collar is only used in air venting mode with an internal or external blower. b Installation area; Wall/ceiling area respectively for vent hole and outlet installation. For recirculation mode only the outlet installation is required. Appliance dimensions 22 ...
-
Miele DAR 1220 - page 7
a Installation area; Wall/ceiling area respectively for vent hole and outlet installation. Appliance dimensions 23 ...
-
Miele DAR 1220 - page 8
Distance between cooktop and hood (S) Do not install this exhaust hood over cooktops burning solid fuel. Observe the cooktop manufacturer's instructions when determining the distance between cooktop and lower edge of the hood. Unless the instructions require a greater distance, the adjacent minimum safety distances apply for Miele cooktops. ? ...
-
Miele DAR 1220 - page 9
Distance between cooktop and hood (S) Miele Range Wall / Insert Hood DAR 1120, DAR 1220 (30") DAR 1130, DAR 1230 (36") DAR 1150, DAR 1250 (48") Internal / External blowers DRIB/DREB XL (700 cfm) DRIB/DREB XL (700 cfm) DRIB/DREB XXL (1100 cfm) DRIB/DREB XXL (1100 cfm) Miele Electric Cooktops 24" (610 mm) Miele Electric Barbeques ...
-
Miele DAR 1220 - page 10
The majority of the weight of the installed ventilation system will be supported by the retaining plate. It must be firmly attached to the stud framing behind the drywall. If studs are not available in the required locations, a plywood backing (min. ½" (13 mm) thick) spanning at least two studs must be installed. Failure to adequately support ...
-
Miele DAR 1220 - page 11
Before installation read the information in the "Dimensions" and "Important Safety Instruction" chapters. Under certain conditions, there is a danger of poisonous fumes by when the ventilation system and a furnace drawing interior air run at the same time. Installation instructions The individual installation steps are described ...
-
Miele DAR 1220 - page 12
, WARNING Danger of toxic fumes. Gas cooking appliances release carbon monoxide that can be harmful or fatal if inhaled. To reduce the risk of fire and to properly exhaust air, the exhaust gases extracted by the hood should be vented outside of the building only. Do not vent exhaust air into spaces within walls or ceilings or in attics, crawl space ...
-
Miele DAR 1220 - page 13
– If the exhaust is ducted into an inactive flue, the air must be expelled parallel to the flow direction of the flue. Never connect an exhaust hood to an active chimney, dryer vent, flue, or room venting ductwork. Seek professional advice before connecting an exhaust hood vent to an existing, inactive chimney or vent flue. Important If the ductw ...
-
Miele DAR 1220 - page 14
, WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: All electrical work should be performed by a qualified electrician in strict accordance with national regulations (for USA: ANSI-NFPA 70) and local safety regulations. Installation, repairs and other work by unqualified persons could be dangerous. Ens ...
-
Miele DAR 1220 - page 15
Total connected load DAR 1120, DAR 1220 with DRIB XL or DREB XL ......6 2 1W DAR 1130, DAR 1230 with DRIB XL or DREB XL ......6 2 4W DAR 1130, DAR 1230 with DRIB XXL or DREB XXL ....8 0 9W DAR 1150, DAR 1250 with DRIB XXL or DREB XXL ....8 1 2W Overhead lights DAR 1120, DAR 1220 ........2x3W DAR 1130, DAR 1230 ........3x3W DAR 1150, DAR 1250 ...... ...
-
Miele DAR 1220 - page 16
32 ...
-
Miele DAR 1220 - page 17
33 ...
-
Miele DAR 1220 - page 18
34 ...
-
Miele DAR 1220 - page 19
35 ...
-
Miele DAR 1220 - page 20
M.-Nr. 10 219 920 / 01 en - US, CA DAR 1120, 1130, 1150 DAR 1220, 1230, 1250 ...
Miele DAR 1220についてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもMiele DAR 1220の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがMiele DAR 1220で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。