MartinLogan iの取扱説明書

24ページ 0.99 mb
ダウンロード

ページに移動 of 24

Summary
  • MartinLogan i - page 1

    C INEMA TM i user ’s manual c l s e l e c t r o s t a t i c M ART I N L OGA N ® ...

  • MartinLogan i - page 2

    2 Contents & Introduction C ONTENTS &I NTRODUCTION Contents & Introduction . . . . . . . . . . . . . . . . . . . . . . . . .2 Contents Introduction Installation in Brief . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Low- V oltage P ower Con ...

  • MartinLogan i - page 3

    Installation in Brief 3 I NST ALLA TION IN B RIEF W e know you are eager to hear your new Cinema i center channel, so this section is provided to allow fast and easy set up. Once you have it operational, please take the time to read, in depth, the rest of the information in this manual. It will give you perspective on how to attain the greatest pos ...

  • MartinLogan i - page 4

    Y our Cinema i speaker uses an external low-voltage power supply to energize its electrostatic panel. F or this reason the proper low-voltage power supply is provided. The power supply should be firmly inserted into the ‘P ower In ’ receptacle on the rear connection panel of the speaker , then to any convenient AC wall outlet (see figure 1). Y ...

  • MartinLogan i - page 5

    W e also recommend, if possible, that short runs of speaker cable connect the power amplifier and speaker and that high quality long interconnect cables be used to connect the preamplifier and power amplifier . This results in the power amplifiers being close to the speakers, which may be practically or cosmetically difficult, but if the length of ...

  • MartinLogan i - page 6

    6 Installation F or optimum performance the Cinema i must be tilted on its stand towards the main listening position and directed towards the audience’s ears (see figure 4). After you have placed your Cinema i in its final location, support the speaker with one hand and slightly loosen the large knobs with the other hand. T ilt the Cinema i to th ...

  • MartinLogan i - page 7

    Stand Options 7 NOTE: The Cinema i is intended for use with its stand attached in almost all installation options. Stand removal instructions are provided in case you are using a custom installation that does not require the use of the stand. Required hardware (included): (4) #8 x 3 / 4 ” Phillips head wood screws, (4) hollow rubber bumper feet R ...

  • MartinLogan i - page 8

    8 Stand Options 1 Prepare a flat surface with padding and sheets to protect the Cinema i as you work on it. Disconnect any wires and carefully place the Cinema i upside down on the work surface, using books or pieces of cardboard to keep the speaker from rocking . 2 Line up the 6 holes on the metal brackets (3 per side) with the threaded inserts on ...

  • MartinLogan i - page 9

    3 Using a 5 / 32 ” Allen tool remove the 6 allen bolts that attach the stand, 3 each side (figure 7, step B). 4 Remove the stand (figure 7, step C). 5 Unscrew the two large knobs and remove the center part of the stand. Set the 2 bolts, 2 rubber washers, 2 plastic washers and the large knobs nearby (figure 8, step D). 6 Locate and mark the center ...

  • MartinLogan i - page 10

    10 Remove the Cinema i stand from the wall and prepare the wall at each of the 5 marks using the procedure described in step 7 (figure 12, step I). 11 With the help of an assistant, place the center part of the stand against the wall and attach it using the (6) 1 “ Phillips head screws. T ighten the screws but be very careful not to over tighten ...

  • MartinLogan i - page 11

    Dispersion Interactions 11 The concave electrostatic panel launches a 30 degree dispersion pattern when viewed from above. The sound waves focus in front of the speaker and diverge much like a lens would cause light to focus and diverge. This horizontal dispersion field operates in the same manner as our traditional curvilinear line source (CLS) te ...

  • MartinLogan i - page 12

    12 Dispersion Interactions Figure 18–19. As can be seen here, point source concepts invite a great deal of room interaction. While delivering good frequency response to a large listening audience, imaging is consequently confused and blurred. Figure 20– 21. Even though they suffer from “venetian blind” effect, angled multiple panel speakers ...

  • MartinLogan i - page 13

    H OME T HEA TER Home Theater 13 Figure 24. Ascent i speakers as front channels, Cinema i as the center channel, Script i speakers as side surround (effects) channels, and Depth subwoofers as 0.1 (effects) channel. It had long been the practice of stereo buffs to connect their television to a stereo system. The advantage was the use of the larger sp ...

  • MartinLogan i - page 14

    How can sound be reproduced by something that you are able to see through? Electrostatic energy makes this possible. Where the world of traditional loudspeaker technology deals with cones, domes, diaphragms and ribbons that are moved with magnetism, the world of electrostatic loudspeakers deals with charged electrons attracting and repelling each o ...

  • MartinLogan i - page 15

    Since the beginning of audio, achieving smooth dispersion has been a problem for all loudspeaker designers. Large panel transducers present even more of a challenge because the larger the panel, the more directional the dis- persion pattern becomes. F ull range electrostats have long been one of the most problematic transducers because they attain ...

  • MartinLogan i - page 16

    16 Electrostatic Loudspeaker History E LECTROST A TIC L OUDSPEAKER H ISTORY In the late 1800s, any loudspeaker was considered exotic. T oday , most of us take the wonders of sound reproduction for granted. It was 1880 before Thomas Edison had invented the first phonograph. This was a horn-loaded diaphragm that was excited by a playback stylus. In 1 ...

  • MartinLogan i - page 17

    Electrostatic Loudspeaker History 17 developing a better instrument for testing microphone arrays. The test instrument needed an extremely accurate speaker , but Janszen found that the cone speakers of the period were too nonlinear in phase and amplitude response to meet his criteria. Janszen believed that electrostats were inherently more linear t ...

  • MartinLogan i - page 18

    18 Frequently Asked Questions F REQUENTL Y A SKED Q UESTIONS How do I clean my speak ers? Just use a dust free cloth or a soft brush to remove the dust from your speakers. W e recommend a specialty cloth (available at the Xtatic shop at www .martinlogan.com) that cleans your speakers better than anything else we have tried. Do not spray any kind of ...

  • MartinLogan i - page 19

    Frequently Asked Questions 19 Will excessive smok e or dust cause any problems with my electrostatic speak ers? Exposure to excessive contaminants such as smoke or dust may potentially affect the performance of the electrostatic membrane, and may cause discoloration of the diaphragm membrane. When not in use for extended periods, you should unplug ...

  • MartinLogan i - page 20

    20 Troubleshooting T ROUBLESHOOTING No Output • Check that all your system components are turned on. • Check your speaker wires and connections. • Check all interconnecting cables. W eak Output from Electrostatic P anel, Loss of Highs • Check the power cord. Is it properly connected to the speaker and to the wall? • Is the power cord conn ...

  • MartinLogan i - page 21

    The Cinema i hybrid speaker system consists of a broad- range single element electrostatic transducer integrated with a quick-response woofer . This approach takes advantage of the benefits that both technologies have to offer . Dispersion is a controlled 30 degrees. This was achieved by curving the electrostatic transducer element itself , an eleg ...

  • MartinLogan i - page 22

    AC. Abbreviation for alternating current. Active crossover . Uses active devices (transistors, ICs, tubes) and some form of power supply to operate. Amplitude. The extreme range of a signal. Usually measured from the average to the extreme. Arc. The visible sparks generated by an electrical discharge. Bass. The lowest frequencies of sound. Bi-Ampli ...

  • MartinLogan i - page 23

    Inductance. The property of an electrical circuit by which a varying current in it produces a varying magnetic field that introduces voltages in the same circuit or in a nearby circuit. It is measured in henrys. Inductor . A device designed primarily to introduce inductance into an electrical circuit. Sometimes called a choke or coil. Linearity . T ...

  • MartinLogan i - page 24

    2101 Delaware Street, Lawrence, Kansas 66046, USA tel 785.749.0133 fax 785.749.5320 www.martinlogan.com c l s e l e c t r o s t a t i c M ART I N L OGA N ©2003 MartinLogan. All rights reserved. Rev. #030303 ® ...

メーカー MartinLogan カテゴリー Speaker

MartinLogan iのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- iの取扱説明書
- MartinLoganの製品カード
- パンフレット
- またはMartinLogan iの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、MartinLogan iの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、MartinLogan iの取り付け説明書、サービスマニュアル、簡易説明書、またはMartinLogan iのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、MartinLogan iの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

MartinLogan iデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがMartinLogan iを使用するのを助ける技術的文書のことです。説明書は通常、全てのMartinLogan iユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

MartinLoganの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. MartinLogan iの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははMartinLogan iの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。MartinLogan iに関してこのドキュメントで見つけることができる全てのヒントの目次
3. MartinLogan iデバイスの基本機能を使うにあたってのヒント。 MartinLogan iのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。MartinLogan iに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるMartinLogan iのメーカー/サービスへの連絡先に関する情報。

MartinLogan iについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもMartinLogan iの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがMartinLogan iで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)