Oricom 200の取扱説明書

24ページ 0.65 mb
ダウンロード

ページに移動 of 24

Summary
  • Oricom 200 - page 1

    Baby Monitor Secure 200 User Guide ...

  • Oricom 200 - page 2

    T ABLE OF CONTENTS W ARNINGS AND SAFETY INFORMA TION 1 GETTING ST ARTED 3 YOUR BABY MONITOR 5 LCD DISPLA Y OF BABY MONITOR 8 BASIC OPERA TION 9 MENU SETTINGS 14 TROUBLESHOOTING 19 PRODUCT SPECIFICA TIONS 20 GUARANTEE 21 ...

  • Oricom 200 - page 3

    1 Do not place the cord in a high "wear and tear" location. Never use a frayed or compromised cord. Never use or place your Parent or Baby units in or near moisture or water (e.g. near bath or pool). Immersing in water can cause electric shock and even death. Power requirements In Australia this product requires an electrical supply of 22 ...

  • Oricom 200 - page 4

    2 W ARNINGS AND SAFETY INFORMA TION Battery requirements Each parent unit requires two rechargeable Ni-MH batteries, size AAA 1.2V 800mAh (HR10/44). • Do not dispose of the batteries in a fi re, as they can explode. • Do not open, unscrew or temper with any of your baby monitor units or battery. Always carry out repairs through your authorised ...

  • Oricom 200 - page 5

    3 Thank you for choosing this monitor from Oricom. Your Secure 200 Baby Monitor offers the best Digital Technology. INTERFERENCE FREE FREQUENCY DECT (Digital Enhanced Cordless Telecommunications) is the most widely used worldwide digital cordless technology, offering amazingly clear sound, long range and maximum voice security. DECT operates on the ...

  • Oricom 200 - page 6

    4 GETTING ST AR TED 5. Press [ ] to turn the Parent Unit on. • Before fi rst use, or if it has been out of use for a long time, the Parent Unit will need to be charged for 15-16 hours. During this time, the Parent Unit will operate from the Charger pod when switched on. Note that the Parent Unit cannot be used without batteries, even if it is pl ...

  • Oricom 200 - page 7

    5 YOUR BABY MONITOR Baby unit (Sender) 1 Temperature Sensor Picks up the temperature in your baby's room. 2 Battery Cover For non rechargeable batteries (not supplied). 3 Night light key Press to turn On the night light. Press again to turn Off the light. 4 Power On/Off Key Press to turn ON the Baby unit. Press and hold to turn OFF. 5 Page key ...

  • Oricom 200 - page 8

    6 YOUR BABY MONITOR Parent unit (Receiver) 12 Battery Cover Rechargeable batteries. 13 Belt Clip 14 Volume Up/Down Keys Adjust the volume at which you hear the sounds in your Baby's room, and scroll through the menu during setting. 15 Power On/Off Key Press to turn the parent unit ON. Press and hold to turn OFF. 15 14 13 12 Left view of baby u ...

  • Oricom 200 - page 9

    7 YOUR BABY MONITOR 19 Noise level indicators 20 Torch key Press and hold to emit a soft beam of light from the top of the Parent Unit. 21 Talk key Press and hold to talk to your baby or partner in the baby's room via the Baby Unit. Charger Pod 22 Charging Light When Parent unit is placed in the Charger Pod, the red charger light comes ON to i ...

  • Oricom 200 - page 10

    8 LCD DISPLA Y OF BABY MONITOR Baby Unit 1. Battery level indicator 2. Numbers/Characters indicator 3. Temperature indicator 4. Lullaby on/off indicator Parent Unit 1. Sensitivity indicator 2. Night light indicator 3. Battery level indicator 4. Numbers/Characters indicator 5. Temperature indicator 6. Feed time Alarm indicator 7. Lullaby on/off indi ...

  • Oricom 200 - page 11

    9 BASIC OPERA TION Once you have set up your Baby Monitor, you will be able to hear the sounds in your baby's room through the Parent Unit. And also see the green and red sensor lights around the top of the Parent Unit rise and fall with the sound levels. Note: If the connection between the Parent and Baby Units is broken at any time the green ...

  • Oricom 200 - page 12

    10 BASIC OPERA TION Baby alert! You can set your Parent Unit to give an extra warning "beep" when the noise levels in your baby's room is high and the red lights on the sound sensor are lit. This is particularly useful if the volume of your Parent Unit is turned down and you are just using the sensor lights to monitor the noise level ...

  • Oricom 200 - page 13

    11 BASIC OPERA TION 2. Press [ ] key t o scroll to the different lullabies, or to select [Play all?]. 3. Press [ ] key again to start or stop the lullaby. On the Parent Unit 1. Press [ ] key, then use [ / ] keys to scroll to "Lullaby". Press [ OK ] key. 2. "Play?" is shown on the display. Use [ / ] keys to scroll to "Select ...

  • Oricom 200 - page 14

    12 BASIC OPERA TION Talk to your Baby You can speak to your baby from the Parent Unit, perhaps to reassure them that you are on your way. Press and hold [ ] key and speak into the front of the Parent Unit. • Please note that you will not be able to hear your baby while you are speaking to them until you release [ ] key again. Customize your Baby ...

  • Oricom 200 - page 15

    13 BASIC OPERA TION Charging the Battery The Parent Unit will work for up to 10 hours with fully charged batteries. If a battery low alert tone is heard and the battery icon on the Parent Unit's display is fl ashing, you should put the parent unit on the Charger Pod to recharge the batteries. You can still use your Parent Unit from the Charge ...

  • Oricom 200 - page 16

    14 MENU SETTINGS Note: All Menu settings operations are only available on the Parent unit. During setting, press [ ] key to exit. Night light Setting You can turn on or off the night light on the baby unit via the parent unit. 1. Press [ ] key on the parent unit and use [ / ] keys to select "Night Light". The display is shown below: 2. Pr ...

  • Oricom 200 - page 17

    15 MENU SETTINGS 1. Press [ ] key on the parent unit and use [ / ] keys to select "Sensitivity". The display is shown below: 2. Press [ OK ] key and then use [ / ] keys to select the sensitivity level. There are 5 levels. 3. Press [ OK ] key to confirm and "Saved" is shown on the display. Sound Alert Setting You can set the soun ...

  • Oricom 200 - page 18

    16 MENU SETTINGS Press [ ] key on the parent unit and use [ / ] keys to select "Temperature". The display is shown below: Set desired baby room temperature range 1. Press [ OK ] key, "Set Range" is shown on the display. 2. Press [ OK ] key, use [ / ] keys to set the upper and lower temperature limits. 3. Press [ OK ] key to conf ...

  • Oricom 200 - page 19

    17 MENU SETTINGS Set the time 2. Press [ OK ] key and "Set time" is shown on the display. Press [ OK ] key. 3. "Year" is shown on the display. Use [ / ] keys to select the correct year. Press [ OK ] key. 4. "Month" is shown on the display. Use [ / ] keys to select the correct month. Press [ OK ] key. 5 . "Day" ...

  • Oricom 200 - page 20

    18 MENU SETTINGS Set the fi rst or next feed time 1. Press [OK] key, "Set Time" is shown on the display. 2. Press [ OK ] key, then follow the procedures in the Set the time of Clock Setting to set the hour and minute. Set the interval for following feeds 1. Press [ OK ] key and use [ / ] keys to select "Set Interval". 2. Press ...

  • Oricom 200 - page 21

    19 TROUBLESHOOTING Problem Possible cause(s) The red power lights do not turn on when you plug in the power. 1. Check if the units are properly connected to the power supply. 2. Check if the power is turned on. If not, Press [ ] to turn on the power. The green Link light on the Parent Unit is fl ashing and cannot hear the sounds from your baby&apo ...

  • Oricom 200 - page 22

    20 PRODUCT SPECIFICA TIONS Feature Speci fi cations Operating Frequency DECT 1.8 GHz Range Up to 300m under optimum conditions. The range is reduced in buildings (up to 50m) as a result of walls, doors etc. Power supply (Baby Unit) Input: 240 V AC 50Hz Output: 6 V DC , 200 mA, Non rechargeable batteries, baby unit (not included in the package cont ...

  • Oricom 200 - page 23

    21 GUARANTEE Warranty (Australia) (a) Warranty Oricom International Pty Ltd (Oricom) warrants that the product is free from defects in materials and workmanship for a period of 12 months effective from the date of purchase. This warranty in no way affects your statutory warranty under the Trade Practices Act 1974 or any other similar legislation. I ...

  • Oricom 200 - page 24

    Australia Oricom International Pty Ltd Locked Bag 658 South Windsor, NSW 2756 Customer Support Email: support@oricom.com.au Web: www.oricom.com.au Phone: 1300 889 785 Fax: (02) 4574 8898 ...

メーカー Oricom カテゴリー Baby Monitor

Oricom 200のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 200の取扱説明書
- Oricomの製品カード
- パンフレット
- またはOricom 200の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Oricom 200の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Oricom 200の取り付け説明書、サービスマニュアル、簡易説明書、またはOricom 200のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Oricom 200の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Oricom 200デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがOricom 200を使用するのを助ける技術的文書のことです。説明書は通常、全てのOricom 200ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Oricomの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Oricom 200の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははOricom 200の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Oricom 200に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Oricom 200デバイスの基本機能を使うにあたってのヒント。 Oricom 200のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Oricom 200に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるOricom 200のメーカー/サービスへの連絡先に関する情報。

Oricom 200についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもOricom 200の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがOricom 200で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)