-
Niles Audio HDCTR - page 1
B LENDING H IGH F IDELITY AND A RCHITECTURE ® INST ALLA TION & OPERA TION GUIDE ® HD • CT R HD • LR S HD • CT R HD • LR S HIGH DEFINITION MODEL S © 1 999 Niles Audio Corporation. DS001 96A www.nilesaudio.com Niles Audio Corporation 1 233 1 S. W . 1 30 Street Miami, Florida 33 1 86 T el: (305) 238-43 73 Fax: (305) 238-0 1 85 Printed i ...
-
Niles Audio HDCTR - page 2
Congr atulations! Thank you for choosing a Blueprint Series In-Wall Loudspeaker ® from Niles. With proper installation and operation, you'll enjoy years of trouble-free use. Niles manufactures the industry's most complete line of custom installation components and accessories for audio/video systems. For a free full line catalog write: N ...
-
Niles Audio HDCTR - page 3
DSFG Defeat (HD•CTR) Main/Surround Configuration (HD•LRS) Both the HD•CTR and HD•LRS feature crossover mounted switches which cus- tomize the response of the speaker. In the HD•CTR, the switch controls whether the Directed Sound Field Geometry feature is On or Off. (It is useful to switch it Off when the speaker is installed at ear level, ...
-
Niles Audio HDCTR - page 4
Code and any applicable provisions of the local building code. If you are unsure of the correct installation techniques, wire jacket or type of conduit to use, consult a professional audio /video installer , your building contractor , or the local building and inspection department. Incorporating a Remote Control If you are planning to use a stereo ...
-
Niles Audio HDCTR - page 5
the HD•LRS too close to a direct view TV monitor as they may cause picture discol- oration (HD•CTR may be substituted for HD•LRS in such an installation). In general, try to keep an HD•LRS at least 24 inches away from the TV. With larger CRT screen sizes, you should test for picture degrada- tion before installing. The Boundary Effect Corne ...
-
Niles Audio HDCTR - page 6
9 Speaker Placement of these placement techniques require that you work your surround sound amplifier channels harder . If the surround sound sys- tem you are using has a small five or ten watt amplifier for the rear speakers, stay within five to eight feet of the listening loca- tion. If you are using a 25 to 50 watt amplifi- er you can mount the ...
-
Niles Audio HDCTR - page 7
11 Installation F undamentals Try to line the holes up perfectly, because it makes pulling the wire much easier. A good technique is to snap a chalk line across the face of the studs or against the bottom of the ceiling joists. Then work backward so that you can always see the holes you have already drilled. Paying careful attention to this will sa ...
-
Niles Audio HDCTR - page 8
plenum rated wire (check your local building codes, some municipalities require conduit). In traditional wood stud / drywall construc- tion you can cut the hole for the speaker and utilize the large hole to auger holes across, up or down the wall for as far as your drill bit will take you. If you have matching paint and take reasonable care in patc ...
-
Niles Audio HDCTR - page 9
15 Installation of Brack ets, Fr ames and Grilles in New Construction The grille is constructed of aluminum with a perfectly even powder coat overall. This powder coat is an ideal primer. Remove the grilles before painting. If you are using spray paint, use two thin coats without any primer . If you are using a compressor and a spray gun, use the f ...
-
Niles Audio HDCTR - page 10
17 Installation of Brack ets, Fr ames and Grilles in Existing Walls the drywall section can be replaced clean- ly if there is an unseen obstruction behind the wall . BE VERY CAREFUL NOT TO SAW THROUGH EXISTING WIRES, PIPES, OR STRUCTURE. IF YOU FEEL ANY EXTRA RESISTANCE AS YOU ARE CUT- TING, STOP . 4. If you are cutting into lath and plaster walls, ...
-
Niles Audio HDCTR - page 11
19 Installation of the Speaker and Grille f or Ne w or Existing Construction corner, go around the speaker, pushing the grille in a little bit each time. Y ou should be gentle, the aluminum grille can be easi- ly bent out of shape. The speaker will have an absolutely flush appearance when it is fully in place. Speaker Phase Speaker wire has two con ...
-
Niles Audio HDCTR - page 12
Specifications Model HD•CTR Driver Compliment (2) 5- 1 / 4” Magnetically Shielded Mica Filled Polypropylene Woofers 1 ” ElastoDynamic ™ Hybrid Dome Tweeter with Fluid cooling Design Principle Infinite baffle for large and varying air volumes. Directed Sound Field Geometry ™ for optimum phase and frequency response Recommended Amplifier Po ...
Niles Audio HDCTRについてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもNiles Audio HDCTRの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがNiles Audio HDCTRで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。