Cobra Electronics 29 LTD BTの取扱説明書

21ページ 1.34 mb
ダウンロード

ページに移動 of 21

Summary
  • Cobra Electronics 29 LTD BT - page 1

    A N T / ® ® The Citizens Band lies between the shortwave broadcast and 10-meter Amateur r adio bands, and was established by law in 1949. The Class D two-way c ommunications ser vice was opened in 1959. (CB also includes a Class A citizens band and Class C remote con trol frequencies.) FC C Regulations FCC regulations permit only “transmissions ...

  • Cobra Electronics 29 LTD BT - page 2

    426- 002- N-00 1 Repl acem ent DC P ower C ord 251- 353- 9-00 1 Repl acem ent Mo unti ng Bra cket 634-081-9-001 Replacement Thumb Screws 741-080-9-001 Replacement Microphone Bracket HG A1000 21” Base Loaded, Magnetic Mount Antenna HG A1500 38” Base Loaded Magnetic Mount Antenna MNA MIC External Bluetooth Microphone Item # Description Accessory ...

  • Cobra Electronics 29 LTD BT - page 3

    H ow t o Us e Y ou r C ob ra 2 9 L T D BT Cont ents Fea tures .. ... .. .. ... .. .. .. ... .. .. ... .. .. .. ... .. .. ... .. .. .. ... .. .. ... .. .. .. ... .. .. ... .. .. .. ... .. .. ... .. .. .. ... .. .. ..... .. .1 The CB Story ..........................................................................................A1 FCC Regulations FCC ...

  • Cobra Electronics 29 LTD BT - page 4

    Installation Installation Location 3 2 Mounting and Connection Mounting and C onnection Hold the radio with the mounting bracket in the exact desired location. If there is no interference, r emove the bracket and use it as a template to mark the location f or the mounting screws. Location Plan location of transceiv er and microphone bracket before ...

  • Cobra Electronics 29 LTD BT - page 5

    Installation Installation 5 4 Note Connecting to an accessory fuse prevents the unit from being lef t on accidentally , and also permits operating the unit without running the engine. Note In positive ground vehicles the red wire goes to the chassis and the black wire is connected to the ignition switch. Note Before installing the CB radio , visual ...

  • Cobra Electronics 29 LTD BT - page 6

    Ignition Noise Interference Antennas Use of a mobile receiv er at low signal levels is normally limited by the presence of electrical noise. The primar y source of noise in automobiles is from the alternator and ignition syst em. T ypically , when signal lev el is adequate, the background noise does not present a serious problem. Also , when extrem ...

  • Cobra Electronics 29 LTD BT - page 7

    ANT The CB/P A button should be in the CB position. Operation 9 Operation T urning On Setting Channel Selector 8 T urning On Make sure the power cord , antenna and microphone are connected to their proper connectors before starting. Setting Channel Selec tor 2 1 Ro ta te t he On /Of f V olu me kn ob cl oc kwi se to a normal listening level. Select ...

  • Cobra Electronics 29 LTD BT - page 8

    ANT/ Operation Operation Calibrate For SWR (Standing W ave Ratio) 11 10 Note Antenna Indicator LED will illuminate when TX if SWR is high. Note Calibration must be made in an open area (never in a gar age). V ehicle doors must be closed. No one should be standing near the antenna. (S ee your antenna directions for more complete information). contin ...

  • Cobra Electronics 29 LTD BT - page 9

    Operation 13 Operation 12 Note The reading will be slightly higher on Channels 1 and 40 compared to Channel 20. Note When switched to SWR position the meter needle should ideally be as far to the left as possible. An yth ing ov er 3 is n ot a cc ep ta ble . The antenna indicator will light. A slight antenna height adjustment (higher or lower) ma y ...

  • Cobra Electronics 29 LTD BT - page 10

    Operation Operation Bluetooth ® 15 14 Bluetooth Calls on a Bluetooth enabled cell phone can be rout ed thr ough the 2 9 L TD BT spea ker or extern al speaker accessor y . T o Pair with a C ell Phone With 2 9 L TD BT powe r On, pres s and ho ld th e BT But ton for six seconds to ent er Standby mode. A tone will sound and the B T LED will fla sh for ...

  • Cobra Electronics 29 LTD BT - page 11

    ANT/ Operation 17 Operation 16 Switch to NOR to select desired channel. 1 Selecting A Channel Selec ting A Channel ANT/ NB-ANL/ANL/ OFF (Noise Blanker / Automatic Noise Limiter) Switch Note The RF noise blanker is v er y effective in reducing repetitiv e noises such as ignition interference. When switched to ANL the Automatic Noise Limiter is activ ...

  • Cobra Electronics 29 LTD BT - page 12

    The S/RF-SWR-CAL switch must be in the S/RF position to read the meter . 1 S-Meter S-Meter Swings proportionately to strength of incoming signal when receiving . Operation Operation 19 18 RF Gain Control RF Gain Contr ol The RF Gain is used to optimize recepti on in strong or weak signal areas . Note The RF Gain is used to optimize reception in wea ...

  • Cobra Electronics 29 LTD BT - page 13

    F ull clo ckwise rotation closes the gate allowing only very strong signals to enter . F ull counterclockwise rotation opens the “ gate ” allowing all signals in. T o achieve the Desired Squelch Setting (DSS), turn the Squelch control counterclockwise until you hear noise . Now turn the control clockwise just until the noise stops. This is the ...

  • Cobra Electronics 29 LTD BT - page 14

    Setting Dynamike® This controls the micr ophone sensitivity (outgoing audio level). T o T ransmit 23 T o T ransmit T ransmit T alkBack 22 Setting Dynamike ® Caution! Be sure the antenna is properly connected to the radio befor e transmitting . Prolonged transmitting without an antenna, or a poorly matched antenna, could cause damage to the transm ...

  • Cobra Electronics 29 LTD BT - page 15

    Operation Operation P A (Public Address) 25 24 P A (Publ ic Address) Connect an external P A speak er to the P A jack on the rear panel. Set CB/P A switch to P A position. Push and hold microphone button and speak in a normal voice. Y our voice will now transmit on the P A speaker . Adjust P A speaker volume with the Dynamik e® control. Note Speak ...

  • Cobra Electronics 29 LTD BT - page 16

    T emporary Mobile Set-Up 27 Base Station Operation (From 120V AC House Current) T emporary Mobile Set-Up T emporar y Mobile Operation F or temporary mobile operation you may wan t to purchase an optional automobile pow er adapter from your C OBR A dealer . This adapter and a magnetic mount antenna allow y ou to quickly “install” your transceive ...

  • Cobra Electronics 29 LTD BT - page 17

    How Y our CB Can Serve Y ou How Y our CB Can Serve Y ou 29 28 The FC C gives these examples of permitted and prohibited messages for channel 9. These are only guidelines and not all-inclusive: P ermitted Example Message Y es “ T ornado sighted six miles nor th of town.” No “P ost number 10. No tornado sighted . ” Y es “Out of gas on I-95 ...

  • Cobra Electronics 29 LTD BT - page 18

    How Y our CB Can Serve Y ou How Y our CB Can Serve Y ou 31 30 Code Meaning 10-29 Time is up for contact 10-30 Does not conform to FC C rules 10-33 Emergency traffic 10-34 T rouble at this station 10-35 Confidential information 10-36 Correct time is 10-37 Wrecker needed at 10-38 Ambulance needed 10-39 Message delivered 10-41 T ur n to channel 10-42 ...

  • Cobra Electronics 29 LTD BT - page 19

    29 L TD BT Specifications Frequency Ranges 33 32 G ENERAL C h a n n e l s ..........................C B -4 0C H Frequency Range . . . . . . . . . . . . . . . . . . CB - 26.965 to 27.405 MHz F requency T olerance . . . . . . . . . . . . . . . 0.005 % Frequency Control . . . . . . . . . . . . . . . . . PLL (phase lock loop) Synthesizer Operating T em ...

  • Cobra Electronics 29 LTD BT - page 20

    Optional Accessories 35 Replacement DC P ower Cord For in v ehicle use 426-002-N-001 Replacement Mounting Brack et For in v ehicle use 251-353-9-001 Replacement Thumb Screws For in v ehicle use 634-081-9-001 Replacement Microphone Brack et For in v ehicle use 741-080-9-001 Limited One Y ear W arranty 34 C OBRA ELECTRONICS CORPORA TION warrants that ...

  • Cobra Electronics 29 LTD BT - page 21

    Dynamic External Speaker HG S100 Noise Canceling External Speaker HG S300 Noise Canceling With T alk Back External Speaker HG S500 O p ti on al A cc es so ri es Y ou c an find quality Cobra products and accessories at your local Cobra dealer , or in the U.S.A., you can order directly from Cobra. See ordering info on page 37. 36 Optional Accessories ...

メーカー Cobra Electronics カテゴリー Two-Way Radio

Cobra Electronics 29 LTD BTのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 29 LTD BTの取扱説明書
- Cobra Electronicsの製品カード
- パンフレット
- またはCobra Electronics 29 LTD BTの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Cobra Electronics 29 LTD BTの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Cobra Electronics 29 LTD BTの取り付け説明書、サービスマニュアル、簡易説明書、またはCobra Electronics 29 LTD BTのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Cobra Electronics 29 LTD BTの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Cobra Electronics 29 LTD BTデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがCobra Electronics 29 LTD BTを使用するのを助ける技術的文書のことです。説明書は通常、全てのCobra Electronics 29 LTD BTユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Cobra Electronicsの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Cobra Electronics 29 LTD BTの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははCobra Electronics 29 LTD BTの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Cobra Electronics 29 LTD BTに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Cobra Electronics 29 LTD BTデバイスの基本機能を使うにあたってのヒント。 Cobra Electronics 29 LTD BTのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Cobra Electronics 29 LTD BTに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるCobra Electronics 29 LTD BTのメーカー/サービスへの連絡先に関する情報。

Cobra Electronics 29 LTD BTについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもCobra Electronics 29 LTD BTの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがCobra Electronics 29 LTD BTで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)