-
Electrolux 69802 G - page 1
AUS ERF AHRUNG GUT 69802 G Gas Hob Operating Instructions GB PERFECT IN FORM AND FUNCTION ...
-
Electrolux 69802 G - page 2
2 Important Safety Information Y ou MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 350350 Installation z This hob must be installed by qualified personnel, according to the manufacturer ’ s instructions and to the relevant British Standards. z Any gas in ...
-
Electrolux 69802 G - page 3
3 z Do not use this hob if it is in contact with water . Do not operate the hob with wet hands. z Ensure the control knobs are in the ‘OFF’ position when not in use. z When using other electrical appliances, ensure the cable does not come into contact with the hot surfaces of the cooking appliance. z Unstable or misshapen pans should not be use ...
-
Electrolux 69802 G - page 4
4 Contents Important Safety Information ................................................................................ 2 Instructions for the User ........................................................................................ 5 Description of the Hob ....................................................................................... ...
-
Electrolux 69802 G - page 5
5 1. Hob T op 2. Rapid Burner 3. Semi-rapid Burners 4. Auxiliary Burner 5. Control knob for back right burner (semi-rapid) 6. Control knob for back left burner (semi-rapid) 7. Control knob for front left burner (rapid) 8. Control knob for front right burner (auxiliary) Description of the Hob INSTALLATION Any gas installation must be carried out by ...
-
Electrolux 69802 G - page 6
6 HOB BURNERS T o light a burner , turn the relevant control knob anticlockwise to the maximum position, then push it down to ignite the burner . Upon, ignition, keep the knob pushed down about 5 seconds, then adjust the flame as required. If the burner does not ignite, turn the control knob to zero, and try again. Each control knob is equipped wit ...
-
Electrolux 69802 G - page 7
7 Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply . The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. Pan Supports T o keep the pan supports in the correct position, they are mounted on metal pins located in the back of t ...
-
Electrolux 69802 G - page 8
8 Something Not Working? If the hob is not working correctly , please carry out the following checks before contacting your local AEG Service Force Centre. SYMPTOM There is no spark when lighting the gas The gas ring burns unevenly SOLUTION Check that the unit is plugged in and the electrical supply is switched on Check that the RCC ...
-
Electrolux 69802 G - page 9
9 Service and Spare Parts When you contact the Service Centre, they will need the following information: 1 . Y our name, address and post code. 2 . Y our telephone number 3 . Clear and concise details of the fault 4 . The model and the serial number (see rating label on the back of this instruction booklet) 5 . Date of purchase If you require spare ...
-
Electrolux 69802 G - page 10
10 Guarantee Conditions Standard guarantee conditions We, AEG, undertake that if within 12 months of the date of the purchase this AEG appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our discretion repair or replace the same FREE OF CHARGE for labour, materials or carriage on co ...
-
Electrolux 69802 G - page 11
11 Burner Dia. Tap By-pass 1/100 mm Auxiliary 28 Semi-rapid 32 Rapid 40 Aeration adjustment none OVERALL DIMENSIONS Width: 580 mm. Depth: 510 mm. Height: 88 mm. Weight: 8 Kg. CUT OUT DIMENSIONS Width: 550 mm. Depth: 470 mm. Thickness: 30 mm. SUPPLY CONNECTIONS Gas: RC 1/2 inch (1/2 inch male) Rear right hand corner Electric: 230-240V 50Hz supply , ...
-
Electrolux 69802 G - page 12
12 BURNER RAPID SEMI-RAPID AUXILIARY (large) (medium) (small) POSITION MAX MIN MAX MIN MAX MIN NOMINAL THERMAL POWER kW 2. 9 0.65 1.9 0.45 1.0 0.33 NOMINAL FLOW RATE m 3 / h 0.276 0.062 0.181 0.043 0.095 0.031 NOZZLE REFERENCE 1 19 Adjust. 9 6 Adjust. 7 0 Adjust. 1/100 mm NOMINAL THERMAL POWER kW 2. 7 0.65 1.9 0.45 1.0 0.33 NOMINAL FLOW RATE g/h 1 ...
-
Electrolux 69802 G - page 13
13 Installation IMPORT ANT This hob must be installed by qualified personnel to the relevant British Standards. Any gas installation must be carried out by a registered CORGI installer . The manufacturer will not accept liability , should the above instructions or any of the other safety instructions incorporated in this book be ignored. Location T ...
-
Electrolux 69802 G - page 14
14 A) End of shaft with nut B) W asher C) Elbow FO 0814 FO 0264 On the end of the shaft, which includes the GJ 1/2" threaded elbow , adjustment is fixed so that the washer is fitted between the components as shown in the diagram. Screw the parts together without using excessive force. It is important to install the elbow correctly , with the s ...
-
Electrolux 69802 G - page 15
15 550 4 7 0 580 510 Cut Out Size The dimensions of the cut-out are given in the diagram. Building In Building over a cupboard or drawer If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface. It is also recommended to carry out the e ...
-
Electrolux 69802 G - page 16
16 Building over a kitchen unit with door Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in diagram 3. The panel fitted under the hob ("a") should be easily removable to allow easy access ...
-
Electrolux 69802 G - page 17
17 Electrical connections Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. THIS HOB MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed. This hob is designed to be connected to a 230-240 ...
-
Electrolux 69802 G - page 18
18 Permanent Connection In the case of a permanent connection, it is necessary that you install a double pole switch between the hob and the electricity supply (mains), with a minimum gap of 3 mm. between the switch contacts and of a type suitable for the required load in compliance with the current electric regulations. The switch must not break t ...
-
Electrolux 69802 G - page 19
19 Fault Finding Preliminary Electrical Systems Check START Isolate appliance and carry out: A: Earth Continuity check. Has inlet fuse blown? Carry out: C: Polarity check. Electricity supply should now be satisfactory. Carry out: D: Resistance to Earth check. Inlet wiring faulty. Rectify any fault. Isolate appliance and carry out: B: Insulation che ...
-
Electrolux 69802 G - page 20
20 A. EARTH CONTINUITY CHECK Appliance must be electrically disconnected - meter set on Ω (Ohms) x 1 scale and adjust zero if necessary . — T est leads from any appliance earth point to earth pin on plug. Resistance should be less than 0.1 Ω (Ohm), check all earth wires for continuity and all contacts are clean and tight. B. INSULATION CHECK ...
-
Electrolux 69802 G - page 21
21 Check gas supply at burner Ignition System / Gas Ignition YES Check plug top fuse and replace if necessary Check polarity and earth continuity of supply point Check earth continuity of appliance Ignitor does not spark Check fitting of burners Check position of the electrode Check by pass simmer adjusted Light burner manually Check continuity fro ...
-
Electrolux 69802 G - page 22
22 Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. T o do this, follow the procedure below . 1) T urn the gas tap to the MAX position and ignite. 2) Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. If the flame is unstable or is extinguis ...
-
Electrolux 69802 G - page 23
23 Conversion from Natural Gas to LPG It is important to note that this model is designed for use with natural gas but can be converted for use with butane or propane gas providing the correct injectors are fitted and the gas rate is adjusted to suit. Method 1) Ensure that the gas taps are in the 'OFF' position 2) Isolate the hob from the ...
-
Electrolux 69802 G - page 24
35686-0001 01/04 AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www .aeg.hausgeraete.de © Electrolux plc 2003 Grafiche MDM - Forlì From the Electrolux Group. The world’s No.1 choice. The Electrolux Group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Gr ...
Do you have a question concerning Electrolux 69802 G?
Use the form below
If you did not solve your problem by using a manual Electrolux 69802 G, ask a question using the form below. If a user had a similar problem with Electrolux 69802 G it is likely that he will want to share the way to solve it.