Manual Chauvet Projector Accessories

17 pages 0.79 mb
Download

Go to site of 17

Summary
  • Chauvet Projector Accessories - page 1

    User Manual ...

  • Chauvet Projector Accessories - page 2

    CHAUVET®, 2010, All Rights Reserved Information and specificat ions in this User Manual are subject t o change without not ice. CHAUVET® assumes no responsibility or liabil ity f or any errors or inaccuracies t hat may appear in this manual. A uthor: A nthony Chiappone Revision: 01 Release Date: 01 - 12 - 2011 T ABLE OF C ONTENTS 1. BEFORE YOU BE ...

  • Chauvet Projector Accessories - page 3

    1. Before You Begin 3 1/13/2011 5:38 PM 1. B EFORE Y OU B EGIN What is i ncl uded • 1 x 6SPOT ™ • 1 x Mounting kit • 1 x Power Cord • 1 x W arrant y Card • 1 x User Manual Unpacki ng Instr uctions Immediately upon receiving a fixture, c arefully unpack the carton, check the contents to ensure that all parts are present, and have been re ...

  • Chauvet Projector Accessories - page 4

    1. Before You Begin 4 1/13/2011 5:38 PM Safety Instructions • Please keep this User Manual for future consult ation. If you sell the unit to another user, be sure that they also receive this inst ructi on bookl et. • Always make sure that you are connecting to the proper voltage, and that the line voltage you are connecting to is not higher tha ...

  • Chauvet Projector Accessories - page 5

    2. Introduction 5 1/13/2011 5:38 PM 2. I NTRODUC TION Product Overview Power In Control P anel (LED Display) DM X Out D M X In Microph one Adjustm ent Power Out Microph one Fuseholder Tripod Stand Fasteni ng Kno b Back Panel ...

  • Chauvet Projector Accessories - page 6

    3. Setup 6 1/13/2011 5:38 PM 3. S ETUP AC P o w er This fixture is aut o - ranging and runs on 1 00~240 VAC , 50/ 60 Hz power . To determine the power requirements for a particular fixture, s ee the label affixed to the back plate of the fixture or refer to the fixture’s spec ific at i ons chart. A fixture’s l isted current rat ing indicat es i ...

  • Chauvet Projector Accessories - page 7

    3. Setup 7 1/13/2011 5:38 PM Mounting Orientation The 6SP OT ™ may be mounted in any position , provided there is adequate room for ventilation. Rigging This fixture has multiple ri ggi ng options. T hey are as follows: Floor Standing (us i ng the two mounting/standi ng brack ets ) Hanging (using the two mounti ng/standi ng brack ets ) Hanging (u ...

  • Chauvet Projector Accessories - page 8

    4. Operating Instruct i ons 8 1/13 /2011 5:38 PM 4. O PERATI NG I NSTRUC TIONS Using the Cont r ol Panel Access control panel functi ons using the four butt ons lo cated directly underneath the LED display. B UTTON F UNCTION < MODE > Used to scroll through the current operating mode, as well as back out of the current menu option < UP > ...

  • Chauvet Projector Accessories - page 9

    4. Operating Instruct i ons 9 1/13 /2011 5:38 PM Opera tion DMX Operation This operating mode will allow for control with an external DMX controller. Y ou m ust set the starting address for t his mode. If this is your first time using DMX, then it is recommended that you refer to the “DMX Primer” section in the “Appendix” of this manual. Pl ...

  • Chauvet Projector Accessories - page 10

    4. Operating Instruct i ons 10 1/13 /2011 5: 38 PM Master/Slave Mode (Sound - Ac t i v e ) This mode allows a single unit, the master, to operate in either aut omatic or sound - acti ve mode. When additional (slave) f i xtures are daisy chained to the master, t hey will all s ynchronize with the master and run the same lighting show. Please see the ...

  • Chauvet Projector Accessories - page 11

    5. Appendix 11 1/13/2011 5: 38 PM 5. A PPENDI X Gener al Tr oubleshooti ng S YMPTOM P OSSIBLE C AUSE ( S ) P OSSIBLE A CTION ( S ) Breaker/F use keeps blowing • Ex ce ssi v e cir cuit load • Check total load placed on the electrical circuit • Short circuit along the power wir es • Check for a short in the electrical wi ring (i nt ernal and/ ...

  • Chauvet Projector Accessories - page 12

    5. Appendix 12 1/13/2011 5: 38 PM DM X Prim er There are 512 channels in a DMX connection . A fixture capabl e of receiving D MX w ill require one or a number of sequential channels. The user must assign a starting address on the fixture that indicat es the first channel reserved in the controll er. There are many different types of DMX controll ab ...

  • Chauvet Projector Accessories - page 13

    5. Appendix 13 1/13/2011 5: 38 PM Cable Conne c t or s Cabling must have a male XLR connector on one end and a female X LR connector on the other end . Do not allow contact between the common and the f ixture’s chassis gro und. Ground ing the common can cause a ground loop, and your fixture may perform erratically. Test cables with an ohm meter t ...

  • Chauvet Projector Accessories - page 14

    5. Appendix 14 1/13/2011 5: 38 PM 3-Pin to 5-Pin Con version Chart I f you use a controller with a 5 - pin DM X output c onnector, y ou will ne ed to use a 5 - pin to 3- pin adapter. The chart below details a proper cable conversion: 3-P IN TO 5-P IN C ONVERSION C HA RT Conductor 3- Pi n Fem al e (O utput) 5- Pin Male (Input) Ground/Shiel d Pin 1 P ...

  • Chauvet Projector Accessories - page 15

    5. Appendix 15 1/13/2011 5: 38 PM General Maintenance To maintain optimum perform ance and minimize wear, fixtures should be cleaned frequent ly. Usage and environment are contributing f act ors in determi ning cl eaning frequency. As a general rule, fixtures should be cleaned at least t wice a month. Dust build up reduces light output performance ...

  • Chauvet Projector Accessories - page 16

    T ECHNI CAL S PECIFICATIO NS WEIGHT & DIME NSI ONS Length ........................................................................................................ 35.5 in (902 mm) W idt h ............................................................................................................. 2. 2 i n (56 mm) Height ........................ ...

  • Chauvet Projector Accessories - page 17

    C ONTACT U S W ORL D HE A DQUARTERS General Inform ation ............................................................................................ CHAUVE T® Address ........................................................................................... 5200 N W 108 th Ave Sunrise, FL 33351 Voice ............................................. ...

Manufacturer Chauvet Category Projector Accessories

Documents that we receive from a manufacturer of a Chauvet Projector Accessories can be divided into several groups. They are, among others:
- Chauvet technical drawings
- Projector Accessories manuals
- Chauvet product data sheets
- information booklets
- or energy labels Chauvet Projector Accessories
All of them are important, but the most important information from the point of view of use of the device are in the user manual Chauvet Projector Accessories.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Chauvet Projector Accessories, service manual, brief instructions and user manuals Chauvet Projector Accessories. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Chauvet Projector Accessories.

Similar manuals

A complete manual for the device Chauvet Projector Accessories, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Chauvet Projector Accessories by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Chauvet Projector Accessories.

A complete Chauvet manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Chauvet Projector Accessories - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Chauvet Projector Accessories, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Chauvet Projector Accessories, that we can find in the current document
3. Tips how to use the basic functions of the device Chauvet Projector Accessories - which should help us in our first steps of using Chauvet Projector Accessories
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Chauvet Projector Accessories
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Chauvet Projector Accessories in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Chauvet Projector Accessories?

Use the form below

If you did not solve your problem by using a manual Chauvet Projector Accessories, ask a question using the form below. If a user had a similar problem with Chauvet Projector Accessories it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)