Manual Winegard rm-4610

16 pages 0.83 mb
Download

Go to site of 16

Summary
  • Winegard rm-4610 - page 1

    1 RV Digital Satellite System with RS-1000 Antenna Model RM-4610, no Digital Magic TM Elevation Sensor Model RM-DM61 with “Digital Magic” TM Elevation Sensor Model RM-DM55 with “Digital Magic” TM (No Power Supply) OWNER’S MANUAL - OPERATION/INSTALLATION INSTRUCTIONS WINEG ARD ® U.S. PATENT NO. 5,532,710 AND 5,554,998 Made in U.S.A. INSTA ...

  • Winegard rm-4610 - page 2

    2 FINDING THE SATELLITE STEP 1 . Step outside the vehicle and, using a compass, determine which direction is North. (Standing in or near the vehicle can give you an incorrect reading.) The more accurately you determine North, the easier it will be to find the satellite(s). STEP 2. Using satellite receiver, determine correct elevation for your locat ...

  • Winegard rm-4610 - page 3

    3 OPERATIONS DO’S AND DON’T’S DO’S 1. Do check parking location for obstructions before raising antenna. 2. Do carefully raise, lower and rotate the antenna — if difficult, check for cause. 3. Do rotate slowly when searching for the satellite(s) and check fine tuning on TV set for proper adjustment. 4. Do lower antenna before moving vehic ...

  • Winegard rm-4610 - page 4

    4 TROUBLE SHOOTING NO PICTURE ON TV 1. Do you have a clear line of sight to the satellite? Are there trees, buildings, etc. in the way? Figure 3 illus- trates the look angle of your reflector. 2. Do you have the menu from the receiver? If not, check the channel the TV set is tuned for — it should be 3 or 4. 3. Check connections at the receiver, T ...

  • Winegard rm-4610 - page 5

    5 INSTALLATION AND ASSEMBLY THINGS YOU NEED Screwdrivers (Phillips and slot) 1-3/4” hole saw 7/16” wrench Drill with 1/8” bit Tape measure Sealant (Must be approved for compatibility w/roof) STEP 1. Choose a location on the roof for the unit. The dish must be able to rotate without interfering with other roof- mounted equipment (air condition ...

  • Winegard rm-4610 - page 6

    6 STEP 3. Remove backing from gasket. Attach adhesive side to base plate. IF YOU ARE USING THE ROOF WEDGE (RW-5000), use 3/16” gasket included with the mount UNDER the roof wedge. Install the 1/16” gasket included with RW-5000 BETWEEN the mount and roof wedge.See Figure 7. The word FRONT is embossed on the base. This MUST FACE the front of the ...

  • Winegard rm-4610 - page 7

    7 STEP 7. Facing the front of the dish, find coax cables attached to side of the feed arm, Figure 9. Measure 24” of coax from this point and mark. DO NOT CUT. Rotate mount on base clockwise, fully, until it stops. Route coax around mount base, Figure 10. Fasten cable clamp in hole in mount base (check roof template inserted in this manual for cor ...

  • Winegard rm-4610 - page 8

    8 FOR RM-DM61/RM-DM55 ONLY DIGITAL ELEVATION SENSOR ROOF CONNECTIONS The illustrations below show the different methods of connecting wires at roof level. Method will depend on model. Wire colors MUST MATCH (i.e. red to red, green to green, black to black, white to white). This wire harness connect s to the digital elevation sensor on the antenna. ...

  • Winegard rm-4610 - page 9

    9 FIGURE 13 STEP 19. The directional handle and threaded rod will fit roofs up to 5-1/4" thick. If you are using wedges to compensate for roof/ ceiling slope, be sure to allow for this extra thickness. You may add an extension to the directional handle for thicker roofs. Each extension will increase the length of the directional handle by 2-1/ ...

  • Winegard rm-4610 - page 10

    10 Rotation Clamp ASSEMBLED VIEW POINT TO BACK OF RV POINTER MUST POINT TO RED SCREW ON ROTATION CLAMP WHEN IN TRAVEL POSITION CAUTION: After INITIAL INSTALLATION, the antenna should ROTATE APPROXIMATELY 360° FROM TRAVEL POSITION. The pointer on the DIRECTIONAL HANDLE should point towards the RED SCREW on the ROTATION CLAMP when in TRAVEL POSITION ...

  • Winegard rm-4610 - page 11

    11 EXPLODED PARTS VIEW Antenna Head Dish Frame 46 cm Reflector White (4) Flat Head Bolts (White) LB-1000: St andard Single LNBF E-Clip T op Boom Carriage Bolt Pin 1-9/16” long Mount Adapter Rubber Bumper Screw Bushing Bottom Boom Flange Nut 1/4-20 Feed Arm Roller Hex Head Bolt 1/4-20 x 2.5” Nylock Nut 1/4-20 (not shown) Pivot Bracket (Feed Arm) ...

  • Winegard rm-4610 - page 12

    12 NOT TO SCALE Ceiling Base Directional Dial (4) #10 Phillips Flat Head Screws Directional Handle Azimuth Lock Azimuth Lock Knob Washer #10 x 3/8" Red Phillips Screw #8-32 Square Nut Crank Handle Base Crank Handle Knob Washer #8-32 x 3/8" Phillips Screw #10 x 3/8" Phillips Screw Directional Handle Extension Rev 6/11/01 PARTS LIST IN ...

  • Winegard rm-4610 - page 13

    13 SPECIFICATIONS Height when raised ........ 30” with satellite antenna in vertical position Height in travel position ........ 8” Operating radius ........ 35” (70” diameter circle) Roof space required ........ 19.5” x 46.75” LNBF ........ Compatible with DISH Network ® , DirecTV ® and ExpressVu Color ........ White Satellite antenn ...

  • Winegard rm-4610 - page 14

    14 REPLACEMENT PARTS KITS HEAD ASSEMBLY RP-RS00 Head w/bracket and nut ................ 1 Pins .............................................. 2 E-Clip ............................................ 2 REFLECTOR RP-REFL Dish .............................................. 1 Bolt ............................................... 4 Nut ..................... ...

  • Winegard rm-4610 - page 15

    15 ...

  • Winegard rm-4610 - page 16

    16 Printed in U.S.A. Winegard Company • 3000 Kirkwood Street • Burlington, Iowa 52601 © Winegard Company, 2002 2451070 Rev. 6/09/03 ...

Manufacturer Winegard Category Satellite TV System

Documents that we receive from a manufacturer of a Winegard rm-4610 can be divided into several groups. They are, among others:
- Winegard technical drawings
- rm-4610 manuals
- Winegard product data sheets
- information booklets
- or energy labels Winegard rm-4610
All of them are important, but the most important information from the point of view of use of the device are in the user manual Winegard rm-4610.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Winegard rm-4610, service manual, brief instructions and user manuals Winegard rm-4610. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Winegard rm-4610.

Similar manuals

A complete manual for the device Winegard rm-4610, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Winegard rm-4610 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Winegard rm-4610.

A complete Winegard manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Winegard rm-4610 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Winegard rm-4610, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Winegard rm-4610, that we can find in the current document
3. Tips how to use the basic functions of the device Winegard rm-4610 - which should help us in our first steps of using Winegard rm-4610
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Winegard rm-4610
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Winegard rm-4610 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Winegard rm-4610?

Use the form below

If you did not solve your problem by using a manual Winegard rm-4610, ask a question using the form below. If a user had a similar problem with Winegard rm-4610 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)