English dropdown-ico

Manual Transcend Information USB JetFlash

30 pages 1.43 mb
Download

Go to site of 30

Summary
  • Transcend Information USB JetFlash - page 1

    USB 128MB–512MB JetFlash™ User ’ s Manual ...

  • Transcend Information USB JetFlash - page 2

    Table of Contents Introduction Package Cont ent s .................................................................................... 1 Features .................................................................................................... 1 System Require ment s ............................................................................. 2 ...

  • Transcend Information USB JetFlash - page 3

    MP3 Function To Download or Upload MP3/WMA fi les .............................................. 10 To Play MP3 Music ................................................................................. 11 AB Repeat Function .................................................................. 11 Voice Recording Function To Record Vo ice ................ ...

  • Transcend Information USB JetFlash - page 4

    1 Intr oduction Thank you very much for purchasing Transcend’s JetFlash™ . This small device is more than a USB Flash Drive. It combines a USB Flash Drive with MP3, AB repeat, and voice recording functions. With a USB connector, it can expedite exchanging huge amounts of data between any desktop or la ptop computers with a USB por t. With the M ...

  • Transcend Information USB JetFlash - page 5

    2 recorder; • Power Saving Function: Auto-powers off after two minutes without use. • LEDs indicate the usage status of JetFlash . System Requirements Desktop or notebook computer with USB port One of following operating systems: • Windows 98SE • Windows Me • Windows 2000 • Windows XP • Mac OS 9.0 or later • Linux kernel 2.4 or late ...

  • Transcend Information USB JetFlash - page 6

    3 Driv er Installa tion Driver Installation for Windows 98SE 1. Put the Driver CD into the CD-ROM (Auto-Run supported). Click Win98 Driver button. 2. Click Next to continue. 3. The Install Shield Wizard guides you through the installation process. ...

  • Transcend Information USB JetFlash - page 7

    4 4. Plug JetFlash into an available USB port. Your computer automatically detects this new device. A new Removable Disk drive with a newly assigned drive letter appears in the My Computer window. Driver Installation for Windows Me, 2000, and XP No driver is required. These Windows opera ting systems have built-in drivers to support JetFlash . Simp ...

  • Transcend Information USB JetFlash - page 8

    5 Driver Installation for Li nux Kernel 2.4 or Later No driver is required. Just plug JetFlash into the USB port and mount it. Example: 1. Create directory of /mnt/JetFlash first: mkdir /mnt/JetFlash 2. mount JetFlash : mount –a –t msdos /dev/sda1 /mnt/JetFlash Data Stor a ge After installing the driver, simply plug JetFlash into an available U ...

  • Transcend Information USB JetFlash - page 9

    6 Uninstall 1. Put the Driver CD into the CD-ROM (Auto-Run supported). Click Win98 Driver button. 2. Click OK to continue. Ho w to Unplug J etFlash Safely Before removing JetFlash , please make sure the LED is not flashing! If you remove JetFlash while the LED is flashing, unpredi ctable damage to the files or JetFlash may occur. When JetFlash is u ...

  • Transcend Information USB JetFlash - page 10

    7 To Remove JetFlash in Windows 98SE Unplug JetFlash from your system directly when data are not transferring. To Remove JetFlash in Windows Me, 2000, and XP 1. Click the icon on the system tray. 2. The Safely remove USB Mass Storage Device pop-up menu will appear. Click to continue. 3. A message box appears: The ‘USB Mass Storage D evice’ devi ...

  • Transcend Information USB JetFlash - page 11

    8 Pr oduct Ov er view REC Button PLAY/PAUSE Button Record LED Power/Play LED Repeat LED USB Connec tor Cover HOLD Switch Microphone Earphone Jack Track Control Wheel Volume Control Wheel Basic Oper a tion Enter MP3 Mode 1. Disconnect JetFlash from your computer. 2. Press and hold the PLAY/PAUSE button for a few seconds to power on (enter MP3 mode). ...

  • Transcend Information USB JetFlash - page 12

    9 Play a Track Press the PLAY/PAUSE button after entering MP3 or Record mode. The Power/Play LED blinks green and there is track playback.  If there is no track in your JetFlash , the Power/Play LED turns green. Pause a Track Press the PLAY/PAUSE button when there is track playback. The Power/Play LED turns green and the track is paused.  To ...

  • Transcend Information USB JetFlash - page 13

    10 Repeat All Tracks Press the Track Control Wheel when the Repeat LED is on, or press the Track Control Wheel twice when the Repeat LED is off. The Repeat LED blinks orange.  To resume normal playback, press the Track Control Wheel again. Repeat a Portion of One Track (AB Repeat) 1. Press the Volume Control Wheel to mark the beginning of the po ...

  • Transcend Information USB JetFlash - page 14

    11 To Play MP3 Musi c 1. Make sure you have downloaded MP3 or WM A files to the root directory of your JetFlash . 2. Disconnect JetFlash from your computer. 3. Connect the earphone with the earphone jack . 4. Set HOLD switch to “ OFF ” position. 5. Press and hold the PLAY/PAUSE button for a few seconds to power on (enter MP3 mode). The Power/Pl ...

  • Transcend Information USB JetFlash - page 15

    12 4. Press and hold the REC button for a few seconds to enter Record mode. The Record LED turns red. 5. Press the REC button. The Record LED blinks red and voice recording starts. 6. Press the REC button to stop voice recording when you wish to stop. 7. Press the REC button to start voice recording when you wish to start again.  The recorded fi ...

  • Transcend Information USB JetFlash - page 16

    13 LED Indica tion Record LED (Red) Power/Play LED (Green) Repeat LED (Orange) Status off off off Power off off fast blink off Data transfer off on off Power on (in MP3 mode) off normal blink off Play MP3 music off normal blink on Repeat a track off normal blink normal blink Repeat all tracks off normal blink fast blink The beginning of the portion ...

  • Transcend Information USB JetFlash - page 17

    14  Do not release the PLAY/PAUSE button until the Recovery procedures are completed. 4. Found New Hardware and New Hardw are Found messages appear. (Only the first time you recover the JetFlash .) 5. Click the Recovery button on the JetFlash splash screen. 6. MSCN Format status bar message appears.  If above message does not appear, click th ...

  • Transcend Information USB JetFlash - page 18

    15 screen again. If this still doesn’t work, press and hold PLAY/PAUSE button to re-plug JetFlash first. Then, click the Recovery button on the JetFlash splash screen again. 7. New Hardware Found messages appear. (Only the first time you run the Recover y program.) 8. Click the Recovery button on the JetFlash windows splash screen again. 9. MSCN ...

  • Transcend Information USB JetFlash - page 19

    16 remains unchecked. Click Start to initiate the low-level format. 10. Complete message appears. Click Close to complete the Recovery procedures. 11. Release the PLAY/PAUSE button. JetFlash has been returned to its initial status for your usage. ...

  • Transcend Information USB JetFlash - page 20

    17 To Recover JetFlash in Windows Me, 2000, and XP  Skip steps 1-3 if the Utility program has already been installed. 1. Put the Driver CD into the CD-ROM (Auto-Run supported) and click the Utility button on the JetFlash splash screen. 2. SigmaTel MSCN Audio Player Setup window appears. Click Next to continue. 3. The InstallShield Wizard guides ...

  • Transcend Information USB JetFlash - page 21

    18 5. Press and hold the PLAY/PAUSE button, then plug JetFlash into an available USB port.  Do not release the PLAY/PAUSE button until the Recovery procedures are completed. 6. Found New Hardware messages appear. (Only the first time you recover the JetFlash .)  If using Windows Me or 2000, go directly to step 9. 7. Wait a while until Found N ...

  • Transcend Information USB JetFlash - page 22

    19 8. Found New Hardware Wizard window appears. Click Finish to continue. (Only appears the first time you recover the JetFlash .) 9. Click the Recovery button on the JetFlash splash screen. 10. MSCN Format status bar message appears.  If above message does not appear, click the Recovery button on the JetFlash splash screen again. If this still ...

  • Transcend Information USB JetFlash - page 23

    20  If using Windows Me or 2000, go directly to step 15. 12. Found New Hardware Wizard window appears. Click Next to continue. (Only appears the first time you run the Recovery program.) 13. Found New Hardware Wizard window appears. Click Next to continue. (Only appears the first time you run the Recovery program.) ...

  • Transcend Information USB JetFlash - page 24

    21 14. Completing the Found New Hardware Wizard message appears. Click Finish to continue. (Only appears the first time you run the Recovery program.) 15. MSCN Format dialog box appears. Click Start in the Media Recovery tab to initiate the low-level format. ...

  • Transcend Information USB JetFlash - page 25

    22 16. Complete message box appears. Click Close to comp lete the Recovery procedures. 17. Release the PLAY/PAUSE button. JetFlash has been returned to its initial status for your usage. ...

  • Transcend Information USB JetFlash - page 26

    23 T roubleshooting Q1: Why doesn’t the driver CD Auto-Run after it is inserted into the CD-ROM drive in Windows? A1: This problem usually occurs because the Auto-Insert function of t he CD-ROM drive is disabled. Please enter Device Manager in Control Panel and enable the Auto-Insert function of the CD-ROM drive. Al ternatively, you can execute t ...

  • Transcend Information USB JetFlash - page 27

    24 Q7: Why do the three LEDs just blink a moment and extinguish when press the PLAY/PAUSE button to turn on JetFlash ? A7: Please press and hold the PLAY/PAUSE button a second or two longer, until the three LEDs blink once and the Power/Play LED turns green. If the problem persists, please check to see whether the battery power is used up. If it is ...

  • Transcend Information USB JetFlash - page 28

    25 Q13: Why does JetFlash turn off automatically after entering MP3 mode or Record mode? A13: JetFlash features a power-save function. If your JetFlash is idle for two minutes, power-save is triggered and the power turns off automatically. Q14: Why is JetFlash automatically removed from the operating system when I use it as a USB Flash Drive? A14: ...

  • Transcend Information USB JetFlash - page 29

    26 Specifica tions • Size: 97 mm × 31 mm × 18 mm • Weight: 25 g (without battery) • Data retention: Up to 10 years • Shock resistance: 1000 G (maximum) • Erase cycles: 1,000,000 times • Signal-to-Noise Ratio: 90dB • Output frequency: 20Hz–20KHz • Estimated battery life: 12 hours (alkaline battery) • MP3 format: MP3 and WMA • ...

  • Transcend Information USB JetFlash - page 30

    JetFlash Limited Warranty “Above and beyond” is the standard we set ourselves for customer service at Transcend. We consistently position ourselves to be significantly above the industry norm. It ’s all part of our commitment to Customer Satisfaction. All Transcend Information, Inc. (Transc end) products are warranted and tested to be free fr ...

Manufacturer Transcend Information Category Network Card

Documents that we receive from a manufacturer of a Transcend Information USB JetFlash can be divided into several groups. They are, among others:
- Transcend Information technical drawings
- USB JetFlash manuals
- Transcend Information product data sheets
- information booklets
- or energy labels Transcend Information USB JetFlash
All of them are important, but the most important information from the point of view of use of the device are in the user manual Transcend Information USB JetFlash.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Transcend Information USB JetFlash, service manual, brief instructions and user manuals Transcend Information USB JetFlash. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Transcend Information USB JetFlash.

Similar manuals

A complete manual for the device Transcend Information USB JetFlash, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Transcend Information USB JetFlash by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Transcend Information USB JetFlash.

A complete Transcend Information manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Transcend Information USB JetFlash - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Transcend Information USB JetFlash, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Transcend Information USB JetFlash, that we can find in the current document
3. Tips how to use the basic functions of the device Transcend Information USB JetFlash - which should help us in our first steps of using Transcend Information USB JetFlash
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Transcend Information USB JetFlash
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Transcend Information USB JetFlash in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Transcend Information USB JetFlash?

Use the form below

If you did not solve your problem by using a manual Transcend Information USB JetFlash, ask a question using the form below. If a user had a similar problem with Transcend Information USB JetFlash it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)