-
Sunstech RPD10 - page 1
RP-D10 OPERA TING INSTRUCTIONS PLL AM - FM STEREO RECEIVER ...
-
Sunstech RPD10 - page 2
Thank you for purchasing RP-D10, PLL AM /FM Stereo Receiver! It will give you many hours of reliable service and listening pleasure. Before operating the receiver , please read this manual carefully and retain it for future reference. INTRODUCTION CONTENTS Location of Controls............................................................1 LCD Identif ...
-
Sunstech RPD10 - page 3
2 WEEKDAY PM LOCAL AM FM MHz KHz STEREO TEMPERA TURE 1 2 3 4 5 6 7 8 9 88:88 8 1 2 3 4 5 6 7 8 9 Week day Indicator AM Band / AM Clock Mode FM Band PM Clock Mode Local Time Battery Indicator Temperature Indicator Stereo Preset Number / Week day LCD INDENTIFICA TION Slide the battery cover in the direction of the arrow. Insert two AAA batteries acco ...
-
Sunstech RPD10 - page 4
POWER / BAND When the batteries become weak, battery indicator flashes. If batteries get too weak for proper operation, the unit will automatically shut off . Replace the batteries immediately to prevent memories losing after the power automatically turns off. Turn off the unit and then replace the batteries with fresh ones within 1 hour. If the un ...
-
Sunstech RPD10 - page 5
ÊÖ¶¯ËÑË÷ ×Ô¶¯ËÑË÷ TUNING IN TO A STA TION 1. Manual T uning Press SCAN button(+ /- ) to tune in to a clear reception. FM Step: 0.1MHz AM Step: 9KHz Headphones cord functions as antenna for the unit, plug the headphone connector in to earphone jack be fore tuning, or you can not tune in to any stations. Manual tuning is mor e suitabl ...
-
Sunstech RPD10 - page 6
4 FM MHz STEREO 1 00.4 FM MHz STEREO 1 00.4 9 FM MHz STEREO 1 00.4 6 FM MHz STEREO 1 00.4 7 FM 0-19 + AM 0-9 = 30 Presets You can preset up to 20 stations under the preset number (0-19) on FM and 10 stations under the preset number (0-9) on AM: PRESETTING ST ATIONS Tune in to a desired station with manual tuning or quick tuning . 9 Press STORE / TI ...
-
Sunstech RPD10 - page 7
10 11 Make sure to press STORE / TIME after clock setting, otherwise setting is failed. In step 2, hour or minute will step up continuously if y ou press and hold + or - until you release the button. 1 2 3 LOCAL WEEKDAY 1 8:00 5 LOCAL WEEKDAY 19 :01 5 Press + to cyclically increase the hour and - to cyclically increase the minute. 11 12 Press and h ...
-
Sunstech RPD10 - page 8
Avoid using earphones at high volume, if you experience a ringing in your ears, reduce volume or discontinue use. Shut down the radio before sleeping. Do not use earphones while driving or cycling, it can also be potentially dangerous to play your earphones at high volume while walking, especially at pedestrian crossing. Notes On Headphones CAUTION ...
-
Sunstech RPD10 - page 9
RP-D10 MANUAL DE INSTRUCCIONES RADIO PORTÁTIL CON SINTONIZADOR DIGITAL DE FM ESTÉREO / AM ...
-
Sunstech RPD10 - page 10
¡Gracias por adquirir el receptor de AM/FM Estéreo PLL Sunstech RP-D10! Este aparato le va a proporcionar numerosas horas de servicio fiable y escucha placentera. Antes de utilizar el receptor, dedique unos momentos a leer con detenimiento este manual y guárdelo para futuras consultas. INTRODUCCIÓN CONTENIDO Ubicación de controles Identificaci ...
-
Sunstech RPD10 - page 11
2 WEEKDAY PM LOCAL AM FM MHz KHz STEREO TEMPERA TURE 1 2 3 4 5 6 7 8 9 88:88 8 1 2 3 4 5 6 7 8 9 Indicador de día de la semana Banda de AM Banda de FM PM Hora local Indicador de batería Indicador de temperatura Estéreo Número de presintonía / Día de la semana IDENTIFICACIONES EN PANT ALLA LCD Deslice la tapa del alojamiento de baterías en la ...
-
Sunstech RPD10 - page 12
ALIMENTACIÓN / BANDA DE FRECUENCIAS Cuando las baterías se debilitan, el indicador de batería parpadea. Si la batería se debilita demasiado para un funcionamiento correcto, la unidad se desactiva de forma automática a través de un circuito integrado especial. Sustituya las baterías de inmediato para evitar que se pierda la memoria tras la de ...
-
Sunstech RPD10 - page 13
ÊÖ¶¯ËÑË÷ ×Ô¶¯ËÑË÷ SINTONIZACIÓN DE EMISORAS 1. Sintonización manual Pulse el botón SCAN (Búsqueda) (+ / ) para sintonizar una recepción con claridad. Paso de FM: 0,1MHz Paso de AM: 9KHz El cable de los auriculares hace la función de antena de la unidad, conecte los auriculares a la toma de auriculares, antes de efectuar la sin ...
-
Sunstech RPD10 - page 14
4 FM MHz STEREO 1 00.4 FM MHz STEREO 1 00.4 9 FM MHz STEREO 1 00.4 6 FM MHz STEREO 1 00.4 7 Puede predefinir hasta 20 emisoras con un número predefinido (0-19) en FM y 10 emisoras con un número predefinido (0-9) en AM: FM: 0-19 + AM: 0-9 = 30 presintonías PREAJUSTE DE EMI SORAS Sintonice una emisora que desee mediante la sintonización rápida o ...
-
Sunstech RPD10 - page 15
10 11 Asegúrese de pulsar STORE / TIME (GUARDAR/ HORA) tras el ajuste del reloj, de lo contrario el ajuste no se realiza. En el paso 2, la hora o los minutos avanzan de forma continua si mantiene pulsados + o hasta que suelte el botón. 1 2 3 LOCAL WEEKDAY 1 8:00 5 LOCAL WEEKDAY 19 : 0 1 5 11 12 Mantenga pul sado STOR E / TI ME (GUARDAR/ HORA) dur ...
-
Sunstech RPD10 - page 16
Evite el uso de auriculares a volumen alto, si siente que le zumban los oídos, reduzca el volumen o deje su uso. Desactive la radio antes de dormir . No utilice auriculares al conducir o montar en bicicleta, también puede ser potencialmente peligro so escuchar los auriculares a volumen alto mientras camina, sobre todo al cruzar un paso de peatone ...
Do you have a question concerning Sunstech RPD10?
Use the form below
If you did not solve your problem by using a manual Sunstech RPD10, ask a question using the form below. If a user had a similar problem with Sunstech RPD10 it is likely that he will want to share the way to solve it.