English dropdown-ico

Manual Spracht cp-2010

20 pages 0.38 mb
Download

Go to site of 20

Summary
  • Spracht cp-2010 - page 1

    V oice Center ™ Conference Phone CP-2010 model series User's Manual ...

  • Spracht cp-2010 - page 2

    ...

  • Spracht cp-2010 - page 3

    T able of Contents - V oice Center User’s Manual Introduction and Quick Start Guide Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Analog or Digital T elephone System? . . . . . . . . . . . . . . . . . . . . . ...

  • Spracht cp-2010 - page 4

    Introduction Thank you for choosing the V oice Center Conference Phone, a high per formance audio conferencing system. Its features include: • Full duplex communication – the V oice Center’ s digital speech processing enables simultaneous two- way communication. This eliminates clipped sentences and awkward one-way conversations, allowing smo ...

  • Spracht cp-2010 - page 5

    3 Quick Start Guide 3. Analog or Digital T elephone System? Caution: if the V oice Center is connected to a digital telephone system using the Analog T elephone System Inter face, it will not operate correctly , and may cause damage to the A T -101 Analog Interface and cause it to over heat. It is therefore impor tant to use the correct inter face ...

  • Spracht cp-2010 - page 6

    Analog T elephone System Setup with Analog T elephone System If you are connecting the V oice Center Conference Phone to an analog telephone system, follow the instructions below . In Nor th America, use the A T -101 Analog T elephone System Inter face supplied with the conference phone; in Europe, use the A T -102 European T elephone System Interf ...

  • Spracht cp-2010 - page 7

    W all Mounting of Analog Interface (Optional) • Install the two mounting screws supplied with the Analog Interface in the wall. Leave approximately 3/16 in. (0.5 cm) between screw head and wall. • Place the Analog Interface over the mounting screws and slide it down to fix it in position. Selection of T one or Pulse Dialing The user may select ...

  • Spracht cp-2010 - page 8

    Keypad Functions with Analog Phone System ON/OFF Pressing the ON/OFF key turns the Conference Phone on to obtain a dial tone, or turns it off to terminate a call. The green LED just above the ON/OFF key illuminates when the Conference Phone is on. REDIAL If a dial tone is available, pressing the REDIAL key redials the last number dialed on the Conf ...

  • Spracht cp-2010 - page 9

    Conference Phone Operation with Analog Phone System Answering a call When the Conference Phone rings, press the ON/OFF key to answer the call. The green LED illuminates to indicate the Conference Phone is on. Adjusting the speaker volume While a call is in progress use the ▼ (decrease volume) and ▲ (increase volume) keys to adjust the speaker v ...

  • Spracht cp-2010 - page 10

    Digital T elephone System Setup of Conference Phone with Digital Phone System Note: The DT -102 Digital T elephone System Inter face is required for use of the Voice Center Conference Phone with a digital phone system. Follow the steps below to set up the system. Throughout the instructions, the V oice Center Conference Phone is referred to as “C ...

  • Spracht cp-2010 - page 11

    4. Use Digital Inter face’s 4-position switch to adjust audio level by making a test call. • Lift digital telephone handset from its cradle, then press Conference Phone’ s “On/Off” key . Important: the digital telephone handset must be “off-hook” for the duration of the call; the Digital Interface disables the handset microphone when ...

  • Spracht cp-2010 - page 12

    Keypad Functions with Digital Phone System ON/OFF Pressing the ON/OFF key turns the Conference Phone on to connect a call, or turns it off to ter- minate the Conference Phone conversation. The green LED just above the ON/OFF key illumi- nates when the Conference Phone is on. W ith a digital telephone system, Conference Phone calls go through the di ...

  • Spracht cp-2010 - page 13

    Conference Phone Operation with Digital Phone System Answering a call 1. When the phone rings, pick up the digital telephone handset to accept the call. 2. Press the ON/OFF key to take the call on the Conference Phone. The green LED illuminates to indi- cate the Conference Phone is on; the microphone in the digital telephone handset is disabled whi ...

  • Spracht cp-2010 - page 14

    General Setup T ips T ips for Obtaining Optimal Acoustic Performance •T o minimize echoes, place the Conference Phone at the center of the room, or at least away from walls (at least 20 inches/0.5 m from any wall). • It is impor tant to place the Conference Phone on the sur face where it will be used before applying power . When power is applie ...

  • Spracht cp-2010 - page 15

    General Installation of External Microphones (Optional) The V oice Center Conference Phone has 3 built-in microphones for complete 360° coverage in areas up to 10 x 15 ft (3 x 4.5 m). The V oice Center Conference Phone has RJ-22 input jacks for two external microphones to extend coverage in larger areas and to allow for irregular layouts. V oice C ...

  • Spracht cp-2010 - page 16

    Specifications Conference Phone Controls and Interface Switches Microphone switch to turn on 1, T one/pulse switch to select 2, or all 3 built-in microphones telephone dialing mode LED indication lights Green LED indicates unit is on 3 red LEDs (one on each arm) indicate mute is activated Speakerphone connections I nputs: Output: RJ-45 for telephon ...

  • Spracht cp-2010 - page 17

    Spracht Limited W arranty Policy Spracht warrants it products against defects or malfunctions in material and workmanship under normal use and ser vice, with the exceptions stated below . This warranty lasts for one year from the original date of purchase. Coverage terminates if you sell o r other wise transfer the product. In order to keep this wa ...

  • Spracht cp-2010 - page 18

    Federal Communications Commission Statement Note: The V oice Center Conference Phone equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Par t 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. The equipment g ...

  • Spracht cp-2010 - page 19

    ...

  • Spracht cp-2010 - page 20

    SPRACHT T el: 650-318-8061 Fax: 650-318-8060 2672 Bayshore Parkway , Bldg 900 Mountain View , CA 94043 USA www .spracht.com © 2001 Spracht Spracht and V oice Center are trademarks of ODI. SP1009 Rev . 4/02 Made in T aiwan ...

Manufacturer Spracht Category Telephone

Documents that we receive from a manufacturer of a Spracht cp-2010 can be divided into several groups. They are, among others:
- Spracht technical drawings
- cp-2010 manuals
- Spracht product data sheets
- information booklets
- or energy labels Spracht cp-2010
All of them are important, but the most important information from the point of view of use of the device are in the user manual Spracht cp-2010.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Spracht cp-2010, service manual, brief instructions and user manuals Spracht cp-2010. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Spracht cp-2010.

Similar manuals

A complete manual for the device Spracht cp-2010, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Spracht cp-2010 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Spracht cp-2010.

A complete Spracht manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Spracht cp-2010 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Spracht cp-2010, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Spracht cp-2010, that we can find in the current document
3. Tips how to use the basic functions of the device Spracht cp-2010 - which should help us in our first steps of using Spracht cp-2010
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Spracht cp-2010
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Spracht cp-2010 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Spracht cp-2010?

Use the form below

If you did not solve your problem by using a manual Spracht cp-2010, ask a question using the form below. If a user had a similar problem with Spracht cp-2010 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)