English dropdown-ico

Manual Burris XT-120

24 pages 1.51 mb
Download

Go to site of 24

Summary
  • Burris XT-120 - page 1

    Burris Co. 311 East 8th Street Greeley , CO 80631 970-356-1670 www .burrisoptics.com ...

  • Burris XT-120 - page 2

    XT ® -120 Xtreme T actical Laser Flashlight ...

  • Burris XT-120 - page 3

    CAUTIONS AND WARNINGS 1. Prior to the operation of any firearm in conjunction with the XT -120 make sure that you completely understand all safety pr ecautions and procedures contained in the XT -120 operator’ s manual as well as in the manual for your fir earm . Failu re to fo llow th ese pr ecaut ions ma y resu lt in dam age to pr oper ty , ser ...

  • Burris XT-120 - page 4

    need to point directly at the subject. Light fr om the XT -120 can be safely pointed at a wall, ceiling or floor and the resulting r eflected light will be sufficient to identify the object of inter est. The XT -120’ s light beam can also be adjusted for wide-angle illumination. 5. T he XT -1 20 all ows y ou to o pera te th e ON/O FF sw itch w hi ...

  • Burris XT-120 - page 5

    8. D o not op era te the X T -120 a ro und an y fla mmab le or c ombu sti ble ma ter ial such as cleaning solvents, paints or gasoline. Do not operate the XT -120 in an environment which may contain flammable gasses such as evapo- rated gasoline. 9. T est the XT -120 periodically , especially after periods of non-use or prior to employment to verif ...

  • Burris XT-120 - page 6

    Avoid Dir ect Exposure to Laser Radiation Beam Visible Laser Output Power: <5mW W avelength: 640±40nm Class IIIa Laser Product • Do not look into the laser beam directly or thr ough binoculars or telescopes. • Do not point the laser beam at mirror -like or reflective surfaces. • Do not shine the beam into the eyes of anyone. DANGER 4 ...

  • Burris XT-120 - page 7

    DANGER VIS ILL XT -120 W arning/Aperture/Mode Label LASER RADIA TION-A VOID DIRECT EYE EXPOSURE Max. Output-5mW , Wavelength:630 Complies with 21 CFR Chapter 1, Model: XT -120 Manufacture: Feb. 2005 Burris Company 331 East 8th Street, Gr eeley Colorado OFF VIS ILL A VOID EXPOSURE Laser radiation is emitted from the APER TURE A VOID EXPOSURE Laser r ...

  • Burris XT-120 - page 8

    For the location of the Laser W ar ning Label on the unit see the photo at left. WARNING Do not store the XT -120 with batteries installed. CAUTION Do not over turn the adjusters. 6 ...

  • Burris XT-120 - page 9

    7 ...

  • Burris XT-120 - page 10

    Mounting the XT -120 1. With your “cleared and safe” fir earm in either hand, hold the XT -120 in the other hand with the bulb pointing away from your body in th e same dir ection as the we apon muzzle . 2. Raise the XT -120 up and toward the firearm with the gr ooves of the XT -120 aligned with the firearm grooves. S lide t he XT -120 b ack un ...

  • Burris XT-120 - page 11

    Step 1 Step 2 9 ...

  • Burris XT-120 - page 12

    Dismounting the XT -120 1. Place your hand under the XT -120 with your index finger and thumb on each side of the latch bars. Squeeze the bars with the finger and thumb to disengage the latch bar from the firearm. 2. With the latch bars pressed in, slide the XT -120 forward, down and away from the weapon muzzle until clear of the gr ooves. CAUTION ...

  • Burris XT-120 - page 13

    Operating the Switch T h e r o ck er s wi tc h h a s tw o po si ti on s: MO ME NT A R Y and STEADY ON. The rocker switch is part of the backplate and you should not attempt to disassemble. MOMENT ARY POSITION Ro tate t he r ock er sw itc h in a clo ckw ise d ir ect ion to turn the light on in a MOMENT ARY position. Release the rocker switch to turn ...

  • Burris XT-120 - page 14

    Mode Switch: A rotary Mode Selection Switch on the XT -120 provides the option of four positions each indicated on the warning label - “OFF”, “VIS”, “ILL” and “VIS/ILL.” After activating the rocker switch, the modes ar e: OFF - the system will not operate VIS - only the visible laser is operable. ILL - only the white flashlight is o ...

  • Burris XT-120 - page 15

    ZEROING PROCEDURES P ri or t o u si ng a n y fi r ea rm w it h th e XT -1 2 0, b e su r e t o re a d an d un d er st a nd all procedur es and safety precautions associated with your weapon and the XT -120. Follow the proper “clearing” pr ocedures for your firearm befor e attempting to mount or dismount the XT -120. When you squeeze the trigger ...

  • Burris XT-120 - page 16

    4. Rotate the r ocker switch to one side until it clicks “ON.” 5. While aiming through the weapon’ s iron sights, adjust the visible aim point of the XT -120 with the provided adjusting (hex) tool until the aiming point of the beam is superimposed over the firearms’ s iron sight aiming point (see diagram). 6. Fire thr ee rounds into the cen ...

  • Burris XT-120 - page 17

    FOCUSING T urn the bezel on the XT -120 until you have your desired focus being careful not to uns crew t he beze l compl etely . CAUTION DO NOT place your hand in front of the fir earm muzzle while turning the bezel. 15 ...

  • Burris XT-120 - page 18

    BULB REPLACEMENT With the XT -120 detached from the fir earm, tur n the bezel counterclockwise until it comes free fr om the retaining threads. Remove the old bulb as shown and insert a new bulb in its place. Replace the bezel by carefully pushing down and rotating the bezel clockwise making sure that threads ar e engaged properly to p rev ent s tr ...

  • Burris XT-120 - page 19

    BA TTER Y REPLACEMENT 1. With the XT -120 detached from the fir earm, hold the unit in one hand and, with the thumb of your other hand, press down on the tab in the top center of the backplate. 2. While keeping the tab depressed, pivot the backplate away from the body of the XT -120. 3. Remove the batteries by tipping the bezel upward to allow the ...

  • Burris XT-120 - page 20

    4. Note the raised markings indicating battery orientation. Hold the XT -120 with mounting rails on top and the battery receptacle facing you. Insert a battery on the left side with the negative end first. Insert the other battery on the right side with the positive end first. 5. Place the bottom lip of the backplate into the bottom gr oove of the ...

  • Burris XT-120 - page 21

    MAINTENANCE WARNING: Make sure the weapon has been “clear ed” and on SAFE before mounting or dismounting the XT -120 by following the instruction manual for your firearm. Allow bulb assembly to completely cool before servicing. 1. Clean the XT -120 with mild, soapy water and rinse thoroughly with clean water to eliminate residue. Dry with a sof ...

  • Burris XT-120 - page 22

    LIMITED WARRANTY BURRIS 12 MONTH LIMITED WARRANTY Burris warrants for 12 months after purchase that its pr oducts will be free from defects in material and workmanship. At its sole discr etion, Burris will either repair or r eplace, at no charge, any product or part (with the exception of the lamp and battery) which is found to be defective under n ...

  • Burris XT-120 - page 23

    SERVICE: The XT -120 EXTREME T ACTICAL LASER FLASHLIGHT For service and repair , send via “UPS Prepaid” with a copy of the sales receipt to: Burris Co. 311 East 8th Street Greeley , CO 80631 Attn: Customer Service Phone: 970-356-1670 Fax: 970-356-8702 www .burrisoptics.com The exportation of this product falls under the jurisdiction of the U.S. ...

  • Burris XT-120 - page 24

    22 ...

Manufacturer Burris Category Home Safety Product

Documents that we receive from a manufacturer of a Burris XT-120 can be divided into several groups. They are, among others:
- Burris technical drawings
- XT-120 manuals
- Burris product data sheets
- information booklets
- or energy labels Burris XT-120
All of them are important, but the most important information from the point of view of use of the device are in the user manual Burris XT-120.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Burris XT-120, service manual, brief instructions and user manuals Burris XT-120. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Burris XT-120.

Similar manuals

A complete manual for the device Burris XT-120, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Burris XT-120 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Burris XT-120.

A complete Burris manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Burris XT-120 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Burris XT-120, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Burris XT-120, that we can find in the current document
3. Tips how to use the basic functions of the device Burris XT-120 - which should help us in our first steps of using Burris XT-120
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Burris XT-120
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Burris XT-120 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Burris XT-120?

Use the form below

If you did not solve your problem by using a manual Burris XT-120, ask a question using the form below. If a user had a similar problem with Burris XT-120 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)