English dropdown-ico

Manual Gefen EXT-HDMI1.3-442

18 pages 0.2 mb
Download

Go to site of 18

Summary
  • Gefen EXT-HDMI1.3-442 - page 1

    4x2 Switcher for HDMI ® 1.3 EXT-HDMI1.3-442 User Manual www.gefen.com ...

  • Gefen EXT-HDMI1.3-442 - page 2

    ASKING FOR ASSIST ANCE Rev B3 T echnical Support : T elephone (818) 772-9100 (800) 545-6900 Fax (818) 772-9120 T echnical Support Hours: 8:00 AM to 5:00 PM Monday thru Friday PST Write T o: Gefen, LLC. c/o Customer Service 20600 Nordhoff St Chatsworth, CA 9131 1 www .gefen.com support@gefen.com Notice Gefen, LLC reserves the right to make changes i ...

  • Gefen EXT-HDMI1.3-442 - page 3

    CONTENTS 1 Introduction 2 Operation Notes 3 Features 4 Panel Layout 5 Panel Descriptions 6 Connecting And Operating The 4x2 Switcher For HDMI 1.3 7 IR Remote Control Description 8 IR Remote Installation 9 IR Remote Con fi guration 10 IR Channel Con fi guration 1 1 EDID Management 1 1 Internal EDID 12 External EDID 13 Speci fi cations 14 W arrant ...

  • Gefen EXT-HDMI1.3-442 - page 4

    1 INTRODUCTION Congratulations on your purchase of the 4x2 Switcher for HDMI 1.3. Y our complete satisfaction is very important to us. Gefen Gefen delivers innovative, progressive computer and electronics add-on solutions that harness integration, extension, distribution and conversion technologies. Gefen’s reliable, plug-and-play products supple ...

  • Gefen EXT-HDMI1.3-442 - page 5

    2 READ THESE NOTES BEFORE INST ALLING OR OPERA TING THE 4X2 SWITCHER FOR HDMI 1.3 • By default, display information from the display connected to HDMI output port 1 is sent back to the source. Therefore, the other display connected to the 4x2 Switcher for HDMI 1.3 must be capable of accepting the timings, resolutions and audio formats of the disp ...

  • Gefen EXT-HDMI1.3-442 - page 6

    3 FEA TURES HDMI 1.3 Features • 225 MHz (up to 12 bit YUV 444 supported @ 1080p) • Deep Color • Dolby T rueHD and DTS-HD Master Audio • Lip Sync • CEC Pass-Through Features • Easily switch between any four (4) Hi-Def sources on up to two (2) HDTV displays without signal loss • Maintains sharp HDTV resolutions up to 1080p Full HD and 2 ...

  • Gefen EXT-HDMI1.3-442 - page 7

    4 P ANEL LA YOUT Front Panel Back Panel 1 2 3 4 5 6 7 8 9 10 11 12 ...

  • Gefen EXT-HDMI1.3-442 - page 8

    5 P ANEL DESCRIPTIONS 1 Power Indicator This LED will become active once the included 5V DC power supply is properly connected between the unit and a open wall power receptacle. 2 IR (Infrared) Receiver This receiver will accept command for switching between input HDMI devices using the included RMT -4IR remote control. 3 Internal EDID Mode Indicat ...

  • Gefen EXT-HDMI1.3-442 - page 9

    6 How to Connect the 4x2 Switcher for HDMI 1.3 1. Connect up to two HDMI source devices to the 4x2 Switcher for HDMI 1.3 using the supplied HDMI cables. 2. Connect up to four HDMI capable devices to the 4x2 Switcher for HDMI 1.3 using the supplied HDMI cables. 3. Connect the included 5V DC power adapter to the 4x2 Switcher for HDMI 1.3 power input ...

  • Gefen EXT-HDMI1.3-442 - page 10

    7 IR REMOTE DESCRIPTION 1 LED Button Press Indicator This LED will be activated momentarily each time a button is pressed. 2 Display and Source Selection Buttons These buttons are used to select which source is routed to the displays. Example: Route the source connected to Input 3 to the displays connected to Output 1 and Output 2. 1. Press button ...

  • Gefen EXT-HDMI1.3-442 - page 11

    8 Installing the IR Remote Control Battery 1. Remove the battery cover on the back of the IR Remote Control unit. 2. Insert the included battery into the open battery slot. The positive (+) side of the battery should be facing up. 3. Replace the battery cover . The Remote Control unit ships with two batteries. One battery is required for operation ...

  • Gefen EXT-HDMI1.3-442 - page 12

    9 IR REMOTE CONFIGURA TION Setting the IR Remote Channel on the RMT -8IR In the event that IR commands from other remote controls con fl ict with the supplied IR Remote Control Unit, changing the remote IR channel will fi x this issue. The IR Remote Control Unit has a bank of DIP switches for setting the Remote IR channel. The DIP Switch bank is ...

  • Gefen EXT-HDMI1.3-442 - page 13

    10 IR CHANNEL CONFIGURA TION Setting The IR Channel Use the following procedure to set the proper IR channel on the 4x2 Switcher for HDMI 1.3. 1 Press and hold the EDID button. 2 While holding the EDID button, press and release the Reset button. The input LED indicators, on the front panel, will represent the current IR channel for the Switcher: A ...

  • Gefen EXT-HDMI1.3-442 - page 14

    11 EDID MANAGEMENT EDID Mode Selection 1. EXTERNAL MODE : See page 10 for details on using the External EDID. 2. INTERNAL MODE : T o use this mode, press the EDID button on the rear panel until the front- panel LED marked “Int” turns bright green. This mode will use a preset EDID, from the factory , that is stored in the Gefen 4x2 Switcher for ...

  • Gefen EXT-HDMI1.3-442 - page 15

    12 EDID MANAGEMENT External EDID Management The 4x2 Switcher for HDMI 1.3 features EDID Management. Before the source can send video or audio signals, the source device reads the EDID (Extended Display Identi fi cation Data) from the output devices connected to the Splitter . The EDID contains information about what type of A/V data that the sourc ...

  • Gefen EXT-HDMI1.3-442 - page 16

    13 Video Ampli fi er Bandwidth ............................................................... 225 MHz Input Video Signal ...................................................................... 1.2 V olts p-p Input DDC Signal ................................................................ 5 V olts p-p (TTL) HDMI Input Connectors .................. ...

  • Gefen EXT-HDMI1.3-442 - page 17

    14 W ARRANTY Gefen warrants the equipment it manufactures to be free from defects in material and workmanship. If equipment fails because of such defects and Gefen is noti fi ed within two (2) years from the date of shipment, Gefen will, at its option, repair or replace the equipment, provided that the equipment has not been subjected to mechanica ...

  • Gefen EXT-HDMI1.3-442 - page 18

    20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 818-772-9100 fax: 818-772-9120 www .gefen.com support@gefen.com Rev B3 Pb This product uses UL listed power supplies. ...

Manufacturer Gefen Category Switch

Documents that we receive from a manufacturer of a Gefen EXT-HDMI1.3-442 can be divided into several groups. They are, among others:
- Gefen technical drawings
- EXT-HDMI1.3-442 manuals
- Gefen product data sheets
- information booklets
- or energy labels Gefen EXT-HDMI1.3-442
All of them are important, but the most important information from the point of view of use of the device are in the user manual Gefen EXT-HDMI1.3-442.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Gefen EXT-HDMI1.3-442, service manual, brief instructions and user manuals Gefen EXT-HDMI1.3-442. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Gefen EXT-HDMI1.3-442.

Similar manuals

A complete manual for the device Gefen EXT-HDMI1.3-442, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Gefen EXT-HDMI1.3-442 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Gefen EXT-HDMI1.3-442.

A complete Gefen manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Gefen EXT-HDMI1.3-442 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Gefen EXT-HDMI1.3-442, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Gefen EXT-HDMI1.3-442, that we can find in the current document
3. Tips how to use the basic functions of the device Gefen EXT-HDMI1.3-442 - which should help us in our first steps of using Gefen EXT-HDMI1.3-442
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Gefen EXT-HDMI1.3-442
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Gefen EXT-HDMI1.3-442 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Gefen EXT-HDMI1.3-442?

Use the form below

If you did not solve your problem by using a manual Gefen EXT-HDMI1.3-442, ask a question using the form below. If a user had a similar problem with Gefen EXT-HDMI1.3-442 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)