English dropdown-ico

Manual Peavey IRM 8150

16 pages 0.16 mb
Download

Go to site of 16

Summary
  • Peavey IRM 8150 - page 1

    1 IRM 8150 Powered Mixer ...

  • Peavey IRM 8150 - page 2

    2 Thank you for purchasing the Peavey IRM™ 8150 mixer amplifier . This is an eight-channel, easy-to-use, powered mixer . Y our IRM ™ 8150 features a rugged, heavy-gauge, cold-rolled steel and aluminum chassis, finished in oven-cured epoxy for toughness and screen-printed utilizing the latest photo- graphic film and U.V .-cured ink technology fo ...

  • Peavey IRM 8150 - page 3

    3 CHANNEL SECTION: LEVEL (1) Controls the channel output level. This signal is routed via the main bus to the main level control. The channel level also affects the signal to the AUX send control. MONITOR (MON.) (2) Controls the channel monitor mix level. This is independent of all other channel controls. Controls the amount of signal from a partic ...

  • Peavey IRM 8150 - page 4

    4 AUX SEND (6) Controls the channel AUX drive level. This signal is routed to the AUX master control, where AUX send signals from all channels are summed together. Controls amount of send from a particular channel to AUX output. The channel level control also affects the signal from the AUX send. MASTER SECTION: POWER INDICATOR: PILOT LIGHT LED (7) ...

  • Peavey IRM 8150 - page 5

    5 TAPE/AUX TO MON (14) Controls the level of tape or AUX IN signal to be sent to the mon. bus. This signal will be mixed with channel monitor signals. TAPE OUT/TAPE IN: CAUTION Before placing connected tape decks in the "record" mode, set the TAPE/AUX IN level control to "0" or off. Most tape decks feed the input signal directly ...

  • Peavey IRM 8150 - page 6

    6 LINE INPUT JACK (18) For use with line level signal or compatible high Z microphones equipped with a 1/4" phone plug. NOTE: These input jacks (17 & 18) are typical of each channel. It is possible to use both the mic and line inputs on a single channel simultaneously. It is, however, unlikely that the gain matching of the mic and line wil ...

  • Peavey IRM 8150 - page 7

    7 VENT VOIDING THE WARRANTY. If the amp repeatedly blows fuses, it should be taken to a qualified service center for repair. WARNING: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS BEEN DISCONNECTED FROM ITS POWER SOURCE. POWER SWITCH (28) Center position is OFF. Two ON positions are provided, one of which will properly ground the amplifi ...

  • Peavey IRM 8150 - page 8

    8 SPECIFICA TIONS NOTE: All specifications are typical unless otherwise noted. 0 dBV = 1 volt RMS 0 dBu = .778 volts RMS All specs are referenced to nominal output level (0 dBV) unless otherwise noted. All measurements are wideband 20 Hz to 20 kHz unless otherwise stated. All control settings are nominal (50% rotation) unless otherwise noted. CHANN ...

  • Peavey IRM 8150 - page 9

    9 Output Impedance: 100 ohms MASTER Gain: Main: = 20 dB Monitor: = 15 dB Tape: = 15 dB Aux: = 15 dB Maximum Output Level: Main: = +18 dBV (8.0 V RMS) Monitor: = +18 dBV (8.0 V RMS) Tape: = +18 dBV (8.0 V RMS) Aux: = +18 dBV (8.0 V RMS) Nominal Headroom: Main: = 18 dB Monitor: = 18 dB Tape: = 18 dB Aux: = 18 dB Output Impedance: Main: = 100 ohms Mon ...

  • Peavey IRM 8150 - page 10

    10 XFMR 4 Ω GND LO HI Balanced (600 Ω ) 4 Ω – + Direct Output to 4 Ω Speaker T ra nsform er Output to 8 Ω Speaker (Note: Jumper must be in place.) COM 8 Ω 25V 70V NC 8 Ω + – HI XFMR 4 Ω GND LO Balanced (600 Ω ) Jumper Installed XFMR 4 Ω GND LO Balanced (600 Ω ) Jumper Installed HI T o Booster , Amplifier , etc. Balanced Ou ...

  • Peavey IRM 8150 - page 11

    11 XFMR 4 Ω GND LO HI Balanced (600 Ω ) 8 Ω – + Direct Output to Multiple Speakers in Parallel. T otal Impedance = 4 Ω 8 Ω – + ...

  • Peavey IRM 8150 - page 12

    12 ...

  • Peavey IRM 8150 - page 13

    13 CHANNEL INPUT MAX (1/4") (+ 26 dBV) CHANNEL INPUT MINIMUM (1/4") (-20 dBV) CHANNEL INPUT NOMINAL (1/4") (0 dBV) CHANNEL INPUT MINIMUM (XLR) (GAIN -40 dBV) MAIN, MON, T APE, AUX OUTPUTS (-0 dBV) NOMINAL 30 20 10 0 -10 -20 -30 -40 -50 -60 -70 dBV FLA T CHANNEL EQ -12 dBV CUT +12 dBV BOOST 50 HZ &10 kHz CHANNEL INPUT NOMINAL (XLR ...

  • Peavey IRM 8150 - page 14

    14 LIMITED WARRANTY Peavey Electronics Corporation warrants to the original purchaser of this new Architectural Acoustics product that it is free from defects in material and workmanship. If within one (1) year from date of purchase a properly installed product proves to be defective and Peavey is notified, Peavey will repair or replace it at no ch ...

  • Peavey IRM 8150 - page 15

    15 IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electric products, basic cautions should always be followed, including the following. 1. Read all safety and operating instructions before using this product. 2. All safety and operating instructions should be retained for future reference. 3. Obey all cautions in the operating instructions and o ...

  • Peavey IRM 8150 - page 16

    16 Features and specifications subject to change without notice. A Division of Peavey Electronics Corporation 711 A Street / Meridian, MS 39302-2898 / U.S.A. / (601) 483-5376 / Telex 504115 / Fax 486-1278 ©1994 #80302192 Printed in U.S.A. 10/94 ® ARCHITECTURAL ACOUSTICS ® ...

Manufacturer Peavey Category Music Mixer

Documents that we receive from a manufacturer of a Peavey IRM 8150 can be divided into several groups. They are, among others:
- Peavey technical drawings
- IRM 8150 manuals
- Peavey product data sheets
- information booklets
- or energy labels Peavey IRM 8150
All of them are important, but the most important information from the point of view of use of the device are in the user manual Peavey IRM 8150.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Peavey IRM 8150, service manual, brief instructions and user manuals Peavey IRM 8150. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Peavey IRM 8150.

Similar manuals

A complete manual for the device Peavey IRM 8150, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Peavey IRM 8150 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Peavey IRM 8150.

A complete Peavey manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Peavey IRM 8150 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Peavey IRM 8150, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Peavey IRM 8150, that we can find in the current document
3. Tips how to use the basic functions of the device Peavey IRM 8150 - which should help us in our first steps of using Peavey IRM 8150
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Peavey IRM 8150
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Peavey IRM 8150 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Peavey IRM 8150?

Use the form below

If you did not solve your problem by using a manual Peavey IRM 8150, ask a question using the form below. If a user had a similar problem with Peavey IRM 8150 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)