Manual Kenwood KDC-U40R

19 pages Not applicable
Download

Go to site of 19

Summary
  • Kenwood KDC-U40R - page 1

    KDC-U40R KDC-U30R CD-RECEIVER INSTRUCTION MANUAL CD-RECEIVER BEDIENUNGSANLEITUNG РAДИОПРИЕMНИК С KOMПAKT –ДИСKAMИ ИHCTPУKЦИЯ ПO ЭKCПЛУA T AЦИИ АВТОМАГНІТОЛА ІНСТРУКЦІЯ З ЕКСПЛУ А Т АЦІЇ GET0751-001A (E0) © 2011 JVC KENWOOD Corporation Изделие изгот овлено в Ин ...

  • Kenwood KDC-U40R - page 2

    2 Safety 2 Preparation 4 How to attach/detach the faceplate How to reset your unit Basic operations 4 Getting started 6 Canceling the display demonstration Setting the demonstration mode Adjusting the clock Initial settings before operations Listening to the radio 8 Adjust [SETTINGS] mode settings Listening to the other external components 9 Listen ...

  • Kenwood KDC-U40R - page 3

    3 ENGLISH Information on Disposal of Old Electrical and Electronic Equipment and Batteries (applicable for EU countries that have adopted separate waste collection systems) Pr oducts and batteries with the symbol (crossed-out wheeled bin) cannot be disposed as household waste. Old electrical and electronic equipment and batteries should be recycled ...

  • Kenwood KDC-U40R - page 4

    4 Preparation How to attach/detach the faceplate 2 1 1 2 Do not expose the faceplate to direct sunlight, excessive heat, or humidity . Also avoid places with too much dust or the possibility of water splashing. Keep the faceplate in its casing while detached. The faceplate is a precision piece of equipment and can be damaged by shocks or jolts. T o ...

  • Kenwood KDC-U40R - page 5

    5 ENGLISH When you press or hold the f ollowing button(s)... Button General operation SRC T urns on. T urns off if pressed and held. Selects the available sources ( TUNER, USB/ iPod, CD , AUX, ST ANDBY ), if the power is turned on. • If the source is ready, playback also starts. • “iPod” or “CD” is selectable only when an iPod is connec ...

  • Kenwood KDC-U40R - page 6

    6 Getting started Canceling the display demonstration The display demonstration is always turned on unless you cancel it. When you turn on the power (or after you reset the unit), the display shows: [CANCEL] [ DEMO] [PRESS] [VOLUME] [KNOB] 1 Press the volume knob. [ <Y>/ N ] is selected as the initial setup. 2 Press the volume knob ag ...

  • Kenwood KDC-U40R - page 7

    7 ENGLISH Item Selectable setting (Preset: *) PRESET TYPE NML *: Memorizes one station for each preset button in each band (FM1/ FM2/ FM3/ MW/ LW). ; TYPE MIX: Memorizes one station for each preset button regardless of the selected band (FM1/ FM2/ FM3/ MW/ LW). KEY BEEP BEEP ON */ BEEP OFF: Activates/deactivates the keypress tone. RUSSIAN RUS ON: F ...

  • Kenwood KDC-U40R - page 8

    8 Adjust [SETTINGS] mode settings While listening to the radio... 1 Press the volume knob to enter [FUNCTION] mode. 2 Turn the volume knob to select [SETTINGS] , then press to enter. 3 Turn the volume knob to make a selection, then press to confirm. See table below for selection. 4 Hold to finish the procedure. Item Selectable setting (Preset: *) L ...

  • Kenwood KDC-U40R - page 9

    9 ENGLISH Item Selectable setting (Preset: *) REGIONAL REG ON *: Switches to another station only in the specific region using the “AF” control. ; REG OFF: Cancels. ATP SEEK ATPS ON *: Automatically searches for a station with better reception when the traffic information‘s reception is poor. ; ATPS OFF: Cancels. [MONO SET/ PTY SRCH] is selec ...

  • Kenwood KDC-U40R - page 10

    10 Start playing a disc 1 Press SRC to turn on the power. 2 Insert a disc into the loading slot. Playback starts automatically. 3 Press number button 6 ( ) to resume/ pause playback (if necessary). Ejects the disc. (“NO DISC” appears and “IN” indicator goes off.) Loading slot Pr ess to select track/file. Hold to fast-forwards/reverses . Lis ...

  • Kenwood KDC-U40R - page 11

    11 ENGLISH Selecting Repeat Play Press number button 4 (REP) repeatedly to make a selection. Audio CD : TRAC REP (track repeat), REP OFF (repeat off) AAC/MP3/WMA : FILE REP (file repeat), FOLD REP (folder repeat), REP OFF (repeat off) iPod : FILE REP (file repeat), REP OFF (repeat off) Selecting Random Play Press number button 3 (RDM) repeatedly to ...

  • Kenwood KDC-U40R - page 12

    12 Selecting a song by alphabet 1 Press (BAND) to enter Music Search mode. “SEARCH” appears. 2 Turn the volume knob to select a category, then press to confirm. 3 Press (BAND) again to enter alphabet search mode. “SRCH – – – ” appears. 4 Turn the volume knob to select the character to be searched for. 5 Press 4 / ¢ to move to the ent ...

  • Kenwood KDC-U40R - page 13

    13 ENGLISH 1 To enter [AUD CTRL] menu (see table below): Press AUDIO . To enter [SETTINGS] menu (page 14): Press the volume knob to enter [FUNCTION] mode. Turn the volume knob to select [SETTINGS] , then press to enter. 2 Turn the volume knob to make a selection, then press to confirm. Repeat this step until the desired item is selected/activated. ...

  • Kenwood KDC-U40R - page 14

    14 Item Selectable setting (Preset: *) DTIL SET LPF SW LPF THRU *: All signals are sent to the subwoofer. ; LPF 85H/ LPF 120H/ LPF 160H: Frequencies higher than 85 Hz/ 120 Hz/ 160 Hz are cut off. SW PHASE PHAS REV (180°) / PHAS NML * (0°) : Selects the phase angle of the subwoofer output to be in line with the speaker output for optimum performan ...

  • Kenwood KDC-U40R - page 15

    15 ENGLISH Symptom Remedy/Cause The unit does not work at all. Reset the unit. (page 4) [OFF WAIT] does not work. Turn off the demonstration mode. (page 6) Radio reception is poor. / Static noise while listening to the radio. Connect the antenna firmly. / Pull the antenna out all the way. “IN” flashes. The CD player is not operating properly. R ...

  • Kenwood KDC-U40R - page 16

    16 Installation/connection Part list: A F aceplate.............................................................. (×1) B Escutcheon ......................................................... (×1) C Mounting sleeve ............................................. (×1) D Casing f or faceplate ...................................... (×1) E Wiring harnes ...

  • Kenwood KDC-U40R - page 17

    17 ENGLISH Wiring connection REMOTE CONT STEERING WHEEL REMOTE INPUT MUTE P . CONT ANT CONT RL REAR/SW Fuse (10 A) Antenna terminal (JASO) Light blue/yellow (Steering remote control wire) To the steering wheel remote control adapter Blue/White (Power control wire/ Antenna control wire) Brown (Mute control wire) To the power control terminal when us ...

  • Kenwood KDC-U40R - page 18

    18 Installing the unit Removing the unit 2 1 Connect the wiring harness to the unit. Other wiring connection has been completed earlier . (page 17) Before attaching , make sure the direction of the escutcheon is correct. ( Wider hooks on the top side.) Dashboard of your car 1 Detach the faceplate. 2 Engage the catch pin on the removal tools into th ...

  • Kenwood KDC-U40R - page 19

    19 ENGLISH USB interface USB standard: USB1.1/ 2.0 (F ull speed) Maximum supply current: DC 5 V 1 A File system: F A T16/ 32 AAC decode: AAC-L C “ .m4a” files MP3 decode: Compliant with MPEG-1/2 Audio Layer-3 WMA decode: Compliant with Windows Media Audio Audio section Maximum output power: 50 W × 4 Output power (DIN 45324, +B = 14.4 V): 30 W ...

Manufacturer Kenwood Category Car Radio

Documents that we receive from a manufacturer of a Kenwood KDC-U40R can be divided into several groups. They are, among others:
- Kenwood technical drawings
- KDC-U40R manuals
- Kenwood product data sheets
- information booklets
- or energy labels Kenwood KDC-U40R
All of them are important, but the most important information from the point of view of use of the device are in the user manual Kenwood KDC-U40R.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Kenwood KDC-U40R, service manual, brief instructions and user manuals Kenwood KDC-U40R. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Kenwood KDC-U40R.

Similar manuals

A complete manual for the device Kenwood KDC-U40R, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Kenwood KDC-U40R by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Kenwood KDC-U40R.

A complete Kenwood manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Kenwood KDC-U40R - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Kenwood KDC-U40R, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Kenwood KDC-U40R, that we can find in the current document
3. Tips how to use the basic functions of the device Kenwood KDC-U40R - which should help us in our first steps of using Kenwood KDC-U40R
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Kenwood KDC-U40R
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Kenwood KDC-U40R in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Kenwood KDC-U40R?

Use the form below

If you did not solve your problem by using a manual Kenwood KDC-U40R, ask a question using the form below. If a user had a similar problem with Kenwood KDC-U40R it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)