English dropdown-ico

Manual Wagner SprayTech GP2905

27 pages 0.7 mb
Download

Go to site of 27

Summary
  • Wagner SprayTech GP2905 - page 1

    Diaphr agm Pumps 1 150 Pist on Pumps EP2105 EP2205 EP2300 EP2300se EP2400 EP2510 GP2605 GP2905 HVLP CS5100 CS8100 CS9100 Maxum II Gun Diaphr agm Pumps 1 150 Pist on Pumps EP2105 EP2205 EP2300 EP2300se EP2400 EP2510 GP2605 GP2905 HVLP CS5100 CS8100 CS9100 Maxum II Gun ...

  • Wagner SprayTech GP2905 - page 2

    ...

  • Wagner SprayTech GP2905 - page 3

    1  Owner's Manual ED1 1 50 Airless Spr ayer Model no. 0294059 Form no . 0294968C © 1996 Wagner Spr ay T ech. All r ights reserved. Plus ...

  • Wagner SprayTech GP2905 - page 4

    2 THIS UNIT IS PROVIDED WITH A THERMALLY PROTECTED AUTOMATIC RESET. IF AN OVERLOAD OCCURS THE THERMALLY PROTECTED AUTOMATIC RESET DISCONNECTS THE MOTOR FROM THE POWER SUPPLY. • Motor will restart without warning when protector automatically resets. • Always disconnect motor from power supply before working on equipment. • When thermally prote ...

  • Wagner SprayTech GP2905 - page 5

    3 SAFETY PRECA UTIONS This manual contains information which must be read and understood before using the equipment. When you come to an area which has one of the following symbols, pay particular attention and make certain to heed the safeguard. WARNING Important safety information indicates a hazard which may cause serious injury or loss of life. ...

  • Wagner SprayTech GP2905 - page 6

    4 WARNING PREVENTION HAZARD • • Paint hose can develop leaks from wear, kinking, abuse, etc. A leak is capable of injecting material into the skin. The paint hose should be inspected before each use. • NEVER use a spray gun which does not have a trigger lock or trigger guard in place and in working order. • All accessories must be rated at ...

  • Wagner SprayTech GP2905 - page 7

    5 WARNING HAZARD PREVENTION Explosion or fire - Solvent and paint fumes can explode or ignite causing property damage and/or severe injury. • Exhaust and fresh air introduction must be provided to keep the air within the spray area free from accumulation of flammable vapors. • Avoid all ignition sources such as static electricity sparks open fl ...

  • Wagner SprayTech GP2905 - page 8

    6 WARNING PREVENTION HAZARD Explosion hazard incompatible materials - May cause property damage or severe injury. General - May cause property damage or severe injury. Hazardous vapors - Paints, solvents, insecticides, and other materials may be harmful if inhaled causing se- vere nausea, fainting, or poisoning. • Read all instructions and safety ...

  • Wagner SprayTech GP2905 - page 9

    7 GENERAL DESCRIPTION Be sure to read the IMPORTANT SAFETY INFORMA- TION on pages 3 thru 6 before using this sprayer. Your SprayTECH sprayer is a powerful, easy to operate and easy to service machine. Since it operates on the airless principle, no air compressor is needed. Power is supplied by a 3/4 horsepower, TEFC electric motor. The flow rate is ...

  • Wagner SprayTech GP2905 - page 10

    8 The paint pump is located below the hydraulic pump (see Figure 1). The two pumps are bolted together by four socket head capscrews. The diaphragm separates the pumps. The paint pump operates as follows: The piston in the hydraulic pump forces hydraulic oil toward and away from the diaphragm. This action moves the diaphragm up and down. Diaphragm ...

  • Wagner SprayTech GP2905 - page 11

    9 tainer. When the priming knob is turned to (prime), paint is drawn up the suction tube into the paint pump. The paint pump then routes the paint through the return tube back to the paint container. This primes the painting system. When the priming knob is turned to (spray), flow is shut off through the return tube and the sprayer can spray. The o ...

  • Wagner SprayTech GP2905 - page 12

    10 ASSEMBL Y OF A NEW SPRA YER 1. Screw the return fitting into the elbow on the front side of the paint pump. Both fittings should be hand tight only, but tight enough to prevent air from being drawn in. 2. Screw the paint hose, wrench tight, onto the outlet fitting on the front side of the paint pump. SPRA Y GUN TIP SELECTION Select a spray gun t ...

  • Wagner SprayTech GP2905 - page 13

    11 4. Tighten tip nut. The tip guard should now be in the proper position. See Figure 5. Figure 4.- Spray Gun Tip Guard Postion Before Tightening. 3. Loosen the tip nut slightly. Turn the tip guard about 1/16 turn counterclockwise from desired spray angle. See Figure 4. Figure 6.-Spray Gun Filter Assembly and Trigger Safety Lever position. 6. Test ...

  • Wagner SprayTech GP2905 - page 14

    12 OPERA TION ST AR T UP PROCEDURE SPRA Y P AINTING You can learn to spray paint as easy as you can learn to paint with a brush or roller. You can get a professional looking job in a safe manner by following the spray painting tips below. 1. Heed all WARNINGS and CAUTIONS that are listed on pages 2 thru 6 at the front of this manual. Take time out ...

  • Wagner SprayTech GP2905 - page 15

    13 2. Avoid sharp bending and kinking of the paint hose. The paint hose and electric cord should be kept clear of traffic and sharp cutting edges or objects. 3. Use the lowest pressure possible when spraying. Too much pressure shortens equipment life. It also causes faster than normal wear on the spray tip. 4. Determine the best spraying distance ( ...

  • Wagner SprayTech GP2905 - page 16

    14 SPRA Y TIP PLUGGING The spray tip can be plugged by foreign matter and “skin” in the paint. Excessively large paint pigments can also plug the tip. If the tip becomes plugged while spraying, proceed as follows: 1. Lock spray gun trigger OFF so that the spray gun can't spray. 2. Turn sprayer ON/OFF switch OFF. 3. Reduce pressure by turni ...

  • Wagner SprayTech GP2905 - page 17

    15 IMPORT ANT! Tighten the (4) Pump Block Bolts after the first 20 hours of use. To tighten, use the 6mm allen wrench supplied in the literature kit. Use a criss cross pattern when tightening. First A, then C, then B, then D. If you have a torque wrench use 13-15 Ft./Lbs. SHUTDO WN AND CLEANUP MAINTENANCE 11.Turn ON-OFF Switch OFF. 10. Remove sucti ...

  • Wagner SprayTech GP2905 - page 18

    16 CHECKING OPERA TION OF INLET V AL VE See Figure 14 for location of inlet valve. The inlet valve should be checked if the sprayer draws up little or no paint. It is a good practice to check inlet valve operation before spraying. If the sprayer has been in storage, the inlet valve may be sticky. To check inlet valve operation, proceed as follows: ...

  • Wagner SprayTech GP2905 - page 19

    17 When the diaphragm or diaphragm parts have to be re- placed, proceed as follows: 1. Remove the 4 paint pump screws with a 6 millimeter alIen wrench. As you remove the 4 screws, also remove the 4 washers that may remain in the holes. Figure 15. - Remove paint pump screws 2. Take the paint pump housing off the hydraulic pump housing. 3. Remove the ...

  • Wagner SprayTech GP2905 - page 20

    18 Problom Sprayer does not startup Sprayer starts up but does not draw up paint Sprayer draws up paint but pressure does not build up Cause TR OUBLESHOO TING Provided you have followed the instructions, the sprayer will operate efficiently and give trouble-free service. Should any unexpected problem arise you can, in most cases, remedy the problem ...

  • Wagner SprayTech GP2905 - page 21

    19 TR OUBLESHOO TING (Continued) Problem Sprayer draws up paint, pressure builds up, but drops away markedly when gun is opened (low performance) Pressure fluctuation . Paint in hydraulic housing Spray gun won't shut off Cause 1. No spray tip on gun 2. Spray tip hole too large 3. Suction filter clogged 4. Gun filter plugged 5. Gun filter too f ...

  • Wagner SprayTech GP2905 - page 22

    20 TR OUBLESHOO TlNG (Concluded) 1. Worn valve ball holder on gun 1. Out of spray material 2. Spray tip or gun filter plugged 1. Partially plugged spray tip or filter 1. Valve ball holder not in correct position Problem Cause Remedy NOTE1: If a return line that is completely submerged in paint causes bubbles after priming, you probably have a vacuu ...

  • Wagner SprayTech GP2905 - page 23

    21 ITEM PART NO. DESCRIPTION QTY. ITEM PART NO. DESCRIPTION QTY. 1 0288478 Grip, 1 2 0294511 Handle 1 3 0088328 Washer, Lock, 5/16" 4 4 9800325 Screw, Soc. Hd. 8mm x 16mm Lg. 1 5 0089935 Elbow, Barb 2 6 0270504 Tubing, 5/16" O.D., 3/16" I.D. 1 7 0294656 Filter 1 8 9822515 Ring, Retaining 1 9 0270501 Washer 1 10 0005311 Spring 1 11 00 ...

  • Wagner SprayTech GP2905 - page 24

    22 Paint Pump Assembly — Figure 19 ©1995 WAGNER SPRAY TECH CORPORATION. ALL RIGHTS RESERVED. ‰ 1 2 3 4 5 6 7 8 9 10 11 12 13 14 17 18 17 19 20 21 22 23 24 25 26 15 16 ...

  • Wagner SprayTech GP2905 - page 25

    23 P AINT PUMP ASSEMBL Y — Figure 19 ITEM PART NO. DESCRIPTION QTY. ITEM PART NO. DESCRIPTION QTY. 1 0270201 Diaphragm assy. 1 2 0270494 Ring, diaphragm 1 3 0294216 Pusher assy, outlet valve 1 (Includes O-ring P/N 9971327) 4 0294672 Kit, repair outlet valve 1 5 0010778 Seal, ball seat 1 6 0294264 Housing assy., outlet seat 1 7 0270491 Ball 1 8 02 ...

  • Wagner SprayTech GP2905 - page 26

    24 0294218 SUCTION SET ASSEMBL Y ITEM PART NO. DESCRIPTION QTY. A CCESSORIES Part No. Description 0153--- Tungsten C arbide Flat Tips 0153003 Tip Guard, Flat Tip 0093641 Hopper Assembly, 6 gallon 0291004 Hose, Whip End, 3' x 3/16'' 0291003 Hose, Whip End, 5' x 3/16" 0291002 Hose, Wireless, 25' x 1/4'' 0291000 ...

  • Wagner SprayTech GP2905 - page 27

    28 What Is Covered By This Warranty: This product, manufactured by SprayTech Corporation (SprayTech), is warranted against defects in material and workmanship for one (1) year following date of purchase if operated in accordance with SprayTech's printed recommendations and instructions. For SprayTech EP and GP (piston) sprayers: In addition, f ...

Manufacturer Wagner SprayTech Category Paint Sprayer

Documents that we receive from a manufacturer of a Wagner SprayTech GP2905 can be divided into several groups. They are, among others:
- Wagner SprayTech technical drawings
- GP2905 manuals
- Wagner SprayTech product data sheets
- information booklets
- or energy labels Wagner SprayTech GP2905
All of them are important, but the most important information from the point of view of use of the device are in the user manual Wagner SprayTech GP2905.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Wagner SprayTech GP2905, service manual, brief instructions and user manuals Wagner SprayTech GP2905. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Wagner SprayTech GP2905.

Similar manuals

A complete manual for the device Wagner SprayTech GP2905, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Wagner SprayTech GP2905 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Wagner SprayTech GP2905.

A complete Wagner SprayTech manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Wagner SprayTech GP2905 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Wagner SprayTech GP2905, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Wagner SprayTech GP2905, that we can find in the current document
3. Tips how to use the basic functions of the device Wagner SprayTech GP2905 - which should help us in our first steps of using Wagner SprayTech GP2905
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Wagner SprayTech GP2905
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Wagner SprayTech GP2905 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Wagner SprayTech GP2905?

Use the form below

If you did not solve your problem by using a manual Wagner SprayTech GP2905, ask a question using the form below. If a user had a similar problem with Wagner SprayTech GP2905 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)