-
Wayne-Dalton 8700 - page 1
GARAGE DOORS & OPENERS Part No. IMPORT ANT NO TICES! Wayne-Dalton highly recommends that you read and fully under - stand the Installation Instructions and Owner’ s Manual before you attempt this installation. T o avoid possible injur y , read the enclosed instructions carefully before installing and operating the garage door . Pay close atte ...
-
Wayne-Dalton 8700 - page 2
2 Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com A. FLAG ANGLES (AS REQUIRED): A1. Fully Adjustable (F .A.) Flag Angles A2. Quick Install (Q.I.) F ...
-
Wayne-Dalton 8700 - page 3
I m p o r t a n t S a f e t y I n s t r u c t i o n s DEFINITION OF KEY WORDS USED IN THIS MANUAL: W ARNING W ARNING INDICA TES A POTENTIALL Y HAZARDOUS SITUA TION WHICH; IF NOT AVOIDED , COULD RESUL T IN SEVERE OR FA T AL INJURY . CAUTION: PROPER TY DAMAGE OR INJURY CAN RESUL T FROM FAILURE TO FOLLOW INSTRUCTIONS. IMPORT ANT : REQUIRED STEP FOR SA ...
-
Wayne-Dalton 8700 - page 4
Cable drums RH/LH Center bracket bushing Torsion springs RH/LH End bearing brackets RH/LH Counterbalance lift cables (2) 5/16”-18 Hex nuts (2) 3/8”- 16 Hex nuts 1/4”- 20 Flanged hex nuts (as required) (2) 1/4” - 20 Hex nuts (lift handles) (2) 3/8”-16 x 3/4” Truss head bolts 5/16”-18 Flange hex nuts (as required) 1/4”-20 x 9/16” Tr ...
-
Wayne-Dalton 8700 - page 5
for tracks, springs, etc. to allow the door to open properly . If the door is to be motor operated, 2-1/2” (64 mm) of additional headroom is required. Backroom requirement: Backroom is defined as the distance needed from the opening back into the garage to allow the door to open fully . BACKROOM REQUIREMENTS DOOR HEIGHT TRACK MANUAL LIFT MOTOR O ...
-
Wayne-Dalton 8700 - page 6
INST ALLA TION Before installing your door , be certain that you have read and followed all of the instruc- tions covered in the pre-installation section of this manual. Failure to do so may result in an improperly installed door . NOTE: Reference TDS 160 for general garage door terminology at www.dasma.com . Fully Adjustable Flag Angles T ools: No ...
-
Wayne-Dalton 8700 - page 7
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Graduated Hinge Attachment T ools: Power drill,7/16” Socket driver 5 NOTE: Refer to door section ...
-
Wayne-Dalton 8700 - page 8
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Now insert the outside step plate into the holes through the front of the door , mounting the two s ...
-
Wayne-Dalton 8700 - page 9
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com NOTE: Larger doors will use long stem track rollers with double graduated end hinges. With assistan ...
-
Wayne-Dalton 8700 - page 10
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com T o install horizontal track, place the top rail end over the top track roller of the top section. ...
-
Wayne-Dalton 8700 - page 11
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Center bracket Vertical line Mounting surface Horizontal line Center of end bearing bracket Equal d ...
-
Wayne-Dalton 8700 - page 12
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com IMPORT ANT : VERIFY THA T THERE ARE NO COUNTERBALANCE LIFT CABLE OBSTRUCTIONS. Hook the counterbala ...
-
Wayne-Dalton 8700 - page 13
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com HIGH SPRING TENSION CAN CAUSE SERIOUS INJURY OR DEATH. DO NOT adjust, repair or remove springs or p ...
-
Wayne-Dalton 8700 - page 14
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Sound framing members Perforated angle Horizontal track (3) 5/16” Bolts and nuts Perforated angle ...
-
Wayne-Dalton 8700 - page 15
Inside Lock T ools: Power drill, 7/16” Socket driver , T ape measure Install the inside lock on the second section of the door . Secure the lock to the section with (4) 1/4”-20 x 11/16” self drilling screws. Square the lock assembly with the door section, and align with the square hole in the vertical track. The inside lock should be spaced a ...
-
Wayne-Dalton 8700 - page 16
Cleaning Y our Garage Door Like any other exterior surface, Wayne-Dalton garage doors will have dirt exposure from atmo- spheric conditions. Ordinarily , the cleaning action of rainfall will be adequate to wash the door , or the door can be washed periodically by hosing with a garden hose and clear water (in particular) for the areas not accessible ...
-
Wayne-Dalton 8700 - page 17
Limited Warranty Model 8700 Subject to the terms and conditions contained in this Limited Warranty , Wayne-Dalton (“Manufacturer”) warrants the sections of the door , which is described at the top of this page, for a period of TEN (10) YEARS from the date of installation against: i) P eeling, flaking, chipping or cracking due to defects in mat ...
-
Wayne-Dalton 8700 - page 18
AFTER INST ALLA TION IS COMPLETE, F ASTEN THIS MANUAL NEAR THE GARAGE DOOR. Please Do Not Return This Product T o The Store Thank you for your pur chase. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pa ges business listings or go to the Find a Dealer section online at www .Wayne-Dalt ...
Do you have a question concerning Wayne-Dalton 8700?
Use the form below
If you did not solve your problem by using a manual Wayne-Dalton 8700, ask a question using the form below. If a user had a similar problem with Wayne-Dalton 8700 it is likely that he will want to share the way to solve it.