Manual Directed Electronics RSS-2514XR

20 pages 0.19 mb
Download

Go to site of 20

Summary
  • Directed Electronics RSS-2514XR - page 1

    500-10050(07-08) PATENT NOS CAN 1.130.426 USA 4.345.554 - 5.614.883 - 5.617.819 - 5.673.017 AND OTHER PATENTS PENDING A ll r ights reserv ed © Dir ected E lec tronic s Cana da inc. 2008 USER MANUAL Model RSS-2514XR For all gas- and diesel-powered vehicles This model may be equipped with an optional security system.. (FRANÇAIS AU VERSO) C ONSUL T ...

  • Directed Electronics RSS-2514XR - page 2

    GOVERNMENT REGULATIONS This device complies with the requirements of Indus try Canada (IC) - Management of Radiof requencies, as specified in document CNR-210. Its use is authorized only on a no-interf erence, no-protection basis; in other words, this device must not be used if it is det er mined that it causes harmful interference to services auth ...

  • Directed Electronics RSS-2514XR - page 3

    1 THANK YOU FOR CHOOSING AN ASTROSTART REMOTE CAR STARTER! Just like you are, Directed Electronics C anada is concerned with the environment. This is why we are suggesting you to use the two-minute runtime when you remote-start your vehicle to warm up engine fluids. You can set the runtime yourself using your transmitter. We take this opportunity t ...

  • Directed Electronics RSS-2514XR - page 4

    2 SAFETY PRECAUTIONS Before using this product, carefully read the following safet y precaut ions. GENERAL RULES • Never perform a remote start when a person or animal is inside the vehicle. • Do not allow any person or animal to remain inside the vehi cle when the engine is runni ng under remote starter control (continuous mode). • Immediate ...

  • Directed Electronics RSS-2514XR - page 5

    3 SAFETY SEQUENCE FOR MANUAL TRANSMISSION VEHICLES Your remote starter was designed to force y ou to perform a series of actions that will ensure that the gearshift lever is in neutral position when you exit the vehicle. This series of actions is called a "safety sequence" and is aimed at preventing any remot e star t in situations where ...

  • Directed Electronics RSS-2514XR - page 6

    4 THE REMOTE CONTROL Your remote control can transmit on two different channels, allo wing control of two separate vehicles. Up to four remote controls can be assigned to your vehicle. NOTE : The range of your remote control can be affected by a weak battery, interf erence from nearby metal structures, hydro poles, or crowded parking lots. Only the ...

  • Directed Electronics RSS-2514XR - page 7

    5 T ABLE OF COMMANDS C OMMAND B UTTONS C ONFIRMATIONS H ORN P ARKING LIGHTS S IREN * G ROUPE 1 G ROUPE 2 P ANIC OR (> 4 SEC .) AND (> 4 SEC .) 30 / 60 SEC . S TART / C ONTINUOUS M ODE 1  1  - S TOP  (> 4 SEC .) 1  1 - L OCK / A RMING * (R EDUCED RANGE IF < 2 SEC .) 1  1 / 3  1 / 3 / X  U NLOCK / D ISARMING ...

  • Directed Electronics RSS-2514XR - page 8

    6 START COMMANDS STARTING THE ENGINE Refer to the table of command on page 5 to know which but t on to press. The system automatically adjusts ignition durat ion for your type of vehicle; parking lights flash once (durat ion: four seconds) then stay on all the time engine is running. If more than one command is emitted, each successive st art co mm ...

  • Directed Electronics RSS-2514XR - page 9

    7 CONTINUOUS MODE Continuous Mode function lets you remove the key f rom t he ignition while leaving the engine running. This convenient feature allows you to leave your vehicle for s hort periods while climate controls remain on. A UTOMATIC TRANSMISSION VEHICLES To access Continuous Mode, press on the button while engine is idling (see S TARTING T ...

  • Directed Electronics RSS-2514XR - page 10

    8 LOW TEMPERATURE MODE Press the and buttons simultaneously for 2 seconds. The command alternatively activates/ deacti vate Low Temperature mode. In Low Temperature (Sentinel) mode, system starts your engine aut omatically when temperat ure falls below a preset level. Engine will run for programmed r untime, after which system will wait 2½ hour s ...

  • Directed Electronics RSS-2514XR - page 11

    9 SECURITY SYSTEM (OPTIONAL) The current section only applies to an Astr oStart security system (added as an option) which must not be confused with the vehicle’s OEM system. PROTECTION ZONES Your security system can use up to six dif f erent monito ring devices simultaneously to protect your vehicle. These devices are connected to the system on ...

  • Directed Electronics RSS-2514XR - page 12

    10 OPERATION Your alarm system has three diff erent operating modes, active , semi-passive rearming and passive rearming depending on initial programming. See the relevant par agraph for the mode your system was configured in during installat ion. ACTIVE In active mode, the alarm must be armed and di sarmed using the remote. See Table of Commands o ...

  • Directed Electronics RSS-2514XR - page 13

    11 The following table shows the effect t hat each zone has on the rearming cycle (after 25 or 60 seconds depending on installation). Protection zone Effect on rearming cycle Hood Doors Additional sensor (trunk) Shock sensor These four zones prolong rearming cycle as long as they r emain in violation. Ignition Activated by ignition ke y: Cancels re ...

  • Directed Electronics RSS-2514XR - page 14

    12 The following table shows the meaning of zone codes (number of fl ashes). ZONE CODES FLASHES ZONE INDICATED 1 System is armed. 2 A door is/was open. 3 Hood is/was open. 4 Alarm condition is/was detec ted on shock sensor input. 5 Key is/was in the run position. 6 Alarm condition is/was detect ed on additional sensor input. Additional sensor monit ...

  • Directed Electronics RSS-2514XR - page 15

    13 GLOSSARY S IREN Siren has six different sounds, i.e., it chirps repeatedly and has six di fferent melodies (supplied only with optional alarm ki t). It chirps intermittently (short r epeated chirps) during a pre- alarm and cont inuously dur ing an alarm condition. It can confirm arm and disarm commands with short chirps; see table in CONFIRMATI ...

  • Directed Electronics RSS-2514XR - page 16

    14 UNLOCK / DISARM Refer to the table of command on page 5 to know which but t on to press Doors are unlocked and alarm is disarmed, parking lights flash and siren chirps twice to conf irm command has been received and that no alarm condition was generated during your absence. If there was a violation, confirma t ion is different (4 flashes or chir ...

  • Directed Electronics RSS-2514XR - page 17

    15 OTHER COMMANDS ANTITHEFT (CIRCUIT DISABLER) Programmable as Active or Inactive during installation. Your Remote Starter is equipped with an Antitheft system. This system consists of an output that controls a r elay that cuts all circuits required to operate your vehicle ( optional connection). “P ASSIVE A RMING » TYPE A NTITHEFT This type of ...

  • Directed Electronics RSS-2514XR - page 18

    16 CAR FINDER Refer to the table of command on page 5 to know which but t on to press. This function sounds horn (short tune) and f l ashes par king lights to help you locate your v ehicle in a large parking lot. REMOTE SILENT MODE The remote can be programmed to be used in silent mode. Refer to the table of command on page 5 to know which but t on ...

  • Directed Electronics RSS-2514XR - page 19

    17 ALARM CONDITION CODES Use this command to identify which zone is in viol ation during arming or whic h generated alarm conditi on. Refer to the table of command on page 5 to know which but t on to press. Parking lights will flash number of times corres ponding to code for protecti on zone in violation. If more than one zone is in violation, code ...

  • Directed Electronics RSS-2514XR - page 20

    18 GEARSHIFT CHECK APPLICABLE TO AUTOMATIC TRANSMISSION VEHICLES If key must be in ignition for gearshift t o be moved out of P , your vehicle is safe as long as keys are kept away from children. If, on the other hand, gearshift c an be put in gear without key being in ignition, proceed wi th this simple check. • Make sure that the parking brake ...

Manufacturer Directed Electronics Category Remote Starter

Documents that we receive from a manufacturer of a Directed Electronics RSS-2514XR can be divided into several groups. They are, among others:
- Directed Electronics technical drawings
- RSS-2514XR manuals
- Directed Electronics product data sheets
- information booklets
- or energy labels Directed Electronics RSS-2514XR
All of them are important, but the most important information from the point of view of use of the device are in the user manual Directed Electronics RSS-2514XR.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Directed Electronics RSS-2514XR, service manual, brief instructions and user manuals Directed Electronics RSS-2514XR. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Directed Electronics RSS-2514XR.

A complete manual for the device Directed Electronics RSS-2514XR, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Directed Electronics RSS-2514XR by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Directed Electronics RSS-2514XR.

A complete Directed Electronics manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Directed Electronics RSS-2514XR - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Directed Electronics RSS-2514XR, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Directed Electronics RSS-2514XR, that we can find in the current document
3. Tips how to use the basic functions of the device Directed Electronics RSS-2514XR - which should help us in our first steps of using Directed Electronics RSS-2514XR
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Directed Electronics RSS-2514XR
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Directed Electronics RSS-2514XR in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Directed Electronics RSS-2514XR?

Use the form below

If you did not solve your problem by using a manual Directed Electronics RSS-2514XR, ask a question using the form below. If a user had a similar problem with Directed Electronics RSS-2514XR it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)