-
Bushnell 119204 - page 1
Model# 1 19204 (Std) / 1 19305 (NV) / 1 19505 (Camo NV) LIT #: 98-1 164/03-08 Instruction Manual TRAIL SENTR Y™ Digital T rail Camera Standard Sentry Night V ision Sentry 119204+119305 Trail Sentry 1LIM-1 1 3/3/08 11:51:13 PM ...
-
Bushnell 119204 - page 2
2 Congrat ulations on your purc hase of the Bushn ell ® Digital T rail Sentr y ™ C amera! is weatherproof , rugged trail camera is designed to record still images or movie clips of ou tdoor wild life activity . i s ins tr uction manual will hel p y ou understand, setup , and use yo ur Sentr y to achieve the best possible resul ts. Bushne l ...
-
Bushnell 119204 - page 3
3 QUICK GUIDE: BUSHNELL TRAIL SENTR Y (Standard and Night V ision Models) 1. Open the camera by releasing the latches on the right side of the camera. Install 4 “D” cell batteries (at base of all batteries contacting springs), and insert an SD card (not included, use any capacity up to 1GB) in the slot to the right of the 5 buttons (upside d ...
-
Bushnell 119204 - page 4
4 QUICK GUIDE: BUSHNELL TRAIL SENTR Y (Standard and Night V ision Models) 6. ( Night Vision models only ) After selecting still photo or movie clip mode, press ENTER. The “Sun” icon will blink (f). Press ENTER again and use the UP or DOWN buttons to set the hour-this is the time the camera will consider to be the start of the “Day”. During ...
-
Bushnell 119204 - page 5
5 Digital T rail S entry Spe cic ations Imag e S ensor 2.1 MP (Standar d model) or 3.1 MP (Nigh t Visio n models) CMOS sensor Lens F/3.5, eective focal length 42mm. Sight ran ge: 45 degrees Flash High power electro nic Xenon Flash or IR LED s (Night V ision models o nly , array o f 20). Range: 45 . PIR Sensor Low noise, high sensitivi ty p ...
-
Bushnell 119204 - page 6
6 Glossary PIR — Passive Infrared S ensor . S enses motion like typical s ecurity m otion detector . Requires inf rared energy (h eat) in addition to mo tion to trip sensor to assure det ec tion of liv e animals. Event— An y time tha t the PIR senses motion it counts it as an even t. E vents are recorded to the S D c ard in a t ext le. Even ...
-
Bushnell 119204 - page 7
7 P arts Guide Front of Camera Control Panel Inside Front Button & Display Detail SD Card Slo t LCD Display Setup , Men u & Po wer Butto ns PIR PIR Detected (or Low Battery) LED Lock T ab Camera Lens Standar dFlash LED IR Flash (NV Models only) 119204+119305 Trail Sentry 1LIM-7 7 3/3/08 11:51:14 PM ...
-
Bushnell 119204 - page 8
8 Setup and Operation Guide 1. Open the Sentry by pulling out on the two latches on the right side. Install 4 “D” cell batteries (at base of all batteries contacting springs), and insert an SD card (not included, use any capacity from 16MB to 1GB. Do not substitute MMC cards.) in the slot to the right of the 5 buttons as indicated on the slo ...
-
Bushnell 119204 - page 9
9 Setup G uide (co nt.) last two digits blinking (“20_ _”) ( d ). Again use the Up/Down buttons to change the year if necessary , press enter, and set the time (“TIME” will ash, press enter and use Up/Down to set the hour and minute. The time display uses the 24 hr standard, so 2:00 PM is indicated as “1400”, etc). 4. After the date ...
-
Bushnell 119204 - page 10
10 After setting the start hour for “Day”, press ENTER and the “Star&Moon” icon will blink. Press ENTER and set the hour to dene the start of “Night”. During the Night, photos and videos will be taken using the infrared LED lamp array to light the scene. This allows you to take night photos without startling animals or revealing ...
-
Bushnell 119204 - page 11
11 9 . Thread the strap through the slots on the back of the Sentry and attach the buckles, then strap it onto a suitable tree, making sure the strap is tight and the camera is aimed at the area you wish to observe. The red LED lamp on the front of the camera can help you determine how lar ge an area is covered, as it will ash when an “event? ...
-
Bushnell 119204 - page 12
12 ABOUT THE PIR SENSOR e sensor that t riggers the trail camera is Passive Infra Re d, or PIR . Infrared energ y is essentially heat energy . e PIR detector o perates by sensin g a change in the infrar ed level in its detection zon e. is zone is a co ne in the center 10 degrees of the camera ’ s eld of vie w . e camera establishes ...
-
Bushnell 119204 - page 13
13 OPTI ON AL ACCESSORIES FO R THE BUSHNELL TRAIL S ENTR Y Ratcheting Bracket ( Bushnell Model # 1 1-9650C ) An optional ratcheting bracket is available for all new Trail Sentry models included in this manual, providing an alternative mounting method. This bracket can be screwed to a tree, or secured to a tree with the provided cable. When mounting ...
-
Bushnell 119204 - page 14
Solar Pa nel (insert plug int o camera inpu t jack) Solar Pa nel P ower I npu t Jack Solar Panel ( Bushnell Model # 1 1-9750C ) ( Compatible only with T rail Sentry Night V ision models and most T rail Scouts ) W ARNING : DO NOT USE the solar panel unless rechargeable ( “D” size type NiMh ) batteries have been installed. Using the solar panel w ...
-
Bushnell 119204 - page 15
FCC Note: is equipment has be en tested and found to comply with the limits for a Class B digital device, p ursuant to Part 15 of the FCC Rules. ese limits are designed to provide r easonable protection agains t harmful interferen ce in a residential installation. is equi pment generates, uses and can radiate radio f requency energ y and, ...
-
Bushnell 119204 - page 16
©2008 Bushnell Outdoor Products Fo r fu rt h er qu e st io n s o r a d di ti o na l i n fo rm a ti on pl e as e c o nt ac t : Bushnell Outdoor Products 9200 Cody , Overland Park, Kansas 66214 ( 80 0) 42 3 -3 53 7 • w ww . bu sh ne l l. co m 119204+119305 Trail Sentry 1LIM-16 16 3/3/08 11:51:17 PM ...
Do you have a question concerning Bushnell 119204?
Use the form below
If you did not solve your problem by using a manual Bushnell 119204, ask a question using the form below. If a user had a similar problem with Bushnell 119204 it is likely that he will want to share the way to solve it.