-
Cannon 10296G - page 1
Instruc tion Book This appliance must be installed in accordanc e with the regulations in force and only used in a w ell ventilat ed space. Read these instructions before installing or using the appliance and retain them for future use . The data badge is located belo w the oven door on the plinth pan el. Part no . 4866200052-04 W indsor Mk2 ...
-
Cannon 10296G - page 2
PA G E Introduction 3 For Y our Safety 4 Oven Timer Operation 6 Hotplate 12 Grill 14 Ov en 15 Oven Cooking Char t 17 The “E” Setting 19 Care and Cleaning 20 Something Wrong with y our cooker? 24 Installation Instructions 26 K e y C o n ta ct s Back Cov er 2 C ONTENTS ...
-
Cannon 10296G - page 3
T o help you make the best use of your c ooker , PLEASE READ THIS BOOKLET CAREFULL Y . Y our new cooker is guaranteed and will give lasting service. The guarantee is only applicable if the cooker has been installed in accordance with the Installation Instructions. The cooker is designed specifically for domestic use and responsibility will not be a ...
-
Cannon 10296G - page 4
Please read the precautions below befor e using your cook er . AL W A YS . . . AL W A YS make sure you understand the controls bef ore using the co oker . AL W A YS check that all controls on the c ooker are turned off after use. AL W A YS stand back when opening an oven door t o allow heat to dis perse. AL W A YS use dry , good qualit y oven glov ...
-
Cannon 10296G - page 5
NEVER . . . NEVER leave childr en unsuper vised where the cooker is installed as all sur faces will get hot during and after use. NEVER allow any one to sit or stand on any part of the cooker . NEVER store items that childr en may attempt to r each above the c ooker . NEVER heat up unopened food con tainers as pressure can build up causing the cont ...
-
Cannon 10296G - page 6
6 O VEN TIMER OPER A TION The ov en timer offers you the f ollowing featur es: 1. Time of Day 2. Automatic C ook ing 3. Minute Minder GUIDANCE ON A UTOMA TIC C OOKING 1. Select foods which will take the same time to cook. 2. Set the oven timer so that the f ood has just finished or is just about to finish cooking on your return to the oven. T his w ...
-
Cannon 10296G - page 7
7 KNOW Y OUR TIMER CL OCKF A CE The timer incorporates a 24 hour clock. Ensure the correct time of day is alw ays set , b efore using you cooker . PLEASE NO TE THA T THE DISPL A Y WILL DIM BETWEEN 22.00 HOURS AND 06.00 HOURS TO PREVENT GL ARE . Howe ver , should you oper ate the timer during these hours the display will return to normal brightness ...
-
Cannon 10296G - page 8
8 O VEN TIMER OPER A TION SETTING THE TIME OF DA Y Step 1 Make sure all oven controls ar e turned Off. Step 2 Check the electricity supply to the cooker is turned on. Step 3 When switched on the display will show 0.00 and A uto symbol will be flashing intermittently . Step 4 Press & hold in both the “Minute Minder” & “Cook Period” b ...
-
Cannon 10296G - page 9
9 O VEN TIMER OPER A TION Step 3 Press and hold in the C ook Period button. The display will read 0.00 with the cookpot ( ) symbol lit . Step 4 With the Cook P eriod button still held in, set the required Coo k Period using the “+” and “–” buttons . Release the buttons and the timer display will rev ert to the time of day with the Auto sy ...
-
Cannon 10296G - page 10
10 O VEN TIMER OPER A TION Step 4 Press & hold in the “C ook Period” button, the display will read 0.00 and the cookpot ( ) symbol will light up. With the Cook P eriod button still held set the required Cook P eriod using the “+” and “–” buttons. Example: 1hr 30 minutes (as shown). Note: Cook P eriod is the length of time the food ...
-
Cannon 10296G - page 11
O THER NOTES ON TIMER OPERA TION 1. When cooking Automatically the Cook P eriod can be checked at an y time simply by pressing the Cook Period button. 2. When cooking Automatically the End Time can be checked at any t ime by simply pr essing the End Time button. 3. Having set a Cook P eriod and End Time an elec tronic device stor es the information ...
-
Cannon 10296G - page 12
12 HO TPLA TE The hotplate lid is fitted with a saf et y device which cuts off the gas supply to the hotplate burners unless the lid is fully open. Do not use the s afety device as a means of controlling the hotplat e burners. All spillages must be remov ed from the sur face of the lid befor e opening . The hotplate has two high speed burners and t ...
-
Cannon 10296G - page 13
13 HO TPLA TE SAFET Y REQUIREMENTS FOR DEEP F A T FRYING 1. Nev er fill chip pans more than one third full with oil or fat . 2. Nev er leave oil or fat unattended during the heating or cooli ng period . 3. Nev er heat fat or fr y with a lid on the pan. 4. A lways dry food thoroughly befor e fr ying, and lo wer it slowly into the hot oil or fat. F r ...
-
Cannon 10296G - page 14
T O USE THE GRILL 1. Check that the electricity supply is switched on. 2. Open the grill door and remove the grill pan. 3. Press the ignition butt on and then push in and turn the control knob anti- clockwise to the large flame symbol. Continue to pr ess the igni tion button until the sparks light the gas. 4. Slide the grill pan along either of the ...
-
Cannon 10296G - page 15
The ov en has different heat z ones – the thermostat settings ref er to the t emperature on the middle shelf position; above this shelf it is hott er and below it is cooler . T wo shelves pro vide five possible cooking levels enabling full use of the different t emperatures inside the ov en. Each shelf has a safety stop to prev ent if from being ...
-
Cannon 10296G - page 16
C OLD ST ART C OOKING Anything requiring long slow c ooking such as casseroles and ric h fruit cakes can be put into a cold ov en. S atisfactor y results can also be obtained with creamed mixture, rich pastries or yeast mixtures, but for perfection we recommend preheating the o ven for about 15 minutes at the gas mark y ou require for c ooking. RO ...
-
Cannon 10296G - page 17
The following times and setting ar e for guidance only . Y ou may wish to alter the setting t o give a result more to your sa tisfaction. When a different setting to t hat shown belo w is given in a recipe , the recipe instructions should be followed . Allow 15 minutes preheat for best results. Alw ays turn the thermostat knob to Mark 9 before sele ...
-
Cannon 10296G - page 18
18 O VEN C OOKING CHART Gas Shelf Food Mark Positions Approx. C ooking Time and Comments CAKES, P ASTRIES AND BISCUITS Small cakes - 2 trays 5 2 & 4 17 - 25 mins - 1 tray 5 2 or 3 only " Victoria sandwich 2x8" (205mm) 4 2 & 4 25 - 35 mins 5 2 20 - 25 mins. 2 tins side by side Christmas cake 2 3 or 4 4 - 6 1 / 2 hrs depending on re ...
-
Cannon 10296G - page 19
The ‘E’ setting on the ov en thermostat is used for slow cooking , keeping f ood warm and warming plates for short periods. USING THE ‘E’ SETTING FOR SLOW C OOKING 1. All dishes cooked by the ‘E’ setting should be cooked for a minimum 6 hours. They will ‘hold’ at this setting for a further hour but marked deterioration in appearance ...
-
Cannon 10296G - page 20
Switch off the electricity supply and allow to c ool before cleaning the cooke r . Clean the cooker r egularly and wipe up spills so on after they occur to prev ent them from becoming burnt on. Nev er use biologic al washi ng powder , caustic cleaners, harsh abrasiv es, scouring pads, aeros ol cleaners or o ven chemical cleaners of any kind . Befor ...
-
Cannon 10296G - page 21
21 CARE AND CLEANING C OOKER FINISH CLEANING METHOD Vitreous Enamel Hotplate , hotplate front trim, burner caps, roasting dish, grill pan, main oven base , inside of grill compartment, inside of doors. Cloth wrung out in warm soapy water . Stubborn stains can be remov ed with a cream paste , liquid cleaner or by rubbing with fine steel wool soap pa ...
-
Cannon 10296G - page 22
22 CARE AND CLEANING Cannon Pearl Duo HOTPLA TE HOTPLA TE FRONT TRIM F ASCIA BO T TOM TRIM SIDE TRIM LID REAR TRIM FL UE GRILLE HOTPLA TE SIDE TRIM F ASCIA END CAP ...
-
Cannon 10296G - page 23
23 CARE AND CLEANING Take particular care not to damage the inner sur face of the door inner glass that is coated with a hea t reflec tive la yer . Do not use scouring pad s, or abrasiv e powder , which will scratch the glass . Ensure that the glass panel is not subjected to any sharp mechanical blo ws. Stubborn stains can be remov ed by using a fi ...
-
Cannon 10296G - page 24
24 SOMETHING WRONG WITH Y OUR C OOKER PROBLEM Before contacting your Service C entre or Installer , check the problem guide below , there ma y be nothing wrong with your c ooker . CHECK Ignition does not work. Burner por ts Ignitor Burner por ts Ignitor Burner por ts Ignitor Oven burner Grill burner Hotplate burner . I f all burners fail t o ignit ...
-
Cannon 10296G - page 25
DISPOSAL OF Y OUR PRODUCT : T o minimise the risk to injury to children please dispose of your product carefully and safely . Remove all doors and lids (where fitt ed). Remove the mains cable (where fitted) by cutting off flush with the appliance and always ensur e that no plug is left in a condition where it could be connected to the electricity s ...
-
Cannon 10296G - page 26
Prior to installation, ensur e that the local distribution conditions (nature of the gas and gas pressure) and the adjustment conditions ar e compatible. The adjustmen t conditions for this appliance ar e stated on the data badge which is fitted behind the bottom of the main ov en door seal. This appliance is not designed to be connected to a c omb ...
-
Cannon 10296G - page 27
TECHNICAL DA T A DIMENSIONS Height 900 - 915mm Width 600mm Depth 595mm (excluding door handles) GENERAL Gas connection Rp 1 / 2 ( 1 / 2 ” BSP female) Gas Supply Natural gas models – G20 at 20 mbar Pressur e test point Grill injector Gas rate adjustment None Aeration adjustmen t None Electrical connection Flexible c ord fitted with a 3 pin 13 am ...
-
Cannon 10296G - page 28
SP ACE FOR FIXING The cooker can be close fitted below hotplat e level. This requires a minimum distance of 600mm between cupboard units of hotplat e height. When installing next to a tall cupboard , par tition or wall, for a minimum distance of 400mm above hotplat e level, allow a side clearanc e of at least 65mm. The diagram below illustr ates th ...
-
Cannon 10296G - page 29
29 INST ALLA TION INSTRUCTIONS 125mm ST ABILIT Y BRACKET POSITION SLO T FOR ST ABILITY BR ACKET REAR OF COOKER UNP ACKING THE C OOKER Unpack the components from inside the grill and ov en: Check that the following parts are present. Grill pan and grid Baking dish P an suppor ts (4) Main oven shelves (2) Enamelled burner caps (4) Literature Aluminiu ...
-
Cannon 10296G - page 30
C ONNECTING TO GAS SUPPL Y The cooker is designed to match the depth of standar d 600mm wor ktops. An adaptor backplate should, theref ore, be fitted within the shaded area shown t o allow the cooker to be pushed fully to the wall. Connection to the cooker should be made with an approv ed appliance flexible connection to BS 669. A length of 0.9 to ...
-
Cannon 10296G - page 31
Connection to the electricity supply should be made via a properly ear thed, readily accessible wall socket which is adjacent to but not directly above , and not more than 1.25m away from the appliance and capable of electrical isolation. The mains lead should be routed such that it cannot t ouch hot par ts of the cooker i.e. the back panel above a ...
-
Cannon 10296G - page 32
INST ALLA TION AND OPER A TIONAL CHECKS After installation, check for gas soundness . The supply pressur e can be checked at the grill injector . Access to the injector is by first removing the baffle a t the front of the grill fastened by two screws . Then remove the fastening screw on the right hand side of the burner and slide the burner off the ...
-
Cannon 10296G - page 33
Our policy is one of continual improvement in design and dev elo pment, therefore strict accuracy of illustrations and descriptions can not be guaranteed . This appliance conf orms to the following EEC Dir ectives: Gas Appliances 90/396/EEC Low V oltage Equipment 72/23/EEC 93/68/EEC Electromagnetic Compatibility 89/336/EEC 92/31/EEC 93/68/EEC ...
-
Cannon 10296G - page 34
...
-
Cannon 10296G - page 35
...
-
Cannon 10296G - page 36
K ey C ontac ts Ser vice W e have the largest appliance manufacturer’ s ser vice team in Eu rope , trained specialists directly employed by us to ensur e your complete con fidence. Repair Ser vice UK: 08709 066 066 Republic of Ireland: 1850 302 200 Y ou will be asked for the following information:- Name, address and postc o de. T elephone number ...
Do you have a question concerning Cannon 10296G?
Use the form below
If you did not solve your problem by using a manual Cannon 10296G, ask a question using the form below. If a user had a similar problem with Cannon 10296G it is likely that he will want to share the way to solve it.