Manual McCulloch XTREME Aug-42

17 pages 0.37 mb
Download

Go to site of 17

Summary
  • McCulloch XTREME Aug-42 - page 1

    INSTRUCTION MANUAL IMP ORT AN T IN FO RM A TIO N: Pl ease read t hese inst ru cti ons caref ull y and make sur e you unde rst and th em befo re usi ng thi s uni t. Ret ain t hese instr uctions for f uture refer ence. MANUEL D’ INSTRUCTIO NS RENSEIGNEM ENTS IMPOR T AN TS: Avant d’ut il iser cet appareil , veuill ez li re at entivement les i nstr ...

  • McCulloch XTREME Aug-42 - page 2

    2 ID ENTI FIC A TIO N (WHA T IS WH A T?) Chain Adjus tment T oo l (Bar T ool) Bar O il Fill Cap Chain Front Hand G uard Starter R ope ON/S T OP Switch Muffler Chok e/ Fast I dle Lever Fuel Mix Fill C ap Start er Hous ing Idle Speed S crew Bumper s pike Primer Bu lb Front Handle Guide Bar Adjus ting Wheel Cy linder Cov er Thrott le Lock out Rear Han ...

  • McCulloch XTREME Aug-42 - page 3

    3 IDEN TIF ICA T ION OF SYM BOL S Mov e O N/ STOP s wi tc h to the ON pos ition. Slow ly press pr imer bulb 6 times. Pull the s tarter rope s harply 5 times with y our right hand. Pull th e sta rter r ope s harply with your right hand until the engi ne starts. Pull c hoke/fas t idle lev er out to the f ull extent (to the FU LL CHO KE pos i- tion). ...

  • McCulloch XTREME Aug-42 - page 4

    4 S Keep all parts of y our body away from the chain w hen the engine is running. S Keep childr en, by s tanders , and animals a minimum of 10 meters away from the wor k area. Do not allow other people or animals to be near the c hain s aw w hen star ting or operating the c hain s aw . S Do not handle or opera te a chain s aw when you ar e fatigued ...

  • McCulloch XTREME Aug-42 - page 5

    5 MAINTA IN YOUR S A W IN G OOD WOR KI NG OR DER S Hav e all c hain s aw s erv ice pe rformed by a qualified s erv ic e dealer w ith the ex c eption of the items lis ted in the maintenanc e sec tion of this manual . For example , if impr oper tools are used to remove or hold the flywheel when s erv ic ing the clutc h, s truc tur al damage to the fl ...

  • McCulloch XTREME Aug-42 - page 6

    6 S Do not attempt c uts star ting with the tip of the bar (plunge c uts ). S Watch for s hifting lo gs or other f orc es tha t cou ld clos e a c ut and pinc h or fall into c hain . S Us e t he R educed - - Kic kbac k G uide Bar and Low - - K ick bac k Chain spec ified for your s aw . MAINTAI N C ONTROL Never reverse hand positions Stan d to th e l ...

  • McCulloch XTREME Aug-42 - page 7

    7 ASSE M BL Y Protec tiv e gloves (not pr ovided) s hould be worn during as sembly. A TTA CHIN G THE BUMPE R SPIKE (If not already att ached) The bumper s pike may be us ed as a piv ot when making a c ut. 1. Loos en and r emove bar k nob completely by lift ing lever and turning count erc lock - wis e. Remov e clutc h c ov er . 2. A ttach the bumper ...

  • McCulloch XTREME Aug-42 - page 8

    8 CHAIN TENSION (Including unit s with chain a lready installed ) WAR N I N G : Wear protec tiv e gloves when handl ing chai n. The chai n is s harp and c an cut you ev en w hen it is not moving. NOTE: When adjus ting c hain tension, make s ure the bar knob is finger tight only. Attempting to tens ion the c hain when t he bar knob is t ight can c a ...

  • McCulloch XTREME Aug-42 - page 9

    9 OPER A TING YOUR U NIT BEFORE ST ARTING ENGINE WAR N I N G : Be s ure to read the fuel information in the safet y rules before y ou be- gin. If you do not understand the safety rules , do not attempt to f uel your unit. C ontact an authoriz ed ser vic e dealer . BAR AND CHAIN LUBRICA TION The bar and c hain require c ontinuous lubri- cat ion. Lub ...

  • McCulloch XTREME Aug-42 - page 10

    10 OFF HALF CHOKE /F AST IDLE LE VE R FULL 6. P ull the star ter rope s harply wit h your right hand until t he engine star ts. 7. A llow the engine to r un for approx imately 30 sec onds. Then, s queeze and releas e throttle tr igger to allow engine to return to idle s peed. STARTING A WARM ENGINE 1. Mov e ON /STOP s witc h to the ON posi- tion. 2 ...

  • McCulloch XTREME Aug-42 - page 11

    11 S Keep the engine at full s peed the entire time y ou are c utting. S Allow the c hain to cut for y ou. E xer t only light downwar d pres sure. S Releas e the throttle trigger as s oon as the cut is c ompleted, allowing the en- gine to idle. If you run the saw at full throttle w ithout a c utting load, unnec es- sar y w ear c an occ ur . S T o a ...

  • McCulloch XTREME Aug-42 - page 12

    12 Import ant p oints S Cut only one log at a time. S Cut s hattered w ood very c arefully ; shar p pieces of wood could be flung toward oper- ator . S Us e a saw hors e to c ut small logs . Nev er allow anot her per son to hold t he log w hile cutt ing and never hold the log w ith your leg or foot. S Do not c ut in an area where logs , limbs, and ...

  • McCulloch XTREME Aug-42 - page 13

    13 S Be alert f or s pringbac k . Watch out for branc hes that are bent or under press ur e. Avoid being struc k by the branch or the saw w hen the tens ion in the wood fibers is releas ed. S Keep a c lear wor k ar ea. F requently c lear branc hes out of the way to av oid tripping over t hem. LIMBING S Alway s limb a tree after it is c ut down. O n ...

  • McCulloch XTREME Aug-42 - page 14

    14 After each us e, ens ure ON /STOP s witc h is in the STOP pos ition, then clean all s awdus t from the guide bar and s proc ket hole. T o maintain guide bar: S Move O N/S TOP s witc h to the STOP po si - tion. S Loos en and remov e bar nuts an d c hain brak e. Remov e bar and c hain from s aw . S Clean the oil h oles an d bar groove af ter each ...

  • McCulloch XTREME Aug-42 - page 15

    15 STOR AGE WAR N I N G : Stop engine and allow to cool, and s ecure the unit before st oring or trans porting in a v ehic le. Store unit and fuel in an area wher e fuel v apors cannot r each spar ks or open flames from water heaters , elect ric motors or switc hes, furnac es , etc . Store unit w ith all guards in plac e. Pos ition so that any s ha ...

  • McCulloch XTREME Aug-42 - page 16

    16 DECLAR A T ION OF CONF ORM ITY EC D eclarati on of C onformi ty (O nly applies to Europe) We, H usqvarna O utdoor Products Ital ia, S .p.A. , V almadrera, Italy . T el: +39 - - 0341 - - 20321 1, dec lare that the c hain saw model McC ull och X-tr e m e 8 -4 2 SAS - - - AV from serial numbers 2007 - - 181(N or D ) 00001 and onwards ( the year is ...

  • McCulloch XTREME Aug-42 - page 17

    17 TECHNICAL DA TA S HEE T Engine X-tre me 8-4 2 Cy linder volume, c m 3 42 Stroke, m m 32 Idle speed, r pm 3,000 Rec ommended max. speed, unloaded, rpm 12,000 Power , kW 1,6 Ignition syst em Manufactur er IIDA T ype of ignit ion sy stem Induc tive Spark plug Champion Elec trode gap, mm 0,5 Fuel and lubri cation system Manufactur er Zama Carbur eto ...

Manufacturer McCulloch Category Chainsaw

Documents that we receive from a manufacturer of a McCulloch XTREME Aug-42 can be divided into several groups. They are, among others:
- McCulloch technical drawings
- XTREME Aug-42 manuals
- McCulloch product data sheets
- information booklets
- or energy labels McCulloch XTREME Aug-42
All of them are important, but the most important information from the point of view of use of the device are in the user manual McCulloch XTREME Aug-42.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals McCulloch XTREME Aug-42, service manual, brief instructions and user manuals McCulloch XTREME Aug-42. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product McCulloch XTREME Aug-42.

Similar manuals

A complete manual for the device McCulloch XTREME Aug-42, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use McCulloch XTREME Aug-42 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of McCulloch XTREME Aug-42.

A complete McCulloch manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual McCulloch XTREME Aug-42 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the McCulloch XTREME Aug-42, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the McCulloch XTREME Aug-42, that we can find in the current document
3. Tips how to use the basic functions of the device McCulloch XTREME Aug-42 - which should help us in our first steps of using McCulloch XTREME Aug-42
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with McCulloch XTREME Aug-42
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of McCulloch XTREME Aug-42 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning McCulloch XTREME Aug-42?

Use the form below

If you did not solve your problem by using a manual McCulloch XTREME Aug-42, ask a question using the form below. If a user had a similar problem with McCulloch XTREME Aug-42 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)