English dropdown-ico

Manual Scotsman Ice FME804

16 pages 0.67 mb
Download

Go to site of 16

Summary
  • Scotsman Ice FME804 - page 1

    Installation and User's Manual for Flake and Nugget Ice Machine Models FME504, FME804, NME454, NME654 ...

  • Scotsman Ice FME804 - page 2

    INTRODUCTION To the owner or user: This manual is intended to provide you with the information needed to install, start up, clean, and maintain this ice system. This is a modular ice system that fits a variety of Scotsman ice storage bins. NME454, 654 & FME504, 804 January 2007 Page 1 Table of Contents FOR THE INSTALLER ············ ...

  • Scotsman Ice FME804 - page 3

    FOR THE INSTALLER These machines fit the following Scotsman products, check sales literature for other possible combinations: · SB480 and extensions (with bin top KBT18) · HTB555 or BH550 using bin top KBT14 or KBT20 · BH801 using bin top KBT28 · BH900 using bin top KBT24 NME Dispenser Applications The NME models can be placed on and used with ...

  • Scotsman Ice FME804 - page 4

    NME454, 654 & FME504, 804 January 2007 Page 3 *Bin Top Kit Required SAMPLE BIN AND MACHINE COMBINATIONS FME804 ON BH550* NME654 ON BH801* FME804 ON BH900* The Nameplate is located on the back of the machine. A Serial Number Plate is located inside the cabinet, behind the front panel. ...

  • Scotsman Ice FME804 - page 5

    FOR THE INSTALLER Location: Install the machine be installed in a location where it has enough space around it to be accessible for service. A minimum of 6" must be allowed at the back and sides for air circulation on air cooled models. Try to avoid hot, dirty and crowded locations. Be sure that the location for the machine is within the envir ...

  • Scotsman Ice FME804 - page 6

    NME454, 654 & FME504, 804 January 2007 Page 5 FOR THE INSTALLER: Location TWO UNITS ON ONE BIN ALLOW ROOM FOR AIR CIRCULATION AND SERVICE ACCESS ALLOW AIR SPACE ON BOTH SIDES Airflow Notice: Air flow is in the sides and out the back. ...

  • Scotsman Ice FME804 - page 7

    FOR THE PLUMBER CONFORM TO ALL APPLICABLE CODES Water Inlet Air Cooled Models: Use 3 8 " O.D. copper tubing to connect cold potable water to the 3 8 " male flare fitting at the back of the cabinet. Install a hand valve near the machine to control the water supply. Water Treatment: In most areas, a water filter of some type will be useful. ...

  • Scotsman Ice FME804 - page 8

    FOR THE ELECTRICIAN CONFORM TO ALL APPLICABLE CODES Connect the electrical power to the machine to the wires in the junction box at the rear of the machine. Check the nameplate (located on the back panel) for the voltage requirements, and for the minimum circuit ampacity. The machine requires a solid chassis to earth ground wire. The ice machine sh ...

  • Scotsman Ice FME804 - page 9

    NME454, 654 & FME504, 804 January 2007 Page 8 INITIAL START UP Pre-Start Inspection 1. Remove the front and side service panels. 2. Check that any shipping blocks have been removed. 3. Inspect the interior of the machine for loose screws or wires. Check that no refrigerant lines are rubbing each other. Check that the fan blade turns freely (air ...

  • Scotsman Ice FME804 - page 10

    CLEANING & SANITIZING A Scotsman Ice System represents a sizable investment of time and money in any company ’s business. In order to receive the best return for that investment, it MUST receive periodic maintenance. It is the USER’S RESPONSIBILITY to see that the unit is properly maintained. It is always preferable, and less costly in the ...

  • Scotsman Ice FME804 - page 11

    1. The bin control is a device that senses light, therefore it must be kept clean so it can “see”. At least twice a year, remove the bin control sensors from the base of the ice chute, and wipe the inside clean, as illustrated . 2. The ice machine senses water level by a probe located in the water reservoir. At least twice a year, the probe sho ...

  • Scotsman Ice FME804 - page 12

    NME454, 654 & FME504, 804 January 2007 Page 11 Clean the air cooled condenser. The air flow on this model is from front to back, so the inside of the machine will have to be available to clean the air cooled condenser. Use a vacuum cleaner or coil cleaner if needed. Do NOT use a wire brush. A. Disconnect electrical power, and remove the filter. ...

  • Scotsman Ice FME804 - page 13

    The bearing in the breaker should also be checked at least two times per year . A. Check the bearing by: · removing the ice chute cover · unscrewing the ice sweep · removing the water shed & unscrewing the breaker cover (left hand threads). · unscrewing the auger stud Inspect the bearing. There should be plenty of grease in sight. If grease ...

  • Scotsman Ice FME804 - page 14

    AUGER MAINTENANCE In some areas, the water supply to the ice maker will contain a high concentration of minerals, and that will result in an evaporator and auger becoming coated with these minerals, requiring a more frequent removal than twice per year. If in doubt about the condition of the evaporator and auger, the auger can be removed so the par ...

  • Scotsman Ice FME804 - page 15

    BIN CONTROLS (Ice Level Sensors) 1. Disconnect electrical power. 2. Remove front panel. 3. Remove control box cover. 4. Locate ice chute, at the base of the chute, in front of and behind it are two plastic bin control mounts. 5. Slide each bin control to the left, and in the control box, disconnect the electrical leads connecting the bin control to ...

  • Scotsman Ice FME804 - page 16

    SCOTSMAN ICE SYSTEMS 775 Corporate Woods Parkway, Vernon Hills, IL 60061 800-533-6006 www.scotsman-ice.com 17-3154-01 ...

Manufacturer Scotsman Ice Category Ice Maker

Documents that we receive from a manufacturer of a Scotsman Ice FME804 can be divided into several groups. They are, among others:
- Scotsman Ice technical drawings
- FME804 manuals
- Scotsman Ice product data sheets
- information booklets
- or energy labels Scotsman Ice FME804
All of them are important, but the most important information from the point of view of use of the device are in the user manual Scotsman Ice FME804.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Scotsman Ice FME804, service manual, brief instructions and user manuals Scotsman Ice FME804. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Scotsman Ice FME804.

Similar manuals

A complete manual for the device Scotsman Ice FME804, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Scotsman Ice FME804 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Scotsman Ice FME804.

A complete Scotsman Ice manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Scotsman Ice FME804 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Scotsman Ice FME804, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Scotsman Ice FME804, that we can find in the current document
3. Tips how to use the basic functions of the device Scotsman Ice FME804 - which should help us in our first steps of using Scotsman Ice FME804
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Scotsman Ice FME804
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Scotsman Ice FME804 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Scotsman Ice FME804?

Use the form below

If you did not solve your problem by using a manual Scotsman Ice FME804, ask a question using the form below. If a user had a similar problem with Scotsman Ice FME804 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)